Engineering topics
Knox, Robert G.
Publications and source records attributed to Knox, Robert G..
Special Opportunities for Highly Sampled Areas
This slide presentation reviews the coverage areas for the two instruments that are scheduled to be on board the HyspIRI mission, (i.e.,visible to short wave infrared (VSWIR) and a multispectral thermal infrared (TIR) imager.)
Combined VSWIR/TIR Products Overview: Issues and Examples
The presentation provides a summary of VSWIR data collected at 19-day intervals for most areas. TIR data was collected both day and night on a 5-day cycle (more frequently at higher latitudes), the TIR swath is four times as wide as VSWIR, and the 5-day orbit repeat is approximate. Topics include nested swath geometry for reference point design and coverage simulations for sample FLUXNET tower sites. Other points examined include variation in latitude for revisit frequency, overpass times, and TIR overlap geometry and timing between VSWIR data collections.
Sensitivity of June Near-Surface Temperatures and Precipitation in the Eastern United States to Historical Land Cover Changes Since European Settlement
Land cover changes alter the near surface weather and climate. Changes in land surface properties such as albedo, roughness length, stomatal resistance, and leaf area index alter the surface energy balance, leading to differences in near surface temperatures. This study utilized a newly developed land cover data set for the eastern United States to examine the influence of historical land cover change on June temperatures and precipitation. The new data set contains representations of the land cover and associated biophysical parameters for 1650, 1850, 1920, and 1992, capturing the clearing of the forest and the expansion of agriculture over the eastern United States from 1650 to the early twentieth century and the subsequent forest regrowth. The data set also includes the inferred distribution of potentially water-saturated soils at each time slice for use in the sensitivity tests. The Regional Atmospheric Modeling System, equipped with the Land Ecosystem-Atmosphere Feedback (LEAF-2) land surface parameterization, was used to simulate the weather of June 1996 using the 1992, 1920, 1850, and 1650 land cover representations. The results suggest that changes in surface roughness and stomatal resistance have caused present-day maximum and minimum temperatures in the eastern United States to warm by about 0.3 C and 0.4 C, respectively, when compared to values in 1650. In contrast, the maximum temperatures have remained about the same, while the minimums have cooled by about 0.1 C when compared to 1920. Little change in precipitation was found.
Reconstructed Historical Land Cover and Biophysical Parameters for Studies of Land-Atmosphere Interactions within the Eastern United States
The local environment where we live within the Earth's biosphere is often taken for granted. This environment can vary depending on whether the land cover is a forest, grassland, wetland, water body, bare soil, pastureland, agricultural field, village, residential suburb, or an urban complex with concrete, asphalt, and large buildings. In general, the type and characteristics of land cover influence surface temperatures, sunlight exposure and duration, relative humidity, wind speed and direction, soil moisture amount, plant life, birds, and other wildlife in our backyards. The physical and biological properties (biophysical characteristics) of land cover help to determine our surface environment because they directly affect surface radiation, heat, and soil moisture processes, and also feedback to regional weather and climate. Depending on the spatial scale and land use intensity, land cover changes can have profound impacts on our local and regional environment. Over the past 350 years, the eastern half of the United States, an area extending from the grassland prairies of the Great Plains to the Gulf and Atlantic coasts, has experienced extensive land cover and land use changes that began with land clearing in the 1600s, led to extensive deforestation and intensive land use practices by 1920, and then evolved to the present-day landscape. Determining the consequences of such land cover changes on regional and global climate is a major research issue. Such research requires detailed historical land cover data and modeling experiments simulating historical climates. Given the need to understand the effects of historical land cover changes in the eastern United States, some questions include: - What were the most important land cover transformations and how did they alter biophysical characteristics of the land cover at key points in time since the mid-1600s? - How have land cover and land use changes over the past 350 years affected the land surface environment including surface weather, hydrologic, and climatic variability? - How do the potential effects of regional human-induced land cover change on the environment compare to similar changes that are caused by the natural variations of the Earth's climate system? To help answer these questions, we reconstructed a fractional land cover and biophysical parameter dataset for the eastern United States at 1650, 1850, 1920, and 1992 time-slices. Each land cover fraction is associated with a biophysical parameter class, a suite of parameters defining the biophysical characteristics of that kind of land cover. This new dataset is designed for use in computer models of land-atmosphere interactions, to understand and quantify the effects of historical land cover changes on the water, energy, and carbon cycles
The Flora Mission for Ecosystem Composition, Disturbance and Productivity
Global land use and climate variability alter ecosystem conditions - including structure, function, and biological diversity - at a pace that requires unambiguous observations from satellite vantage points. Current global measurements are limited to general land cover, some disturbances, vegetation leaf area index, and canopy energy absorption. Flora is a pathfinding mission that provides new measurements of ecosystem structure, function, and diversity to understand the spatial and temporal dynamics of human and natural disturbances, and the biogeochemical and physiological responses of ecosystems to disturbance. The mission relies upon high-fidelity imaging spectroscopy to deliver full optical spectrum measurements (400-2500 nm) of the global land surface on a monthly time step at 45 meter spatial resolution for three years. The Flora measurement objectives are: (i) fractional cover of biological materials, (ii) canopy water content, (iii) vegetation pigments and light-use efficiency, (iv) plant functional types, (v) fire fuel load and fuel moisture content, and (vi) disturbance occurrence, type and intensity. These measurements are made using a multi-parameter, spectroscopic analysis approach afforded by observation of the full optical spectrum. Combining these measurements, along with additional observations from multispectral sensors, Flora will far advance global studies and models of ecosystem dynamics and change.
