Optical phased array feasibility study, STL-029-21, Year 1 of 1
Presentation to be presented during the Site-Directed Research and Development (SDRD) program FY 2021 review meeting (Webex), September 22–23, 2021.
Engineering topics
Publications and source records attributed to LaLone, Brandon.
Presentation to be presented during the Site-Directed Research and Development (SDRD) program FY 2021 review meeting (Webex), September 22–23, 2021.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Ms. to be submitted to Nature Photonics to gauge interest in publication. Nature Photonics website: https://www.nature.com/nphoton/
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Presentation describes project to dynamically determine the content of a shock wave-generated ejecta cloud as well as observe chemical reactions of ejecta with a surrounding gas.
This presentation describes a temperature measurement technique entirely different from the traditional pyrometry method normally used in shock wave measurements. The new technique, based on Raman spectroscopy, does not depend on surface emissivity and provides an independent way of measuring temperature.
This presentation describes a project to develop a PDV system that can measure over an area of 80 cm2, as opposed to the traditional point-sampling PDV. Ultimately the large-area PDV could be used to characterize the morphological evolution of a high-explosive event over the complete event, from very early stages (source terms) to an equilibrium state.
Presentation described project new capability at Nevada National Security Site to perform cutting-edge dynamic compression measurements.
Explore the source record for details and available documents.
Broadband Laser Ranging (BLR) is a developmental diagnostic intended to measure the position of rapidly moving surfaces in combination with optical velocimetry. Design and employment of a BLR diagnostic on dynamic experiments requires consideration for both the inherent measurement system tradeoffs as well as architectural choices appropriate to the nature of investigation. The diagnostic uses spectral interferometry to measure distance by mapping femtosecond laser pulses to the time domain via chromatic dispersion within the fiber-optic architecture. The system parameters and governing equations that describe measurement range, resolution, and Doppler sensitivity will be discussed. We will also briefly review the impact of diagnostic architectural choices including: nature of interferometer, Interferometric dispersion matching, optical amplification, integration of optical velocimetry, BLR calibration, and field operability. To summarize we will present the architectural and operational approach currently being pursued by NSTec within an on-going collaboration between NSTec, Lawrence Livermore and Los Alamos National Labs.
Broadband laser ranging (BLR) is essentially a spectral interferometer used to infer distance to a moving target. The light source is a mode-locked fiber laser, and chromatic dispersion maps the spectral interference pattern into the time domain, yielding chirped beat signals at the detector. A BLR record is a sequence of these chirped signals, representing consecutive target positions. To infer distance to a target, each underlying pulse envelope must be consistently registered and subtracted despite environmentally-induced variability. Then, nonlinear transformation of the phase is applied to remove the chirp, an FFT is performed to determine the peak frequency of the de-chirped signal, and a calibration factor relating de-chirped frequency to distance results in target position. This article discusses these analysis steps are in detail.
Presentation on the use of single-crystal copper to examine whether texture in polycrystalline metals is important, and when.
Presentation on use of grooved graded-density impactor to produce one-dimensional ramp waves for simplified isentropic compression experiments.
Abstract Not Provided
Abstract Not Provided