Engineering Papers⌕ Search

Engineering topics

Larrabee, E. E.

Publications and source records attributed to Larrabee, E. E..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Design of Propellers for Motorsoarers

A method was developed for the design of propellers of minimum induced loss matched to an arbitrary operating point characterized by disc loading (thrust or power), air density, shaft speed, flight speed, and number of blades. A consistent procedure is outlined to predict the performance of these propellers under off design conditions, or to predict the performance of propellers of general geometry. The examples discussed include a man powered airplane, a hang glider with a 7.5 kW (10 hp) 8,000 rpm engine, and an airplane-like motorsoarer.

Larrabee, E. E.↗
NASA NTRS1975

Preservation of wing leading edge suction at the plane of symmetry as a factor in wing-fuselage design

Most fuselage geometries cover a portion of the wing leading edge near the plane of symmetry, and it seems reasonable to expect that a large fraction of the leading edge suction which would be developed by the covered wing at high angles of attack is not developed on the fuselage. This is one of the reasons that the Oswald span efficiency factor for the wing body combination fails to approach the value predicted by lifting line theory for the isolated wing. Some traditional and recent literature on wing-body interference is discussed and high Reynolds number data on wing-body-nacelle drag are reviewed. An exposed central leading edge geometry has been developed for a sailplane configuration. Low Reynolds number tests have not validated the design concept.

Larrabee, E. E.↗
NASA NTRS1975

Propellers of Minimum Induced Loss, and Water Tunnel Tests of Such a Propeller

The fundamental vortex theory for a single rotation propeller with a finite number of blades is reviewed. The theory leads to the specification of a radial distribution of bound circulation on each blade for minimum induced loss, analogous to the elliptic spanwise distribution of bound circulation on a wing for minimum induced drag. A propeller designed in accord with this theory has been tested in a water tunnel where it exhibited high efficiency in spite of localized cavitating flow. A knowledge of the flow field for an optimum propeller is of value to the airframe designer seeking to maximize the performance of the airplane-propeller combination.

Larrabee, E. E.↗
NASA NTRS1975

Trim Drag in the Light of Munk's Stagger Theorem

Munk's stagger theorem holds that the induced drag of a multiplane is independent of the streamwise position (the stagger) of its lifting elements so long as the gap/span ratios and the element/element lift ratios are specified. In particular, a monoplane-tailplane or a monoplane-foreplane (canard)arrangement can be regarded as a biplane of zero gap and the trim drag due to tailplane download or foreplane upload can be readily calculated. The trim drag penalty is the same for both configurations. Relations are given for trim drag estimates for various practical arrangements.

Larrabee, E. E.↗
NASA NTRS1975

Minimum Vertical Tail Drag

Tail size requirement calculations are presented for a vertical tail performing a coordinated turn reversal at corresponding load requirements with minimum tail drag.

Larrabee, E. E.↗