Using X-mode L, R and O-mode reflectometry cutoffs to measure scrape-off-layer density profiles for upgraded ORNL reflectometer on NSTX-U
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Lau, Cornwall H.
Explore the source record for details and available documents.
Recent efforts by Vdovin [1] and Prater [2] have shown that helicon waves (fast waves at ~30 ion cyclotron frequency harmonic) may be an attractive option for driving efficient off-axis current drive during non-inductive tokamak operation for DIIID, ITER and DEMO. For DIIID scenarios, the ray tracing code GENRAY has been extensively used to study helicon current drive efficiency and location as a function many plasma parameters. has some limitations on absorption at high cyclotron harmonics, so the full wave code AORSA, which is applicable to arbitrary Larmor radius and can therefore resolve high ion cyclotron harmonics, has been recently used to validate the GENRAY model. It will be shown that the GENRAY and AORSA driven current drive profiles are comparable for the envisioned high temperature and density advanced scenarios for DIIID, where there is high single pass absorption due to electron Landau damping. AORSA results will be shown for various plasma parameters for DIIID and for ITER. Computational difficulties in achieving these AORSA results will also be discussed. * Work supported by USDOE Contract No. DE-AC05-00OR22725 [1] V. L. Vdovin, Plasma Physics Reports, V.39, No.2, 2013 [2] R. Prater et al, Nucl. Fusion, 52, 083024, 2014
A swept-frequency X-mode reflectometer is being built for Alcator C-Mod to measure the scrape-off layer density profiles at the top, middle, and bottom locations in front of both the new lower hybrid launcher and the new ion cyclotron range of frequencies antenna. The system is planned to operate between 100 and 146 GHz at sweep rates from 10 {mu}s to 1 ms, and will cover a density range of approximately 10{sup 16}-10{sup 20} m{sup -3} at B{sub 0}=5-5.4 T. To minimize the effects of density fluctuations, both differential phase and full phase reflectometry will be employed. Design, test data, and calibration results of this electronics system will be discussed. To reduce attenuation losses, tallguide (TE{sub 01}) will be used for most of the transmission line system. Simulations of high mode conversion in tallguide components, such as e-plane hyperbolic secant radius of curvature bends, tapers, and horn antennas will be shown. Experimental measurements of the total attenuation losses of these components in the lower hybrid waveguide run will also be presented.
A two-frequency x-mode reflectometer operating from 100 146 GHz is being deployed on Alcator C-Mod to measure the density profile and fluctuations in the scrape-off layer (SOL) immediately in-front of the new J-port ICRF antenna and the new B-port Lower Hybrid launcher. The reflectometer will cover densities from 1016 to 1020 m-3 at 5 5.4 T. To provide the greatest flexibility and capability to deal with density fluctuations approaching 100% peak to peak in the SOL, both full-phase and differential-phase measurement capabilities with sweep speeds of ~10 s to >1 ms are being implemented. The differential-phase measurement will use a difference-frequency of 500 MHz, corresponding to cutoff layer separations ranging from about 0.1 mm to 1 mm. The reflectometer will have 6 sets of launchers: 3 on the J-port ICRF antenna and 3 on the B-port LHRF launcher. The ICRF and LHRF antennas will incorporate reflectometer antennas at their top, bottom and mid-plane locations.