Engineering Papers⌕ Search

Engineering topics

Kot, L.

Publications and source records attributed to Kot, L..

Double cylinder implosion experiments at the National Ignition Facility

Here, cylindrical implosion experiments are used to directly measure instability growth in a convergent geometry, providing a wealth of data for model validation. Double cylinders are a natural extension of the platform and enable measurements at a classically unstable interface, the outer surface of the inner cylinder, which experiences no ablative stabilization from the laser drive. However, the utility of this platform relies upon maintaining adequate axial uniformity of the inner cylinder during the implosion. Although previous smaller-scale double cylinder experiments exhibited acceptable levels of axial uniformity, radiation-hydrodynamics simulations of larger-scale double cylinders predict more axial non-uniformity induced by the impedance mismatch as the shock wraps around the axial ends of the inner cylinder. A mechanism to reduce axial non-uniformity in these larger double cylinder implosions is presented, and preliminary experimental data confirms the efficacy of the selected mitigation approach.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Same-sided successive-shock HED instability experiments

Inertial confinement fusion (ICF) and high-energy density (HED) physics experiments experience complicated forcing for instability growth and mix due to the ubiquitous presence of multiple shocks interacting with perturbations on multiple material interfaces. One common driver of instability growth is successive shocks from the same direction. However, there is a severe lack of analytic work and modeling validation for same-sided successive shocks since they are extremely difficult to achieve with conventional (non-HED) drivers. Successive shocks access a large instability parameter space; idealized fluid theory [K. O. Mikaelian, Phys. Rev. A 31, 410 (1985)] predicts 15 different interface evolution scenarios for a sinusoidal perturbation. Growth becomes more complex for multi-mode, compressible HED systems. The Mshock campaign is the first experiment in any fluid regime to probe a wide portion of successive shock parameter space. This is enabled by our development of a hybrid direct/indirect drive platform capable of creating independently controllable successive shocks on the National Ignition Facility. These experiments have delivered the first data capable of rigorously challenging our models and their ability to accurately capture Richtmyer–Meshkov growth under successive shocks. Single-mode and two-mode experiments have successfully demonstrated the ability to access and control the various growth scenarios of the shocked interface, including re-inversion, freeze out, and continued growth. Simulations and theoretical modeling are shown to accurately capture the experimental observations in the linear growth phase, giving us confidence in our ICF/HED design codes.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

First bromine doped cryogenic implosion at the National Ignition Facility

We report on the first experiment dedicated to the study of nuclear reactions on dopants in a cryogenic capsule at the National Ignition Facility (NIF). This was accomplished using bromine doping in the inner layers of the CH ablator of a capsule identical to that used in the NIF shot N140520. The capsule was doped with 3 × 1016 bromine atoms. The doped capsule shot, N170730, resulted in a DT yield that was 2.6 times lower than the undoped equivalent. The Radiochemical Analysis of Gaseous Samples (RAGS) system was used to collect and detect 79Kr atoms resulting from energetic deuteron and proton ion reactions on 79Br. RAGS was also used to detect 13N produced dominantly by knock-on deuteron reactions on the 12C in the ablator. High-energy reaction-in-flight neutrons were detected via the 209Bi(n,4n)206Bi reaction, using bismuth activation foils located 50 cm outside of the target capsule. The robustness of the RAGS signals suggests that the use of nuclear reactions on dopants as diagnostics is quite feasible.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

First measurement of the 10B(α,n)13N reaction in an inertial confinement fusion implosion at the National Ignition Facility: Initial steps toward the development of a radiochemistry mix diagnostic

We report the first measurement of the 10B(α,n)13N reaction in a polar-direct-drive exploding pusher (PDXP) at the National Ignition Facility (NIF). This work is motivated by the need to develop alternative mix diagnostics, radiochemistry being the focus here. The target is composed of a 65/35 at. % deuterium–tritium (DT) fill surrounded by a roughly 30 μm thick beryllium ablator. The inner portion of the beryllium ablator is doped with 10 at. % of 10B. Radiation-hydrodynamics calculations were performed in 1D to optimize both the remaining boron rho-R and the DT neutron yield. A charged-particle transport post-processor has been developed to study α-induced reactions on the ablator material. Results indicate a large 13N production from α-induced reactions on 10B, measurable by the radiochemical analysis of a gaseous samples system at the NIF. The PDXP target N201115-001 was successfully fielded on the NIF, and nitrogen from the 10B(α,n)13N reaction was measured. The 13N production yield, as well as the DT neutron yield, was, however, lower than expected. Some of the reduced yields can be explained by the oblate shape, but the ratios of the various radiochemical signals are not commensurate with expectations based on a simple reduction of the 1D results. Preliminary 2D radiation-hydrodynamics computations are consistent with the experimental measurements, and work is ongoing to extend the radiochemistry analysis into higher dimensions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Hydro-scaling of direct-drive cylindrical implosions at the OMEGA and the National Ignition Facility

