Engineering topics

Knox, C. E.

Publications and source records attributed to Knox, C. E..

At least 19 records

NASA NTRS1986

Algorithm for Fuel-Conservative Airplane Descents

Federal Aviation Administration implementing automated, time-based metering form of air-traffic control (ATC) with profile-descent procedures for arrivals into terminal area. Measures provide fuel savings by matching arrival of airplanes to airport acceptance rate through time-control computations and allowing pilot to descend at his discretion from cruise altitude to designated metering-fix altitude in idle-thrust clean configuration. Airborne descent algorithm developed compatible with time-based metering and profile-descent procedures and designed to improve accuracy of delivering airplane during fuel-efficient descent to metering fix at time designated by the ATC system.

Knox, C. E.↗

NASA NTRS1986

Ground-based time-guidance algorithm for control of airplanes in a time-metered air traffic control environment: A piloted simulation study

The rapidly increasing costs of flight operations and the requirement for increased fuel conservation have made it necessary to develop more efficient ways to operate airplanes and to control air traffic for arrivals and departures to the terminal area. One concept of controlling arrival traffic through time metering has been jointly studied and evaluated by NASA and ONERA/CERT in piloted simulation tests. From time errors attained at checkpoints, airspeed and heading commands issued by air traffic control were computed by a time-guidance algorithm for the pilot to follow that would cause the airplane to cross a metering fix at a preassigned time. These tests resulted in the simulated airplane crossing a metering fix with a mean time error of 1.0 sec and a standard deviation of 16.7 sec when the time-metering algorithm was used. With mismodeled winds representing the unknown in wind-aloft forecasts and modeling form, the mean time error attained when crossing the metering fix was increased and the standard deviation remained approximately the same. The subject pilots reported that the airspeed and heading commands computed in the guidance concept were easy to follow and did not increase their work load above normal levels.

Knox, C. E.↗

NASA NTRS1985

Planning fuel-conservative descents in an airline environmental using a small programmable calculator: Algorithm development and flight test results

A simple, airborne, flight-management descent algorithm was developed and programmed into a small programmable calculator. The algorithm may be operated in either a time mode or speed mode. The time mode was designed to aid the pilot in planning and executing a fuel-conservative descent to arrive at a metering fix at a time designated by the air traffic control system. The speed model was designed for planning fuel-conservative descents when time is not a consideration. The descent path for both modes was calculated for a constant with considerations given for the descent Mach/airspeed schedule, gross weight, wind, wind gradient, and nonstandard temperature effects. Flight tests, using the algorithm on the programmable calculator, showed that the open-loop guidance could be useful to airline flight crews for planning and executing fuel-conservative descents.

Knox, C. E.↗

NASA NTRS1985

Fuel-Conservative Descents Using A Programable Calcultor

Airborne descent algorithm used with or without time constraints. Concepts provide fuel savings by matching airplane arrival flow to airport acceptance rate through time control computations and allowing pilot to descend at his descretion from cruise altitude to designated metering fix in idle-thrust clean (landing gear up, flaps, zero, and speed brakes retracted) configuration. Also used for planning fuel-conservative descents when time is not consideration.

Knox, C. E.↗

NASA NTRS1985

Reference energy-altitude descent guidance: Simulator evaluation

Descent guidance was developed to provide a pilot with information to ake a fuel-conservative descent and cross a designated geographical waypoint at a preselected altitude and airspeed. The guidance was designed to reduce fuel usage during the descent and reduce the mental work load associated with planning a fuel-conservative descent. A piloted simulation was conducted to evaluate the operational use of this guidance concept. The results of the simulation tests show that the use of the guidance reduced fuel consumption and mental work load during the descent. Use of the guidance also decreased the airspeed error, but had no effect on the altitude error when the designated waypoint was crossed. Physical work load increased with the use of the guidance, but remained well within acceptable levels. The pilots found the guidance easy to use as presented and reported that it would be useful in an operational environment.

Abbot, K. H.↗

NASA NTRS1984

Application of fuel/time minimization techniques to route planning and trajectory optimization

Rising fuel costs combined with other economic pressures have resulted in industry requirements for more efficient air traffic control and airborne operations. NASA has responded with an on-going research program to investigate the requirements and benefits of using new airborne guidance and pilot procedures that are compatible with advanced air traffic control systems and that will result in more fuel efficient flight. The results of flight testing an airborne computer algorithm designed to provide either open-loop or closed-loop guidance for fuel efficient descents while satisfying time constraints imposed by the air traffic control system is summarized. Some of the potential cost and fuel savings that are obtained with sophisticated vertical path optimization capabilities are described.

