Engineering topics
Publications and source records attributed to Kassel, P. C., Jr..
The objective of this experiment is to study interplanetary dust, variously referred to as cosmic dust, cometary dust, zodiacial dust, or meteoric dust particles. Specific objectives are to obtain information regarding particle mass and velocity, and to undertake correlative analyses with other experiments, both on LDEF or near the time of the LDEF flight.
Time photograph is taken and is permanently recorded on edge of exposure by compact electronics module that attaches to camera case. Single-chip timing circuit drives LED display, which is imaged on film plane. Normally blanked display is unblanked when shutter switch is activated.
Apparatus uses optoelectric detector to measure station-to-station time-of-flight of small spherical aluminum projectile down steel barrel. Instrument has been used to study impact resistance of composite materials used in aircraft structural research program.
A fail safe light activated switch was used as an emergency control link at the Langley Vortex Research Facility. In this facility aircraft models were towed through a still air test chamber by a gasoline powered vehicle which was launched from one end of a 427-meter track and attained velocities to 31 m/sec in the test chamber. A 5 mW HeNe laser with a mechanical copper provided a connecting link with the moving tow vehicle on which a silicon photodiode receiver with a specially designed amplifier provided a fail safe switching action. This system provided an emergency means of stopping the vehicle by turning off the laser to interrupt the power to the vehicle ignition and brake release systems.
A series of impact tests are described and data presented which characterize the operation of the capacitor-type micrometeoroid flux detectors used on the Meteoroid Technology Satellite (MTS). Capacitor-type detectors with silicon dioxide dielectric thickness of 0.4 and 1.0 microns were tested in the micrometeoroid impact simulator at the Langley Research Center, a 4-MV Van de Graaff electrostatic accelerator. The carbonyl iron projectiles were from 0.5 to 5.0 microns in diameter with velocities from 4 to 10.0 km/sec. The detector bias voltage was varied from -20 to -60 V; some tests were at detector temperatures of 90 C to -100 C; and the angle of impact varied from 0 deg to 75 deg from the normal to the detector. These tests showed that: (1) the detector operation is reliable when the bias voltage is greater than 30 V; (2) after an impact the detector returns to its original condition with an insignificant loss of active area; and (3) the sensitivity of the detector is inversely proportional to the detector thickness. The test results suggest a theoretical model in which the signal is an arc triggered by the impacting projectile, and the detector bias voltage must be high enough to insure that an arc will form.
Ultrahigh speed photographic system for photographing hypervelocity projectiles and impact phenomena
Flash X ray to determine recessions in ablative materials
Flash X ray unit with special film transport devices to obtain sequenced dynamic radiographs of ablating models during reentry simulation tests