Command of active and responsive elastomers by topological defects and patterns
The project resulted in the development of stimuli-responsive elastomer coatings formed by photopolymerized liquid crystal molecules. The molecular orientation of the liquid crystal elastomers is coupled to rubber-like elasticity. The project developed an approach to produce complex patterns of molecular orientation in elastomers by employing photopatterning technique based on plasmonic metamasks that convert unpolarized incoming light into a transmitted light beam with spatially-varying linear polarization. The polarization-modulated light beam aligns the film of azodye molecules, which serves as the substrate for liquid crystal elastomer coating. The alignment of the azodye molecules follows the polarization pattern with a phase shift of the alignment direction by 90 degrees. The azodye substrate imposes orientation of molecules in the adjacent liquid crystal layer which is preserved after the monomers are polymerized into a liquid crystal elastomer. By using differently aligned substrates one could produce various patterns of molecular orientation in the elastomer, which dictate the mechanical properties of the elastomers and their response to external stimuli such as temperature, humidity, and ultraviolet irradiation. In particular, the predesigned molecular orientation produces deterministically defined topography response of the liquid crystal coatings, in which their free surface changes from flat to either locally elevated or locally compressed, depending on whether the pre-inscribed molecular orientation is predesigned with a splay or bend deformation. The research established that the mechanism of this deterministic relation between the dynamic topography and pre-inscribed molecular orientation is rooted in the change of the tensorial order parameter that characterizes the degree of orientational order, and in the contraction/expansion of polymer molecules in response to the order parameter changes. In particular, lowering the order causes contraction of polymer globules. The work demonstrated that the dynamic topography of elastomer coatings with three-dimensional pattern of orientational order includes up and down motion of the material (along the normal to the coating) and also shifts in lateral directions. We demonstrate that the deterministic relationship between the orientational patterns and variations of coatings’ profile is caused by forces that are mathematically equivalent to active forces in the system of “pullers” or “pushers” in active matter, demonstrating universality of the out-of-equilibrium behavior. The project resulted in theoretical models that predictively describe the dynamic response of coatings. The topography of liquid crystal elastomers is sensitive to stimuli such as temperature, ultraviolet irradiation, and humidity. The applicability of the patterned approach to produce dynamic coatings was expanded from nematic elastomers to their smectic counterparts. The project combined a battery of imaging techniques to unveil the dynamic properties of the coatings, ranging from the state-of-the-art dynamic holographic microscopy to fluorescent confocal polarizing microscopy and polscope microscopy. The research uncovered potential applications of dynamic elastomer coatings, such as control placement of colloidal particles, engineering of living tissues with alignment patterns of cells that follow the orientational order of elastomer coatings. The approach developed in the project can be used to design programmable dynamic coatings with functionalities that mimic biological tissues such as skin.