Engineering topics

Lawton, E. A.

Publications and source records attributed to Lawton, E. A..

5 records

NASA NTRS1986

Recent concepts in missions to Mars - Extraterrestrial processes

This paper presents some recent concepts in Mars Sample Return (MSR) missions that utilize extraterrestrial resources. The concepts examined include the power and energy needs of this mission. It is shown that solar energy is not especially attractive. Radioisotopic power generator and a Rankine cycle use are seen to be viable options. Quantitative estimates, taking into consideration state-of-the-art and projected technologies indicate that the power/energy per se is not critical to the mission - but reliability is. Hence, various modern options for the components of the power generation and utilization are discussed. The dramatic savings in Shuttle (or other) vehicle launches are quantitatively plotted. The basic system that is discussed here is the production of hydrocarbon (methane) fuel and oxygen from Martian atmosphere. For the simplest mission, it is seen that earth-carried methane burned with oxygen produced on site provides the best system.

Ramohalli, K. N.↗

NASA NTRS1986

Heat- and Radiation-Resistant Lubricants for Metals

Protective and lubricating coatings formed in situ. Orthophthalonitrile reacts with metal-surface asperities at high frictional temperatures to form lubricating films of metal phthalocyanine. Compounds also formed with hot metal fragments torn from asperities. Bearing surfaces better protected from scoring, and fragments rendered less harmful to base fluids. Lubricants useful as additives to oils and greases in gears, transmissions, motors, and other machines where rubbing loads between metal parts may be severe. Because of their low volatility and lack of requirement for air or moisture, lubricants also useful in vacuums.

Lawton, E. A.↗

NASA NTRS1986

Purifying Water by Imbibition

Concept for purifying water uses absorbent material to remove organic substances. Entire bulk of material employed, not just surface. Proposed purification process uses inexpensive equipment and low energy. Material is methyl acrylate polymer. Material cheap and regenerated by rinsing with methanol or by allowing absorbed compounds to evaporate from it.

Lawton, E. A.↗

NASA NTRS1985

Corrosion of metals by hydrazine

The mechanism of corrosion of metals by hydrazine has been studied by means of coupons in sealed ampoules and by electrochemical techniques. The variables considered were temperature, CO2 impurity level, alloy composition and microcrystalline structure. The coupon studies, to date, verify that increasng temperature and the presence of CO2 does increase the corrosion rate as expected. The presence of molybdenum in stainless steels to the 3 percent level is not necessarily deleterious, contrary to published reports. The influence of microcrystalline structure and surface characteristics are more dominant effects. However, with Ti-6Al-4V, two different microcrystalline structures showed no significant differences. Corrosion rates of CRES 304 L in hydrazine have also been measured by several electrochemical techniques such as Tafel plots, polarization resistance and A. C. Impedance. This is the first documented work to show that A. C. Impedance can be used with non-aqueous solvents. Preliminary data correlated satisfactorily with the results of the coupon studies.

Lawton, E. A.↗

NASA NTRS1983

Methylhydrazinium nitrate

Methylhydrazinium nitrate was synthesized by the reaction of dilute nitric acid with methylhydrazine in water and in methanol. The white needles formed are extremely hygroscopic and melt at 37.5-40.5 C. The IR spectrum differs from that reported elsewhere. The mass spectrum exhibited no parent peak at 109 m/z, and thermogravimetric analysis indicated that the compound decomposed slowly at 63-103 C to give ammonium and methylammonium nitrate. The density is near 1.55 g/cu cm.

Lawton, E. A.↗