Deceleration-phase Rayleigh–Taylor instability (RTI) growth during inertial confinement fusion capsule implosions significantly affects the performance as it mixes cold ablator material into the fuel. Precise measurements of such instability growth are essential for both validating the existing simulation codes and improving our predictive capability. RTI measurements on the inner surface of a spherical shell are limited and are often inferred indirectly at limited convergence. In contrast, cylindrical implosions allow for direct diagnostic access to the converging interface by imaging down the cylinder axis while retaining the effects of convergence. We have performed direct-drive cylindrical implosion experiments at both the OMEGA and the NIF laser facilities using scaled targets. RTI growth is demonstrated to be scale-invariant between the cylindrical targets at OMEGA and similar targets at the NIF, which are scaled up by a factor of three in the radial dimension. Single-mode (m = 0) instability growth factors of ~14 are measured at a convergence ratio (CR) ~ 2.5 with nearly identical mode growth at both scales. The measurements are in agreement with xRAGE radiation-hydrodynamics simulations. In addition, we have developed the Bayesian-inference-engine method to account for the variations in the target alignment, magnification, and the parallax effect in the measurement, allowing a more precise comparison between the experimental data and the simulations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Three-dimensional signatures of self-similarity in a high-energy-density plasma shear-driven mixing layer

A hydrodynamic shear mixing layer experiment at the National Ignition Facility had previously demonstrated Eulerian scaling of integrated, late-time quantities, including turbulent kinetic energy. In this manuscript, the experiment is repeated with new materials. In this work, using the new dataset, we demonstrate that Euler-number scalings hold not just for late time, but dynamically throughout the experiment, for measurements in all three spatial dimensions. Incorporating the dynamic scaling leads to an enhanced calculation that the heavier of the two scaled experiments has approached three generations of mergers of its primary instability's structures and a consistent observation of such a merger in action in the lighter of the two scaled experiments. Furthermore, the improved scrutiny of the time evolution of instability structures leads to sharper estimates of turbulent kinetic energy, including a demonstration of different behaviors correlating with surface roughness (quantitatively consistent with transitions between laminar and turbulent initial states), as predicted by a Reynolds-averaged turbulent model, which evidently correctly handles the differing shock-roughness interactions to drive its internal state of the model into different regimes. Altogether, a picture arises of the analytical improvements in treating these variations (of times, densities, and roughnesses) as a unified whole and of multiple ways by which deviations from the scaling could indicate an onset of non-hydrodynamic behavior. Such deviations were not expected for these experiments (which models correctly indicated would remain hydrodynamic) but could be introduced by, for example, imposing external fields or increasing drive energy to test conditions relevant to inertial confinement fusion or other high-energy-density experiments.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Late-time mixing and turbulent behavior in high-energy-density shear experiments at high Atwood numbers

The LANL Shear Campaign uses millimeter-scale initially solid shock tubes on the National Ignition Facility to conduct high-energy-density hydrodynamic plasma experiments, capable of reaching energy densities exceeding 100 kJ/cm3. These shock-tube experiments have for the first time reproduced spontaneously emergent coherent structures due to shear-based fluid instabilities [i.e., Kelvin-Helmholtz (KH)], demonstrating hydrodynamic scaling over 8 orders of magnitude in time and velocity. The KH vortices, referred to as “rollers,” and the secondary instabilities, referred to as “ribs,” are used to understand the turbulent kinetic energy contained in the system. Their evolution is used to understand the transition to turbulence and that transition's dependence on initial conditions. Experimental results from these studies are well modeled by the RAGE (Radiation Adaptive Grid Eulerian) hydro-code using the Besnard-Harlow-Rauenzahn turbulent mix model. Information inferred from both the experimental data and the mix model allows us to demonstrate that the specific Turbulent Kinetic Energy (sTKE) in the layer, as calculated from the plan-view structure data, is consistent with the mixing width growth and the RAGE simulations of sTKE.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Increasing shot and data collection rates of the Shock/Shear experiment at the National Ignition Facility

Updates to the Los Alamos laser-driven high-energy-density Shock/Shear mixing- layer experiment are reported, which have collectively increased the platform's shot and data acquisition rates. Also, the strategies employed have included a move from two-strip to four-strip imagers (allowing four times to be recorded per shot instead of two), the implementation of physics-informed rules of engagements allowing for the maximum flexibility in a shot's total energy and symmetry performance, and by splitting the laser's main drive pulse from a monolithic single pulse equal to all beams into a triply-segmented pulse which minimizes optics damage.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