NASA NTRS2021
Future lander missions will travel to ambitious, scientifically interesting locations near rough and dangerous terrain. They will need to operate with limited prior information about the terrain, and under varying lighting conditions. Landing safely and precisely in the face of these challenges is difficult for existing vision-based landing systems, which require detailed orbital reconnaissance, a priori hazard maps, and impose time-of-day restrictions on landing to ensure similar lighting conditions in orbital and descent imagery. Advanced 3D imaging LiDAR systems currently under development, and originally intended for single-scan hazard detection, have the potential to be operated continuously from altitudes of up to 5 km. Used together with existing inertial measurement units (IMUs), these sensors open a path-to-flight for a full navigation and mapping system, which could replace or augment a traditional landing sensor suite. A landing system based around these sensors can perform accurate altimetry, map-relative localization (MRL), LiDAR-inertial odometry, and map refinement in an illumination-insensitive manner, over unknown or partially known terrain. This paper outlines preliminary work on a LiDAR-inertial landing system that: estimates the spacecraft trajectory during entry, descent, and landing (EDL); and maps the topography of the terrain below, for future use in hazard detection and avoidance. An incremental, factor graph based, smoothing approach is used to solve for the maximum a posteriori trajectory of spacecraft states. Integrated IMU measurements and features tracked in adjacent range and intensity images are used to estimate motion (LiDAR-inertial odometry). LiDAR scans are binned into motion-corrected digital elevation models (DEMs), which are matched to an existing orbital topographic map to provide absolute position information (MRL). The estimated trajectory is then used to project the LiDAR scans into the map frame, creating a variable-resolution quadtree topographic map suitable for hazard detection and avoidance. Existing topographic maps from throughout the solar system (i.e., Earth, the Moon, Mars, Ceres, Vesta, Europa, Enceladus, and Eros) are upsampled for use in EDL simulations. The Mars 2020 Lander Vision System Simulator (LVSS) is extended to simulate LiDAR-inertial data for realistic EDL trajectories. Results of the algorithm operating on the simulated data are presented. Estimated spacecraft trajectory and refined map are compared to ground truth to assess estimation accuracy.