Engineering topics

King, Lyndell S.

Publications and source records attributed to King, Lyndell S..

8 records

NASA NTRS1998

Experimental and Computational Boundary-Layer Studies In a Supersonic Two-Dimensional Nozzle

Experiments and computations were carried out on the adiabatic laminar boundary layer developing along the surfaces of a two-dimensional supersonic nozzle, consisting of upper and lower contoured nozzle blocks and flat sidewalls. Two- and three-dimensional Navier-Stokes codes, as well as two-dimensional boundary-layer codes were employed. These codes were adapted to the characteristics of a specific wind tunnel nozzle, so that their numerical results could be directly compared with experimental data obtained in the same nozzle. Such comparisons were made for the boundary-layer growth on the nozzle contoured surfaces, and for the boundary-layer growth, surface streamlines and surface shear on the sidewalls. The three-dimensional Navier-Stokes code was found to be the only one to correctly predict the mean laminar boundary-layer flow on both the sidewalls and the contoured surfaces. Theory and experiment both indicated that the sidewall flow is highly three-dimensional, with non-uniform shear, corner vortices and a boundary layer strongly distorted by cross flows induced by lateral pressure gradients.

Demetriades, Anthony↗

NASA NTRS1996

Experimental and Computational Boundary-Layer Studies in a Supersonic Two-Dimensional Nozzle

Calculations have been carried out on the adiabatic laminar boundary layer developing on the surface of a two-dimensional supersonic nozzle, consisting of contoured nozzle blocks and flat sidewalls. Two- and three-dimensional Navier-Stokes codes, as well as two-dimensional boundary-layer codes have been employed. Thee codes have been adapted to the characteristics of a specific wind tunnel nozzle, so that their numerical results could be directly compared with experimental data obtained in the same nozzle. Such comparisons have been made for the boundary-layer growth on the contoured nozzle, and for the boundary-layer growth, surface streamlines and surface shear on the sidewalls. The three-dimensional Navier-Stokes code was found to be the only one to correctly predict the mean boundary-layer flow on both the sidewalls and the contoured nozzle. Theory and experiment both indicate that the sidewall flow is highly three-dimensional, with non-uniform shear, comer vortices and a boundary layer strongly distorted by cross flows induced by lateral pressure gradients.

Brogan, Torence P.↗

NASA NTRS1994

Quiet Supersonic Wind Tunnel Development

The ability to control the extent of laminar flow on swept wings at supersonic speeds may be a critical element in developing the enabling technology for a High Speed Civil Transport (HSCT). Laminar boundary layers are less resistive to forward flight than their turbulent counterparts, thus the farther downstream that transition from laminar to turbulent flow in the wing boundary layer is extended can be of significant economic impact. Due to the complex processes involved experimental studies of boundary layer stability and transition are needed, and these are performed in "quiet" wind tunnels capable of simulating the low-disturbance environment of free flight. At Ames, a wind tunnel has been built to operate at flow conditions which match those of the HSCT laminar flow flight demonstration 'aircraft, the F-16XL, i.e. at a Mach number of 1.6 and a Reynolds number range of 1 to 3 million per foot. This will allow detailed studies of the attachment line and crossflow on the leading edge area of the highly swept wing. Also, use of suction as a means of control of transition due to crossflow and attachment line instabilities can be studied. Topics covered include: test operating conditions required; design requirements to efficiently make use of the existing infrastructure; development of an injector drive system using a small pilot facility; plenum chamber design; use of computational tools for tunnel and model design; and early operational results.

King, Lyndell S.↗

NASA NTRS1993

Comparison of predictions with measurements for a quiet supersonic tunnel

Navier-Stokes and boundary layer calculations were made to study the mean flow through the Montana State University Mach 3 supersonic wind tunnel. Two-dimensional results along the nozzle surface are found to be in good agreement with experiment. For the sidewalls a 3D solution was necessary because of a skew-induced secondary flow that produced significant crossflows in the sidewall boundary layer and thickening of the boundary layer near the sidewall centerline. Boundary layer stability calculations revealed Goertler instabilities in the nozzle producing N factors up to 6. Preliminary results for the crossflow instability on the tunnel sidewall show a maximum N factor of about 2.5 under test conditions for which laminar flow was observed experimentally.

King, Lyndell S.↗

NASA NTRS1992

Development of the NASA-Ames low disturbance supersonic wind tunnel for transition research up to Mach 2.5

A unique, low-disturbance supersonic wind tunnel is being developed at NASA-Ames to support supersonic laminar flow control research at cruise Mach numbers of the High Speed Civil Transport (HSCT). The distinctive aerodynamic features of this new quiet tunnel will be a low-disturbance settling chamber, laminar boundary layers on the nozzle walls and steady supersonic diffuser flow. Furthermore, this new wind tunnel will operate continuously at uniquely low compression ratios (less than unity). This feature allows an existing non-specialist compressor to be used as a major part of the drive system. In this paper, we highlight activities associated with drive system development, the establishment of natural laminar flow on the test section walls, and instrumentation development for transition detection. Experimental results from an 1/8th-scale model of the supersonic wind tunnel are presented and discussed in association with theoretical predictions. Plans are progressing to build the full-scale wind tunnel by the end of 1993.

Wolf, Stephen W. D.↗

NASA NTRS1992

Design features of a low-disturbance supersonic wind tunnel for transition research at low supersonic Mach numbers

A unique, low-disturbance supersonic wind tunnel is being developed at NASA-Ames to support supersonic laminar flow control research at cruise Mach numbers of the High Speed Civil Transport (HSCT). The distinctive design features of this new quiet tunnel are a low-disturbance settling chamber, laminar boundary layers along the nozzle/test section walls, and steady supersonic diffuser flow. This paper discusses these important aspects of our quiet tunnel design and the studies necessary to support this design. Experimental results from an 1/8th-scale pilot supersonic wind tunnel are presented and discussed in association with theoretical predictions. Natural laminar flow on the test section walls is demonstrated and both settling chamber and supersonic diffuser performance is examined. The full-scale wind tunnel should be commissioned by the end of 1993.

Wolf, Stephen W. D.↗

NASA NTRS1991

An efficient supersonic wind tunnel drive system for Mach 2.5 flows

A novel efficient drive system has been developed which provides for the continuous operation of a pitot Mach 2.5 wind tunnel at compression ratios down to 0.625:1. The drive system does not require an overpressure to start, and no hysteresis has been observed. The general design of the proof-of-concept wind tunnel using the new drive system and its modifications are described.

Wolf, Stephen W. D.↗

NASA NTRS1987

A comparison of turbulence closure models for transonic flows about airfoils

Navier-Stokes transonic airfoil calculations using three different turbulence closure models are presented and compared with available experimental data. Two of the models, Cebeci-Smith and Baldwin-Lomax, are equilibrium models in the sense that the turbulent shear stress is assumed to depend only on the local properties of the mean flow. The third model, Johnson and King, is a nonequilibrium model in which an ordinary differential equation is employed to account for the streamwise development of the maximum Reynolds shear stress. An eddy viscosity distribution across the boundary layer is assumed which is functionally dependent on this stress. For attached flows with little inviscid-viscous interaction, little difference in the results with the different models is noted. With stronger interactions and with separation occurring on the airfoils, the nonequilibrium model is shown to perform better.

King, Lyndell S.↗