Kong, K. S. | Engineering Papers

NASA NTRS1995

Conductor-Backed Superconductive Coplanar-Waveguide Resonators

Report describes comparative tests of conductor-backed coplanar-waveguide resonators with design resonant frequency of 10.8 GHz. Dielectric layers in resonators made of LaAIO3 and conductive ground planes on back surfaces of dielectric layers made of gold. TI/Ba/Ca/Cu/O and Y/Ba/Cu/O units performed better than all-gold-conductor unit did, at all but highest temperatures. Results suggest TI/Ba/Ca/Cu/O may be material of choice for cryogenic microwave applications.

Miranda, F. A.↗

NASA NTRS1992

Conductor-backed coplanar waveguide resonators of Y-Ba-Cu-O and Tl-Ba-Ca-Cu-O on LaAlO3

Conductor-backed coplanar waveguide (CBCPW) resonators operating at 10.8 GHz have been fabricated from Tl-Ba-Ca-O (TBCCO) and Y-Ba-Cu-O (YBCO) thin films on LaAlO3. The resonators consist of a coplanar waveguide (CPW) patterned on the superconducting film side of the LaAlO3 substrate with a gold ground plane coated on the opposite side. These resonators were tested in the temperature range from 14 to 106 K. At 77 K, the best of our TBCCO and YBCO resonators have an unloaded quality factor (Qo) 7 and 4 times, respectively, larger than that of a similar all-gold resonator. In this study, the Qo's of the TBCCO resonators were larger than those of their YBCO counterparts throughout the aforementioned temperature range.

Miranda, F. A.↗

NASA NTRS1991

Design aspects and comparison between high T(sub c) superconducting coplanar waveguide and microstrip line

The high T sub c superconducting microstrip line and coplanar waveguide are compared in terms of the loss characteristics and the design aspects. The quality factor Q values for each structure are compared in respect to the same characteristic impedance with the comparable dimensions of the center conductor of the coplanar waveguide and the strip of the microstrip line. Also, the advantages and disadvantages for each structure are discussed in respect to passive microwave circuit applications.

Kong, K. S.↗

NASA NTRS1991

Design aspects and comparison between high Tc superconducting coplanar waveguide and microstrip line

The high T sub c superconducting microstrip line and coplanar waveguide are compared in terms of the loss characteristics and the design aspects. The quality factor Q values for each structure are compared in respect to the same characteristic impedance with the comparable dimensions of the center conductor of the coplanar waveguide and the strip of the microstrip line. Also, the advantages and disadvantages for each structure are discussed in respect to passive microwave circuit applications.

Kong, K. S.↗

NASA NTRS1990

Performance and modeling of superconducting ring resonators at millimeter-wave frequencies

Microstrip ring resonators operating at 35 GHz were fabricated from laser ablated YBCO thin films deposited on lanthanum aluminate substrates. They were measured over a range of temperatures and their performance compared to identical resonators made of evaporated gold. Below 60 Kelvin the superconducting strip performed better than the gold, reaching an unloaded Q approximately 1.5 times that of gold at 25 K. A shift in the resonant frequency follows the form predicted by the London equations. The Phenomenological Loss Equivalence Method is applied to the ring resonator and the theoretically calculated Q values are compared to the experimental results.

Bhasin, K. B.↗