Engineering Papers⌕ Search

Engineering topics

Lathem, W. C.

Publications and source records attributed to Lathem, W. C..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Particle and field measurements on two J-series 30-centimeter thrusters

An experimental investigation under complete computer control of the characteristics of particles and fields emanating from mercury bombardment ion thrusters (J-series, 30 cm diameter), operating independently and simultaneously, is discussed. Results show that the flux rate of sputtered metal atoms leaving a single thruster has been determined and the data is in agreement with previous test results. The flux rate and energies of ions leaving single and two-thruster configurations have been established for a variety of beam current levels and combinations involving the two thrusters, and the data are sufficient to establish upper bounds. Floating potential measurements made in the near vicinity of the thrusters indicate that the fields are weak, plus or minus a few volts. The tests may be significant for the Solar Electric Propulsion System (SEPS) planners.

Lathem, W. C.↗
NASA NTRS1981

Particle and field measurements on two J-series 30 centimeter thrusters

Tests were performed to characterize the particles and fields associated with two 30 cm mercury ion thrusters operating independently and simultaneously. Flux rates and energies of ions and their distribution around the thrusters were determined. Facility effect ions were measured and their effect on thruster created flux measurements was assessed. The flux rate and distribution of sputtered metal atoms was determined and compared with theory and previous measurements. Mapping of the potential fields in the near vicinity of the thrusters was accomplished.

Lathem, W. C.↗
NASA NTRS1973

A 5000-hour test of a grid-translation beam-deflection system for a 5-cm diameter Kaufman thruster

A grid-translation type beam deflection system was tested on a 5-cm diameter mercury ion thruster for 5000 hours at a thrust level of about 0.36 mlb. During the first 2000 hours the beam was vectored 10 degrees in one direction. No erosion damage attributable to beam deflection was detected. Results indicate a possible lifetime of 15,000 to 20,000 hours. An optimized neutralizer position was used which eliminated the sputter erosion groove observed on the SERT 2 thrusters.

Lathem, W. C.↗
NASA NTRS1972

A single axis electrostatic beam deflection system for a 5-cm diameter ion thruster

A single-axis electrostatic beam deflection system has been tested on a 5-cm diameter mercury ion thruster at a thrust level of about 0.43 mlb (25 mA beam current at 1400 volts). The accelerator voltage was 500 volts. Beam deflection capability of plus or minus 10 deg was demonstrated. A life test of 1367 hours was run at the above conditions. Results of the test indicated that the system could possibly perform for upwards of 10,000 hours.

Lathem, W. C.↗
NASA NTRS1972

Optimization of electrostatic dual-grid beam-deflection system

Tests were performed to minimize accelerator grid erosion of a 5-cm diameter Kaufman ion thruster due to direct beam impingement. Several different screen hole diameters, pillow-shape-square screen holes, and dished screen grids were tried. The optimization was accomplished by copper plating the accelerator grid before testing each grid configuration on a thruster for a 2-hour run. The thruster beam sputtered copper and molybdenum from the accelerator grid where the beam impinged. The observed erosion patterns and measured accelerator currents were used to determine how to modify the accelerator system. The lowest erosion was obtained for a 50-percent open area pillow-shape-square-aperture screen grid, dished 0.043 centimeter convex toward the accelerator grid, which was positioned with the center of the screen grid 0.084 centimeter from the accelerator grid. During this investigation the accelerator current was reduced from 120 to 55 microamperes and was also more uniformly distributed over the area of the accelerator grid.

Hudson, W. R.↗
NASA NTRS1972

Grid-translation beam deflection systems for 5-cm and 30-cm diameter Kaufman thrusters

A 5-cm grid translation mechanism has been developed capable of 10 deg beam deflection. A 2026-hour endurance test was run at a preset 10 deg deflection angle and an extrapolated lifetime of better than 10,000 hours obtained. Response time data for grid translation are presented. Preliminary results for a 30-cm diameter system are given and results of a theoretical analysis of a dished grid system are discussed.

Lathem, W. C.↗
NASA NTRS1972

Grid-translation beam deflection systems for 5-cm and 30-cm diameter Kaufman thrusters.

A 5-cm grid translation mechanism has been developed capable of 10-deg beam deflection. A 2026-hour endurance test was run at a preset 10-deg deflection angle, and an extrapolated lifetime of better than 10,000 hours was obtained. Response time data for grid translation are presented. Preliminary results for a 30-cm diameter system are given, and results of a theoretical analysis of a dished grid system are discussed.

Lathem, W. C.↗
NASA NTRS1972

Operational characteristics of a translation screen grid beam deflection system for a 5-cm Kaufman thruster

Measurements of beam deflection angle with respect to spring positioning power and accelerator impingement current as a function of deflection angle were made on a 5-cm diameter system. Response time measurements on the translational grid beam deflection system showed that the time for the maximum deflection angle analyzed (+16.4 deg to -16.4 deg) could be reduced by a factor of nine by increasing the heating power applied to the positioning spring from 4 to 16 watts. At 14 watts the response time for maximum deflection was about 1 minute.

Lathem, W. C.↗