Engineering Papers⌕ Search

Engineering topics

Kim, H J

Publications and source records attributed to Kim, H J.

Ultra-wideband coaxial hybrid coupler for load resilient ion cyclotron range of frequency heating at fusion plasmas

We designed a high power and ultra-wideband two-section 3 dB coaxial hybrid coupler for load resilient ion cyclotron range of frequency heating by configuring asymmetric impedance matching using a three-dimensional simulation code, hfss. By adjusting the characteristic impedances of main and coupled lines of the hybrid coupler, we realized that the bandwidth of the proposed circuit is not only wider than that of a conventional three-section coupler, but also that the bandwidth is almost twice as wide compared to the conventional two-section hybrid coupler while maintaining the identical overall size.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Status of KSTAR 170 GHz, 1 MW Electron Cyclotron Heating and Current Drive System

A 170 GHz Electron Cyclotron Heating and Current Drive (ECH/CD) system on KSTAR is designed to launch total 2.4 MW of power for up to 300 sec into the plasma. At present the first 1 MW ECH/CD system is under installation and commissioning for 2011 KSTAR campaign. The 170 GHz, 1 MW, 300 sec gyrotron and the matching optics unit (MOU) will be provided from JAEA under collaboration between NFRI and JAEA. The transmission line consists of MOU and 70 m long 63.5 mm ID corrugated waveguides with the eight miter bends. The 1 MW, 10 sec launcher is developed based on the existing two-mirror front-end launcher in collaboration with Princeton Plasma Physics Laboratory and Pohang University of Science and Technology, and is installed on the low field side in the KSTAR equatorial plane. The mirror pivot is located at 30 cm below from the equatorial plane. 3.6 MVA power supply system is manufactured and now is under commissioning to meet the triode gun operation of JAEA gyrotron. The power supply consists of 66 kV/55 A cathode power supply, mode-anode system, and 50 kV/160 mA body power supply. In this paper, the current status of KSTAR 170 GHz, 1 MW ECH/CD system will be presented as well as the experimental plan utilizing 170 GHz new ECH/CD system.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Long-Range And Head-On Beam-Beam Compensation Studies in RHIC With Lessons for the LHC

Long-range as well as head-on beam-beam effects are expected to limit the LHC performance with design parameters. They are are also important consideration for the LHC upgrades. To mitigate long-range effects, current carrying wires parallel to the beam were proposed. Two such wires are installed in RHIC where they allow studying the effect of strong long-range beam-beam effects, as well as the compensation of a single long-range interaction. The tests provide benchmark data for simulations and analytical treatments. Electron lenses were proposed for both RHIC and the LHC to reduce the head-on beam-beam effect. We present the experimental long-range beam-beam program at RHIC and report on head-on compensations studies based on simulations.

43 PARTICLE ACCELERATORS↗

Search for a Low Mass Particle Decaying into {mu}{sup +}{mu}{sup -} in B{sup 0}{yields}K{sup *0}X and B{sup 0}{yields}{rho}{sup 0}X at Belle

We search for dimuon decays of a low mass particle in the decays B{sup 0{yields}}K{sup *0}X and B{sup 0{yields}{rho}0}X using a data sample of 657x10{sup 6}BB events collected with the Belle detector at the KEKB asymmetric-energy e{sup +}e{sup -} collider. We find no evidence for such a particle in the mass range from 212 MeV/c{sup 2} to 300 MeV/c{sup 2} for lifetimes below 10{sup -12} s, and set upper limits on its branching fractions. In particular, we search for a particle with a mass of 214.3 MeV/c{sup 2} reported by the HyperCP experiment, and obtain upper limits on the products B(B{sup 0}{yields}K{sup *0}X)xB(X{yields}{mu}{sup +}{mu}{sup -})<2.26(2.27)x10{sup -8} and B(B{sup 0}{yields}{rho}{sup 0}X)xB(X{yields}{mu}{sup +}{mu}{sup -})<1.73(1.73)x10{sup -8} at 90% C.L. for a scalar (vector) X particle.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Effect of Asymmetric Rolling on Plastic Anisotropy of Low Carbon Steels during Simple Shear Tests

Simple shear tests are performed on low carbon steel pre-deformed in conventional, asymmetric and orthogonal-asymmetric rolling. The simple-shear tests were carried out at 0 deg. , 45 deg. and 135 deg. with respect to the previous rolling direction. For a reduction ratio of 15%, a transient stagnation in the hardening rate is observed at reloading for all changes in strain path. The shear stress level, the hardening rate and extent of the plateau appear to be insensitive to the preliminary applied rolling conditions. After a reduction ratio of 50%, plastic instability was detected at reloading for all the changes of strain path and rolling conditions studied. A specific heat treatment was then designed allowing the material to become ductile after rolling while retaining the fine microstructure and therefore the high strength. Promising results were obtained essentially for 45 deg. shear tests.