A LEO Hyperspectral Mission Implementation for Global Carbon Cycle Observations
For both terrestrial and ocean carbon cycle science objectives, high resolution (less than l0 nm) imaging spectrometers capable of acquiring multiple regional to global scale observations per day should enable the development of new remote sensing measurements for important but as yet unobservable variables, with the overall goal of linking both terrestrial and ocean carbon cycle processes to climate variability. For terrestrial research, accurate estimates of carbon, water and energy (CWE) exchange between the terrestrial biosphere and atmosphere a needed to id- the geographical locations and temporal dynamics of carbon sources/sinks and to improve regional climate models and climate change assessments. It is an enormous challenge to estimate CWE exchange from the infrequent temporal coverage and sparse spectral information provided by most single polar-orbiting, earth-looking satellite. The available satellite observations lack a sufficient number of well-placed narrow bands from which to derive spectral indices that capture vegetation responses to stress conditions associated with down-regulation of photosynthesis. Physiological status can best be assessed with spectral indices based on continuous, narrow bands in the visible/near infrared spectra, as can seasonal and annual terrestrial productivity. For coastal and ocean constituents, narrow-band observations in the ultraviolet and visible are essential to investigate the variability, dynamics and biogeochemical cycles of the world's coastal and open ocean regions, which will in turn help in measuring ocean productivity and predicting the variability of ocean carbon uptake and its role in climate change.
A GEO Hyperspectral Mission For Continental-Scale Carbon Cycle Observations
For both terrestrial and ocean carbon cycle science objectives, a hyperspectral geostationary sensor should enable the development of new remote sensing measurements for important but as yet unobservable variables, and with the overall goal of linking both terrestrial and ocean carbon cycle processes to climate variability. For terrestrial research, accurate estimates of carbon, water and energy (CWE) exchange between the terrestrial biosphere and atmosphere are needed to identify the geographical locations of carbon sources/sinks and to improve regional climate models and global climate change assessments. It is an enormous challenge to estimate CWE exchange from the infrequent temporal coverage provided by most polar-orbiting satellites, and without benefit of spectral indices that capture vegetation responses to stress conditions that down-regulate photosynthesis. Physiological status can be better assessed with spectral indices based on continuous, narrow (5 nm) bands, as can seasonal and annual terrestrial productivity. For coastal and ocean constituents, narrow-band observations in the ultraviolet and visible are essential to investigate the variability, dynamics and biogeochemical cycles of the world s coastal and open ocean regions, which will in turn help in measuring ocean productivity and predicting the variability of Ocean carbon uptake and its role in climate change scenarios. The GSFC Carbon Team has been pursuing a geostationary hyperspectral instrument, which would revolutionize our knowledge of biological processes on land, in the ocean, and along the coast by providing multiple, diurnal coverage. Preliminary studies in Goddard's Instrument Synthesis and Analysis Laboratory (ISAL) indicate that we can meet many of our science requirements: full spectral coverage (360-1000 nm); narrow bandwidths (5-10 nm); adequate ground resolution (100-200 m); and continental-scale coverage 4-6 times per day; all the while achieving a signal to noise ratio of between 500 and 1000 to 1. However, an innovative and bold focal plane design and a large mirror (1.8 meter diameter) would be required. The development of our science requirements and the results of the initial design study will be presented as well as our most recent technological developments.
Spectral Ratio Biospheric Lidar
A new active vegetation index measurement technique has been developed and demonstrated using low-power laser diodes to make horizontal-path lidar measurements of nearby deciduous foliage. The two wavelength laser transmitter operates within and adjacent to the 680 nm absorption feature exhibited by all chlorophyll containing vegetation. Measurements from early October through late November 2003 are presented and the results are discussed.
