Engineering topics
Khitun, A.
Publications and source records attributed to Khitun, A..
A spin-wave magnetometer with a positive feedback
In this work, we demonstrate experimentally the operation of a spin-wave magnetometer integrated into a circuit with a positive feedback. The circuit consists of the passive magnetic and active electric parts. The magnetic part includes a sensing element, which is a magnetic cross junction made of Y 3 Fe 2 (FeO 4 ) 3 . The electric part includes a non-linear amplifier and a phase shifter. The electric and magnetic parts are connected via micrometer size antennae. Spin waves are excited by two of these antennae while the output inductive voltage produced by the interfering spin waves is detected by the third antenna. Spin waves propagating in the orthogonal arms of the cross can accumulate significantly different phase shifts, depending on the direction and the strength of the external magnetic field. The output inductive voltage reaches its maximum in the case of constructive spin wave interference. The positive feedback provides further signal amplification. It appears possible to enhance the response function, compared to the passive circuits without a feedback, by a factor of ×100 without an increase in the noise level. The experimental data show a prominent response to the external magnetic field variation, exceeding 5 x 10 3 V/T. The intrinsic noise spectral density of the device can be as low as 10 -16 V 2 /Hz. The estimated sensitivity of the prototype device is 2 x 10 -12 T/√Hz at room temperature. We argue that spin-wave magnetometers can potentially be as sensitive as SQUIDs while operating at room temperature.
Interference of Spin Waves in Arrays of Microwaveguides Based on Yttrium-Iron Garnet Films
Effects of propagation and interference of spin waves in an eight-port magnonic structure in the form of a 2 × 2 array of microwaveguides based on yttrium-iron garnet films with microantennas placed at the waveguide ends are studied experimentally and numerically. It is shown that conditions for a constructive and destructive interference of spin waves, which is necessary for creating spin-wave logic devices, can be implemented at output transducers by changing the phase of input signals.
The discrete noise of magnons
We report experimental results, which show that the low-frequency noise of magnonic devices is dominated by the random telegraph signal noise rather than 1/$f$ noise—a striking contrast to many electronic devices ($f$ is a frequency). It was also found that the noise level of surface magnons depends strongly on the power level, increasing sharply at the on-set of nonlinear dissipation. The presence of the random telegraph signal noise suggests that the current fluctuations involve random discrete macro events caused by an individual macro-scale fluctuator. We anticipate that our results will help in developing the next generation of magnonic devices for information processing and sensing.
Nonreciprocity of backward volume spin wave beams excited by the curved focusing transducer
The focusing effect for spin waves excited by a curved micrometer-sized coplanar waveguide transducer on top of a 5-μm-thick epitaxial yttrium iron garnet film is studied by means of the micro-focused Mandelstam-Brillouin light scattering technique and micromagnetic simulations. The curvilinear transducer is designed to focus the backward volume spin waves on the in-plane bias magnetic field applied along the symmetry axis of the transducer. We show that two-dimensional maps of spin wave intensity exhibit nonreciprocal properties without mirror symmetry with respect to the magnetic field direction and the focusing effect. The observed effects are the consequence of nonreciprocity of the backward volume spin waves travelling at an angle toward the bias field direction.
Realization of spin wave switch for data processing
In this work, experimental data on a spin wave switch based on spin wave interference is reported. The switch is a three terminal device where spin wave propagation between the source and the drain is modulated by the control spin wave signal. The prototype is a micrometer scale device based on Y 3 Fe 2 (FeO 4 ) 3 film. The output characteristics show the oscillation of the output spin wave signal as a function of the phase difference between the source and the drain spin wave signals. The On/Off ratio of the prototype exceeds 20 dB at room temperature. The utilization of phase in addition to amplitude for information encoding offers an innovative route towards multi-state logic circuits. The advantages and shortcomings of spin wave switches are also discussed.
