Engineering Papers⌕ Search

Engineering topics

Lee, E H

Publications and source records attributed to Lee, E H.

Phase evolution and magnetocaloric effect of melt-spun Mn{sub 3}Sn{sub 2-xM{sub x}} (M = B, C; x = 0-0.5) ribbons

The effects of B and C substitution for Sn on phase components, Curie temperature T{sub C}, and magnetocaloric effect of melt-spun Mn{sub 3}Sn{sub 2-x}M{sub x} (M B, C; x = 0-0.5) ribbons have been investigated. X-ray diffraction (XRD) results show that the main phase in the as-spun Mn{sub 3}Sn{sub 2-xM{sub x}} (M = B, C; x 0-0.5) ribbons is Mn{sub 3}Sn{sub 2} of Ni{sub 3}Sn{sub 2}-type (Pnma). Minor Mn{sub 2}B (when x {>=} 0.1) or Mn{sub 5}C{sub 2} (when x > 0.1) secondary phase is formed, and their amounts increase with increasing B and C concentration, respectively. The Curie temperature T{sub C} of these ribbons varies in the temperature range of 240-250 K. The peak values of the maximal magnetic entropy change, -{Delta}S{sub M}{sup max}, are about 13.6-18.3 mJ/cm{sup 3} K for B-substituted ribbons and 13.6-17.5 mJ/cm{sup 3} K for C-substituted ribbons, respectively, at a maximum applied field of 50 kOe. These values are about one fifth that of Gd (81.4 mJ/cm{sup 3} K). However, the relatively broader temperature range of the half maximum of {Delta}S{sub M} peak ({approx}100 K), low-cost and nontoxic elements still make Mn{sub 3}Sn{sub 2}-based ribbons the promising candidates for magnetic refrigeration applications close to room temperature.

36 MATERIALS SCIENCE↗

SUPER HARD SURFACED POLYMERS

High energy ion beam surface treatments were applied to a selected group of polymers. Of the six materials in the present study, four were thermoplastics (polycarbonate, polyethylene, polyethylene terephthalate, and polystyrene) and two were thermosets (epoxy and polyimide). The particular epoxy evaluated in this work is one of the resins used in formulating fiber reinforced composites for military helicopter blades. Measures of mechanical properties of the near surface regions were obtained by nanoindentation hardness and pin on disk wear. Attempts were also made to measure erosion resistance by particle impact. All materials were hardness tested. Pristine materials were very soft, having values in the range of approximately 0.1 to 0.5 GPa. Ion beam treatment increased hardness by up to 50 times compared to untreated materials. For reference, all materials were hardened to values higher than those typical of stainless steels. Wear tests were carried out on three of the materials, PET, PI and epoxy. On the ion beam treated epoxy no wear could be detected, whereas the untreated material showed significant wear.

36 MATERIALS SCIENCE↗