Estimating Terrestrial Carbon Exchange from Space: How Often and How Well?
Data from a new space mission measuring integrated light-use efficiency could provide a breakthrough in understanding of global carbon, water, and energy dynamics, and greatly improve the accuracy of model predictions for terrestrial carbon cycles and climate. Over the past decade, Gamon and others have shown that changes in photo-protective pigments are sensitive indicators of declines in light-use efficiency of plants and plant canopies. The requirements for integrated diurnal measurements from space need to be defined, before a space mission can be formulated successfully using this concept. We used towerbased CO 2 flux data as idealized proxies for remote measurements, examining their sampling properties. Thousands of half-hourly CO 2 flux measurements are needed before their average begins to converge on an average annual net CO 2 exchange. Estimates of daily integrated fluxes (i.e., diurnal curves) are more statistically efficient, especially if the spacing between measured days is quasiregular, rather than random. Using a few measurements per day one can distinguish among days with different net CO 2 exchanges. Fluxes sampled between mid-morning to mid-afternoon are more diagnostic than early morning or late afternoon measurements. Similar results (correlation >0.935) were obtained using 2 measurements per day with high accuracy ([:plusmn:]5%), 3 measurements per day with medium accuracy ([:plusmn:] 10%), or 5 measurements per day at lower accuracy ([:plusmn:]20%). An observatory in a geosynchronous or near-geosynchronous orbit could provide appropriate observations, as could a multi-satellite constellation in polar orbits, but there is a potential trade-off between the required number of observations per day and quality of each observation.
Primary and Secondary Controls on Measurements of Forest Height Using Large-Footprint Lidar at the Hubbard Brook LTER
On September 26, 1999, we mapped canopy structure over 90% of the Hubbard Brook Experimental Forest in White Mountain National Forest, New Hampshire, using the Laser Vegetation Imaging Sensor (LVIS). This airborne instrument was configured to emulate data expected from the Vegetation Canopy Lidar (VCL) space mission. We compared above ground heights of the tallest surfaces detected by lidar with average forest canopy heights estimated from tree-based measurements in or near 346 0.05 ha plots (made in autumn of 1997 and 1998). Vegetation heights had by far the predominant influence on lidar top heights, but with this large data set we were able to measure two significant secondary effects: those of steepness or slope of the underlying terrain and of tree crown form. The size of the slope effect was intermediate between that expected from models of homogeneous canopy layers and for solitary tree crowns. The first detected surfaces were also proportionately taller for plots with more basal area in broad leaved northern hardwoods than for mostly coniferous plots. We expected this because of the contrast between the shapes of cumulative distributions of surface area for elliptical or hemi-elliptical tree crowns and those for conical crowns. Correcting for these secondary effects, when appropriate data are available for calibration, may improve vegetation structure estimates in regional studies using VCL or similar lidar data sources.
Landscape-Scale Canopy Complexity in and Near Braulio Carillo National Park, Costa Rica
Using medium-large footprint lidar sampling of approximately 500 square km of Costa Rica, we assessed the vertical and horizontal complexity of a forest-dominated tropical landscape. As expected, vertical extents of structure and canopy heights estimated from lidar waveforms were smaller in high elevation forests than in forests at lower elevations. In areas of the park and long-protected areas of La Selva Biological Station, forests typically had more consistent ratios of median height to total height than areas with other types of recent land use. Areas outside the park exhibited both stronger and weaker spatial correlations in canopy properties than most areas within the park. We also simulated the effects of these differences on data products gridded from lidar transects, like those produced by the Vegetation Canopy Lidar (VCL) Mission.
Remote sensing of forest ecosystem dynamics: Measurements and modeling
The development of an integrated approach to the modeling of forest dynamics encompassing submodels of forest growth and succession, soil processes and radiation interactions, is reported. Remote sensing technology is a key element of this study in that it provides data for developing, initializing, updating, and validating the models. The objectives are reviewed, the data collected and models in use are discussed, and a framework for studying interactions between the forest growth, soil process and energy interaction components, is described. Remote sensing technology used in the study includes optical and microwave field, aircraft and satellite borne instruments. The types of data collected during intensive field and aircraft campaigns included bidirectional reflectance, thermal emittance and multifrequency, multipolarization synthetic aperture radar backscatter. Synthetic imagery of derived products such as forest biomass and NDVI (Normalized Difference Vegetative Index), and collections of ground data are being assembled in a georeferenced data base. These data are used to drive or test multidiscipline simulations of forested ecosystems. Enhancements to the modeling environment permit considerable flexibility in configuring simulations and selecting results for reporting and graphical display.