Knox, C. E.↗

NASA NTRS1984

A comparison of two position estimate algorithms that use ILS localizer and DME information. Simulation and flight test results

Simulation and flight tests were conducted to compare the accuracy of two algorithms designed to compute a position estimate with an airborne navigation computer. Both algorithms used ILS localizer and DME radio signals to compute a position difference vector to be used as an input to the navigation computer position estimate filter. The results of these tests show that the position estimate accuracy and response to artificially induced errors are improved when the position estimate is computed by an algorithm that geometrically combines DME and ILS localizer information to form a single component of error rather than by an algorithm that produces two independent components of error, one from a DMD input and the other from the ILS localizer input.

Knox, C. E.↗

NASA NTRS1983

Description of the computations and pilot procedures for planning fuel-conservative descents with a small programmable calculator

A simplified flight management descent algorithm was developed and programmed on a small programmable calculator. It was designed to aid the pilot in planning and executing a fuel conservative descent to arrive at a metering fix at a time designated by the air traffic control system. The algorithm may also be used for planning fuel conservative descents when time is not a consideration. The descent path was calculated for a constant Mach/airspeed schedule from linear approximations of airplane performance with considerations given for gross weight, wind, and nonstandard temperature effects. The flight management descent algorithm and the vertical performance modeling required for the DC-10 airplane is described.

Vicroy, D. D.↗

NASA NTRS1983

Planning fuel-conservative descents with or without time constraints using a small programmable calculator: Algorithm development and flight test results

A simplified flight-management descent algorithm, programmed on a small programmable calculator, was developed and flight tested. It was designed to aid the pilot in planning and executing a fuel-conservative descent to arrive at a metering fix at a time designated by the air traffic control system. The algorithm may also be used for planning fuel-conservative descents when time is not a consideration. The descent path was calculated for a constant Mach/airspeed schedule from linear approximations of airplane performance with considerations given for gross weight, wind, and nonstandard temperature effects. The flight-management descent algorithm is described. The results of flight tests flown with a T-39A (Sabreliner) airplane are presented.

Knox, C. E.↗

NASA NTRS1982

Flight-Management Algorithm for Fuel-Conservative Descents

Federal Aviation Administration has developed an automated time-based metering form of air traffic control for arrivals into terminal area called local flow management/profile descent (LFM/PD). LFM/PD saves fuel by matching airplane arrival flow to airport acceptance rate through time-control computations and by allowing pilot to descend at his discretion from cruise altitude to metering fix in an idle-thrust, clean configuration (landing gear up, flaps zero, speed brakes retracted).

Knox, C. E.↗

NASA NTRS1981

Development of simplified airborne computations for fuel conservative descents in a time-based metered air traffic environment

The NASA has developed and flight-tested a simple flight management descent algorithm designed to improve the accuracy of delivering an airplane in a fuel-conservative manner to a metering fix at a time designated by air traffic control. This algorithm provides a three-dimensional path with terminal area time constraints (four-dimensional) for an airplane to make an idle-thrust, clean-configured (landing gear up, flaps zero, and speed brakes retracted) descent to arrive at the metering fix at a predetermined time, altitude, and airspeed. The descent path is calculated for a constant Mach/airspeed schedule from linear approximations of airplane performance with considerations given for gross weight, wind, and nonstandard pressure and temperature effects. Applications of the four-dimensional and descent planning capabilities of the algorithm to conventional airplanes is being investigated. This report describes the flight management descent algorithm and presents the results of the flight tests flown with the Terminal Configured Vehicle airplane.

Knox, C. E.↗

NASA NTRS1981

Test results of flight guidance for fuel conservative descents in a time-based metered air traffic environment

The NASA developed, implemented, and flight tested a flight management algorithm designed to improve the accuracy of delivering an airplane in a fuel-conservative manner to a metering fix at a time designated by air traffic control. This algorithm provides a 3D path with time control (4D) for the TCV B-737 airplane to make an idle-thrust, clean configured (landing gear up, flaps zero, and speed brakes retracted) descent to arrive at the metering fix at a predetermined time, altitude, and airspeed. The descent path is calculated for a constant Mach/airspeed schedule from linear approximations of airplane performance with considerations given for gross weight, wind, and nonstandard pressure and temperature effects. The flight management descent algorithms are described and flight test results are presented.