36 MATERIALS SCIENCE↗

CRAB Cavity in CERN SPS

Beam collisions with a crossing angle at the interaction point are often necessary in colliders to reduce the effects of parasitic collisions which induce emittance growth and decrease beam lifetime. The crossing angle reduces the geometrical overlap of the beams and hence the luminosity. Crab cavity offer a promising way to compensate the crossing angle and to realize effective head-on collisions. Moreover, the crab crossing mitigates the synchro-betatron resonances due to the crossing angle. A crab cavity experiment in SPS is proposed as a proof of principle before deciding on a full crab-cavity implementation in the LHC. In this paper, we investigate the effects of a single crab cavity on beam dynamics in the SPS and life time.

43 PARTICLE ACCELERATORS↗

Dielectric response of AlSb from 0.7 to 5.0 eV determined by in situ ellipsometry

We present pseudodielectric function data <{epsilon}>=<{epsilon}{sub 1}>+i<{epsilon}{sub 2}> from 0.7 to 5.0 eV of oxide-free AlSb that are the closest representation to date of the intrinsic bulk dielectric response {epsilon} of the material. Measurements were done on a 1.5 {mu}m thick film grown on (001) GaAs by molecular beam epitaxy. Data were obtained with the film in situ to avoid oxidation artifacts. Overlapping critical-point (CP) structures in the E{sub 2} energy region were identified by means of band-structure calculations done with the linear augmented Slater-type orbital method. Calculated CP energies agree well with those obtained from data, confirming the validity of the calculations.

36 MATERIALS SCIENCE↗

Simulations of beam-beam and beam-wire interactions in RHIC

The beam-beam interaction is one of the dominant sources of emittance growth and luminosity lifetime deterioration. A current-carrying wire has been proposed to compensate long-range beam-beam effects in the LHC and strong localized long-range beam-beam effects are experimentally investigated in the RHIC collider. Tune shift, beam transfer function, and beam loss rate are measured in dedicated experiments. In this paper, we report on simulations to study the effect of beam-wire interactions based on diffusive apertures, beam loss rates, and beam transfer function using a parallelized weak-strong beam simulation code (BBSIMC). The simulation results are compared with measurements performed in RHIC during 2007 and 2008.

43 PARTICLE ACCELERATORS↗

Effects of self-assembled monolayer and PFPE lubricant on wear characteristics of flat silicon tips.

The effects of self-assembled monolayer (SAM) and perfluoropolyether (PFPE) lubricant on the wear characteristics of flat silicon tips were investigated. The wear test consisted of sliding the silicon tips fabricated on a flat silicon specimen against SAM and PFPE (Z-tetraol) coated silicon (100) wafer. The tips were slid at a low speed for about 15 km under an applied load of 39.2 {micro}N. The wear volume of the tip was obtained by measuring the tip profile using an Atomic Force Microscope (AFM). It was found that the coatings were effective in reducing the wear of the tips by an order of magnitude from 10{sup -6} to 10{sup -7}.

36 MATERIALS SCIENCE↗

Results from KIMS

KIMS is a dark matter search experiment using low background CsI(TB) crystals at Yangyang Underground Laboratory in Korea. With a total exposure of 3409 kg{center_dot}d data, we set a new limit on WIMP-nucleon cross section. We achieved the most stringent limit on the spin-dependent interaction for a pure proton case. We were able to exclude the DAMA signal region for both spin-dependent and spin-independent interaction for the WIMP mass greater than 20 GeV/c{sup 2}. KIMS experiment is upgraded with 12 CsI(TB) crystals corresponding to a total mass of 104 kg and accumulating data since Jan. 2008.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