Engineering topics

Leach, Rodman N.

Publications and source records attributed to Leach, Rodman N..

5 records

NASA NTRS1991

Radar-aeolian roughness project

The objective is to establish an empirical relationship between measurements of radar, aeolian, and surface roughness on a variety of natural surfaces and to understand the underlying physical causes. This relationship will form the basis for developing a predictive equation to derive aeolian roughness from radar backscatter. Results are given from investigations carried out in 1989 on the principal elements of the project, with separate sections on field studies, radar data analysis, laboratory simulations, and development of theory for planetary applications.

Greeley, Ronald↗

NASA NTRS1991

Effect of pressure on electrostatic processes on Mars

Paschen's Law as illustrated by Paschen curves for various gases shows that the minimum breakdown voltage for gases for breakdown distances of interest, i.e., 1 to 1000 mm is at or near the surface pressure on Mars. This means that the physics of many electrostatic processes is markedly different on Mars than on Earth. The primary effect is that voltage potentials above 100 volts are subject to breakdown in the Martian atmosphere. Sharp electrodes, dusty atmospheric conditions, or other anomalies modify the breakdown voltage, usually causing lower breakdown voltages. Paschen's curves for most common pure gases were experimentally determined. A very small amount of mixing of different gases radically changes the curve as shown in the curve for neon plus 0.1 percent argon compared to either neon or argon. Paschen's curve for the exact composition of gases for Mars was not determined; thus, the breakdown voltages are not known. A second important effect is that the breakdown for most Martian cases is a glow discharge rather than a spark discharge. It would seem that simple measurements of breakdown manner and voltage should be included on a Mars lander vehicle.

Leach, Rodman N.↗

NASA NTRS1991

Saltation threshold detection in a wind tunnel by the measurement of the net electrostatic charge

The Mars surface wind tunnel (MARSWIT) is an open circuit wind tunnel used for aeolian studies and is located inside a large vacuum chamber allowing testing at Martian surface atmospheric pressure. Since direct access is not available to the tunnel during operation at low pressure, a remote method of saltation detection is needed. The bed is observed by means of closed circuit video, but it is often difficult to determine the initiation of threshold. The measurement by means of an electrometer of the net electric charge produced by the saltating particles has provided a reliable means of saltation threshold detection. Saltating particles become charged several ways, both in wind tunnels and in a natural environment. The most significant of these methods are tribo-charging and contact charging, which always occur. Fracture charging may also occur under the high velocities associated with particle transport on Mars or under simulated Martian conditions. Detection in MARSWIT is achieved by allowing the saltating particles to impinge on a planar conducting surface normal to the flow that is connected to ground through a Keithly electrometer. The signal from the electrometer is connected to a strip chart recorder along with the analog signal from the pitot tube transducer that is used to determine the wind velocity in the tunnel. Thus, a record of wind velocity and the initiation of particle saltation is conveniently displayed together. While both positive and negative charges are produced during saltation, this method measures only the net charge; thus the charge may be either positive or negative depending upon the particles being tested, the size and size distribution of the test material, and the wind velocity. This has proven to be a very trustworthy and sensitive method of saltation threshold detection, being especially useful with the smaller sized particles which are the most difficult to observe visually.

Leach, Rodman N.↗

NASA NTRS1991

Saltation threshold reduction due to the electrostatic agglomeration of fine particles

Particles between 80 and 110 microns in diameter are the most easily moved by the wind. As the particle size decreases below 60 microns, they are increasingly more difficult to move by surface winds, and a number of experiments were performed in an attempt to reduce the required wind velocity. These include: (1) the bombardment of a bed of fine particles by particles near the optimum size, the larger particles kicking the fine particles into the windstream where they are entrained; and (2) the electrostatic agglomeration of fine particles into sizes more easily saltated. The results of these experiments are discussed.

Leach, Rodman N.↗

NASA NTRS1991

Martian dust threshold measurements: Simulations under heated surface conditions

Diurnal changes in solar radiation on Mars set up a cycle of cooling and heating of the planetary boundary layer, this effect strongly influences the wind field. The stratification of the air layer is stable in early morning since the ground is cooler than the air above it. When the ground is heated and becomes warmer than the air its heat is transferred to the air above it. The heated parcels of air near the surface will, in effect, increase the near surface wind speed or increase the aeolian surface stress the wind has upon the surface when compared to an unheated or cooled surface. This means that for the same wind speed at a fixed height above the surface, ground-level shear stress will be greater for the heated surface than an unheated surface. Thus, it is possible to obtain saltation threshold conditions at lower mean wind speeds when the surface is heated. Even though the mean wind speed is less when the surface is heated, the surface shear stress required to initiate particle movement remains the same in both cases. To investigate this phenomenon, low-density surface dust aeolian threshold measurements have been made in the MARSWIT wind tunnel located at NASA Ames Research Center, Moffett Field, California. The first series of tests examined threshold values of the 100 micron sand material. At 13 mb surface pressure the unheated surface had a threshold friction speed of 2.93 m/s (and approximately corresponded to a velocity of 41.4 m/s at a height of 1 meter) while the heated surface equivalent bulk Richardson number of -0.02, yielded a threshold friction speed of 2.67 m/s (and approximately corresponded to a velocity of 38.0 m/s at a height of 1 meter). This change represents an 8.8 percent decrease in threshold conditions for the heated case. The values of velocities are well within the threshold range as observed by Arvidson et al., 1983. As the surface was heated the threshold decreased. At a value of bulk Richardson number equal to -0.02 the threshold friction speed and threshold wind speed appears to level-off to a constant value. This trend also was observed in the MARSWIT experiments involving the 11 micron sized-silt material.

White, Bruce R.↗