Knox, C. E.↗

NASA NTRS1980

Development and test results of a flight management algorithm for fuel conservative descents in a time-based metered traffic environment

A simple flight management descent algorithm designed to improve the accuracy of delivering an airplane in a fuel-conservative manner to a metering fix at a time designated by air traffic control was developed and flight tested. This algorithm provides a three dimensional path with terminal area time constraints (four dimensional) for an airplane to make an idle thrust, clean configured (landing gear up, flaps zero, and speed brakes retracted) descent to arrive at the metering fix at a predetermined time, altitude, and airspeed. The descent path was calculated for a constant Mach/airspeed schedule from linear approximations of airplane performance with considerations given for gross weight, wind, and nonstandard pressure and temperature effects. The flight management descent algorithm is described. The results of the flight tests flown with the Terminal Configured Vehicle airplane are presented.

Knox, C. E.↗

NASA NTRS1979

Experimental determination of position-estimate accuracy using back-azimuth signals from a microwave landing system

Flight tests using the Boeing 737 airplane to obtain position estimates with back azimuth signals from a microwave landing system (MLS) are discussed. The equations and logic used to generate a navigation position estimate in the MLS back azimuth signal environment are described. The error in the navigation position estimate is determined. A summary of the Boeing 737 position estimate update process is described. The navigation position estimate error calculated flight data and radar tracking information is analyzed. The position estimate error data using the MLS inputs are compared with error data obtained during dual distance measuring equipment updates.

Knox, C. E.↗

NASA NTRS1979

Preliminary test results of a flight management algorithm for fuel conservative descents in a time based metered traffic environment

A flight management algorithm designed to improve the accuracy of delivering the airplane fuel efficiently to a metering fix at a time designated by air traffic control is discussed. The algorithm provides a 3-D path with time control (4-D) for a test B 737 airplane to make an idle thrust, clean configured descent to arrive at the metering fix at a predetermined time, altitude, and airspeed. The descent path is calculated for a constant Mach/airspeed schedule from linear approximations of airplane performance with considerations given for gross weight, wind, and nonstandard pressure and temperature effects. The flight management descent algorithms and the results of the flight tests are discussed.

Knox, C. E.↗

NASA NTRS1979

Algorithms and logic for incorporating ILS NASA TCV B-737 airplane area navigation system

The algorithms and logic for use in the implementation of instrument landing system (ILS) localizer deviation signals for the generation of navigation and guidance information are presented. The navigation position estimates, based on range information from a randomly chosen distance measuring equipment (DME) and ILS localizer deviation information, are illustrated. The ILS volumetric coverage and DME geometric checks are described and their addition to area navigation systems with minimum software modification are discussed.

Knox, C. E.↗

NASA NTRS1979

Capturing and tracking performance of the horizontal guidance and control systems of the terminal configured vehicle

A twin-jet commercial transport equipped with digital navigation, guidance, and control systems and advanced electronic display system was used for airborne operational research. The results of flight tests which evaluated a second-order horizontal-path guidance control law and the autopilot and airplane response are presented. This evaluation was accomplished through analysis of recorded flight data and through pilot opinion of the airplane maneuvers during automatic path-capture scenarios and path tracking. Four different path captures were flown at a ground speed of approximately 160 knots and repeated at approximately 300 knots. Path tracking tracking error was measured in terms of cross track error along two paths: one pat at cruise speeds and one at airport-terminal-area speeds. The path tracking accuracy and the smoothness of the airplane maneuvers were judged satisfactory for high speeds; however, at lower speeds the control law design should be improved so that tracking will be more accurate for operations in the airport terminal area.

Knox, C. E.↗

NASA NTRS1979

Algorithms and logic for incorporating MLS back azimuth information into the NASA TCV B-737 airplane area navigation system

Navigation position estimates are based on range information form a randomly located DME and MLS back azimuth angular information. The MLS volmetric coverage checks are performed to ensure that proper navigation inputs are being utilized. These algorithms and volumetric checks were designed so that they could be added to most existing area navigation systems with minimum software modification.

Knox, C. E.↗