Effects of the magnetic field variation on the spin wave interference in a magnetic cross junction
This article reports results of the investigation of the effect of the external magnetic field variation on the spin wave interference in a magnetic cross junction. The experiments were performed using a micrometer scale Y 3 Fe 5 O 12 cross structure with a set of micro-antennas fabricated on the edges of the cross arms. Two of the antennas were used for the spin wave excitation while a third antenna was used for detecting the inductive voltage produced by the interfering spin waves. It was found that a small variation of the bias magnetic field may result in a significant change of the output inductive voltage. The effect is most prominent under the destructive interference condition. The maximum response exceeds 30 dB per 0.1 Oe at room temperature. It takes a relatively small bias magnetic field variation of about 1 Oe to drive the system from the destructive to the constructive interference conditions. The switching is accompanied by a significant, up to 50 dB, change in the output voltage. The obtained results demonstrate a feasibility of the efficient spin wave interference control by an external magnetic field, which may be utilized for engineering novel type of magnetometers and magnonic logic devices.
A Magnetometer Based on a Spin Wave Interferometer
Here, we describe a magnetic field sensor based on a spin wave interferometer. Its sensing element consists of a magnetic cross junction with four micro-antennas fabricated at the edges. Two of these antennas are used for spin wave excitation while two other antennas are used for detection of the inductive voltage produced by the interfering spin waves. Two waves propagating in the orthogonal arms of the cross may accumulate significantly different phase shifts depending on the magnitude and direction of the external magnetic field. This phenomenon is utilized for magnetic field sensing. The sensitivity attains its maximum under the destructive interference condition, where a small change in the external magnetic field results in a drastic increase of the inductive voltage, as well as in the change of the output phase. We report experimental data obtained for a micrometer scale Y 3 Fe 2 (FeO 4 ) 3 cross structure. The change of the inductive voltage near the destructive interference point exceeds 40 dB per 1 Oe. The phase of the output signal exhibits a π-phase shift within 1 Oe. The data are collected at room temperature. Taking into account the low thermal noise in ferrite structures, we estimate that the maximum sensitivity of the spin wave magnetometer may exceed attotesla.
Variable-temperature inelastic light scattering spectroscopy of nickel oxide: Disentangling phonons and magnons
We report the results of an investigation of the temperature dependence of the magnon and phonon frequencies in NiO. A combination of Brillouin-Mandelstam and Raman spectroscopies allowed us to elucidate the evolution of the phonon and magnon spectral signatures from the Brillouin zone center (GHz range) to the second-order peaks from the zone boundary (THz range). The temperature-dependent behavior of the magnon and phonon bands in the NiO spectrum indicates the presence of antiferromagnetic (AF) order fluctuation or a persistent AF state at temperatures substantially above the Néel temperature (TN=523 K). Tuning the intensity of the excitation laser provides a method for disentangling the features of magnons from acoustic phonons in AF materials without the application of a magnetic field. Our results are useful for the interpretation of the inelastic-light scattering spectrum of NiO and add to the knowledge of its magnon properties important for THz spintronic devices.
Spin wave interference in YIG cross junction
Not Available
Perpendicularly magnetized YIG-film resonators and waveguides with high operating power
Not Available
Pattern recognition with magnonic holographic memory device
In this work, we present experimental data demonstrating the possibility of using magnonic holographic devices for pattern recognition. The prototype eight-terminal device consists of a magnetic matrix with micro-antennas placed on the periphery of the matrix to excite and detect spin waves. The principle of operation is based on the effect of spin wave interference, which is similar to the operation of optical holographic devices. Input information is encoded in the phases of the spin waves generated on the edges of the magnonic matrix, while the output corresponds to the amplitude of the inductive voltage produced by the interfering spin waves on the other side of the matrix. The level of the output voltage depends on the combination of the input phases as well as on the internal structure of the magnonic matrix. Experimental data collected for several magnonic matrixes show the unique output signatures in which maxima and minima correspond to specific input phase patterns. Potentially, magnonic holographic devices may provide a higher storage density compare to optical counterparts due to a shorter wavelength and compatibility with conventional electronic devices. The challenges and shortcoming of the magnonic holographic devices are also discussed.