Engineering topics

Kasule, Jotham

Publications and source records attributed to Kasule, Jotham.

2 records

DOE OSTI2023

PRINTED, PLANAR MICROWAVE CONNECTOR WITH MULTIPLE SIGNAL LINES

Microwave connectors with a planar geometry have been demonstrated using additive manufacturing techniques. This planar form factor is expected to enable connectors to be integrated directly with other components onto a printed circuit board. The connectors were developed with multiple signal lines that will increase the density of signal connections to PCBs, eliminating the physical constraints of single-signal COTS microwave connectors. This work developed electromagnetic models (using Ansys HFSS) of these planar connectors to predict performance and optimize connector design. Materials and printing processes were developed to fabricate the connectors based on high-temperature PEEK thermoplastics. The multiple signal connectors were designed to operate over the 1-6GHz band and are built upon the single signal printed planar geometry connector introduced in a previous paper [1].

Additive Manufacturing↗

DOE OSTI2022

Printed Microwave Connector

This paper describes the development of a printed, planar microwave connector operating from 1-7 GHz. The connector, which is based on a Grounded Coplanar Waveguide (GCPW) transmission line structure, is fabricated using 3D-printed thermoplastic material (PEEK) and conductive nanoparticle silver ink. Electromagnetic models were established to provide guidance on design tradeoffs and their impact on microwave performance. New mechanical designs were also developed to provide accurate alignment and robust connection of the two halves of the planar connector structure. Initial connector prototypes were fabricated to validate the new planar design using conventional double-sided copper laminates (Isola MT40). The designs were then implemented in an all-printed version of the connector. Electromagnetic models of the printed connectors were developed using the measured dielectric properties of printed PEEK. The insertion loss of the printed connectors was measured to be less than 1.7dB across the band.

Microwave Connector, printed electronics, additive↗