Engineering Papers⌕ Search

Engineering topics

Larson, R. S.

Publications and source records attributed to Larson, R. S..

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Aerodynamic and acoustic investigation of inverted velocity profile coannular exhaust nozzle models and development of aerodynamic and acoustic prediction procedures

Five co-annular nozzle models, covering a systematic variation of nozzle geometry, were tested statically over a range of exhaust conditions including inverted velocity profile (IVP) (fan to primary stream velocity ratio 1) and non IVP profiles. Fan nozzle pressure ratio (FNPR) was varied from 1.3 to 4.1 at primary nozzle pressure ratios (PNPR) of 1.53 and 2.0. Fan stream temperatures of 700 K (1260 deg R) and 1089 K(1960 deg R) were tested with primary stream temperatures of 700 K (1260 deg R), 811 K (1460 deg R), and 1089 K (1960 deg R). At fan and primary stream velocities of 610 and 427 m/sec (2000 and 1400 ft/sec), respectively, increasing fan radius ratio from 0.69 to 0.83 reduced peak perceived noise level (PNL) 3 dB, and an increase in primary radius ratio from 0 to 0.81 (fan radius ratio constant at 0.83) reduced peak PNL an additional 1.0 dB. There were no noise reductions at a fan stream velocity of 853 m/sec (2800 ft/sec). Increasing fan radius ratio from 0.69 to 0.83 reduced nozzle thrust coefficient 1.2 to 1.5% at a PNPR of 1.53, and 1.7 to 2.0% at a PNPR of 2.0. The developed acoustic prediction procedure collapsed the existing data with standard deviation varying from + or - 8 dB to + or - 7 dB. The aerodynamic performance prediction procedure collapsed thrust coefficient measurements to within + or - .004 at a FNPR of 4.0 and a PNPR of 2.0.

Larson, R. S.↗
NASA NTRS1979

A jet exhaust noise prediction procedure for inverted velocity profile coannular nozzles

Acoustic model tests have demonstrated that significant noise suppression can be obtained from inverted velocity profile coannular nozzles. An acoustic prediction procedure was developed for inverted velocity profile coannular nozzles that can be used to predict SPL spectra as a function of nozzle geometry and flow conditions. In the development of this prediction procedure, the noise spectrum at a given angle was decomposed into four noise components: a low frequency mixing noise component, a high frequency mixing noise component, an outer stream shock noise component, and an inner stream shock noise component. The physics of the inverted velocity flow field development was used to formulate noise generation models. Scaling laws for each noise component were defined based on these models. Comparisons of predictions from this procedure with experimental data were conducted to verify the prediction procedure.

Larson, R. S.↗
NASA NTRS1978

Mean velocity, turbulence intensity and turbulence convection velocity measurements for a convergent nozzle in a free jet wind tunnel

The effect of light on the mean flow and turbulence properties of a 0.056 m circular jet were determined in a free jet wind tunnel. The nozzle exit velocity was 122 m/sec, and the wind tunnel velocity was set at 0, 12, 37, and 61 m/sec. Measurements of flow properties including mean velocity, turbulence intensity and spectra, and eddy convection velocity were carried out using two linearized hot wire anemometers. Normalization factors were determined for the mean velocity and turbulence convection velocity.

Mccolgan, C. J.↗
NASA NTRS1977

Theoretical jet exhaust noise model for the duct burning turbofan

A model was developed to predict the acoustic power spectrum for a Duct Burning Turbofan (DBTF) whose cycle results in a high velocity, high temperature fan stream and a lower velocity, lower temperature primary stream. Model tests have demonstrated that a DBTF may produce substantially less noise than a conventional turbojet with the same thrust and weight flow. Predictions from the model agreed well with measured data from the model tests. The characteristics of the DBTF acoustic power spectrum were shown to be related to the rapid mixing of the fan and primary streams. The effects of fan to primary velocity ratio, temperature ratio, area ratio, and the effect of nozzle geometry on DBTF jet noise were determined.

Larson, R. S.↗
NASA NTRS1977

Mean Velocity, Turbulence Intensity and Turbulence Convection Velocity Measurements for a Convergent Nozzle in a Free Jet Wind Tunnel. Comprehensive Data Report

The effect of flight on the mean flow and turbulence properties of a 0.056m circular jet were determined in a free jet wind tunnel. The nozzle exit velocity was 122 m/sec, and the wind tunnel velocity was set at 0, 12, 37, and 61 m/sec. Measurements of flow properties including mean velocity, turbulence intensity and spectra, and eddy convection velocity were carried out using two linearized hot wire anemometers. This report contains the raw data and graphical presentations. The final technical report includes a description of the test facilities, test hardware, along with significant test results and conclusions.

Mccolgan, C. J.↗
NASA NTRS1977

Jet noise source modification due to forward flight

The effects of forward flight on the turbulence characteristics of a jet in a co-flowing stream have been determined for a 2.22 inch circular jet in a 36 inch free jet wind tunnel. The nozzle exit velocity was 400 ft/sec, and the tunnel velocity was set at 0, 40, 120 and 200 ft/sec. Measurements of flow properties including mean velocity, turbulence intensity and spectra, convection velocity, integral length scale, and convected integral time scale were carried out using two linearized hot wires. Results were used to predict changes due to flight in the jet acoustic sources. The noise reductions for a cold jet with a velocity of 1000 ft/sec, due to the change in acoustic sources in flight, agreed well at all angles with measured noise reductions.

Larson, R. S.↗