Engineering Papers⌕ Search

Engineering topics

Kriegsman, B. A.

Publications and source records attributed to Kriegsman, B. A..

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Performance evaluation of integrated guidance and navigation systems

The method of linear covariance analysis is applied to the study of an aerospace vehicle integrated guidance-and-navigation system. This requires that the rms trajectory deviations of the vehicle be computed along with the rms errors of the navigation system. The technique is used to examine the performance of the shuttle orbiter vehicle's guidance-and-navigation system during the terminal phase of the landing. Essentially the same rms trajectory deviations were obtained from a single covariance run as from a 30-sample Monte-Carlo run set. Of particular interest in the study was the result that rms trajectory deviations for the integrated-system were generally significantly larger than the rms navigation errors.

Tao, Y. C.↗
NASA NTRS1972

Station-keeping guidance

The station-keeping guidance system is described, which is designed to automatically keep one orbiting vehicle within a prescribed zone fixed with respect to another orbiting vehicle. The active vehicle, i.e. the one performing the station-keeping maneuvers, is referred to as the shuttle. The other passive orbiting vehicle is denoted as the workshop. The passive vehicle is assumed to be in a low-eccentricity near-earth orbit. The primary navigation sensor considered is a gimballed tracking radar located on board the shuttle. It provides data on relative range and range rate between the two vehicles. Also measured are the shaft and trunnion axes gimbal angles. An inertial measurement unit (IMU) is provided on board the orbiter. The IMU is used at all times to provide an attitude reference for the vehicle. The IMU accelerometers are used periodically to monitor the velocity-correction burns applied to the shuttle during the station-keeping mode. The guidance system is capable of station-keeping the shuttle in any arbitrary position with respect to the workshop by periodically applying velocity-correction pulses to the shuttle.

Gustafson, D. E.↗