Engineering topics

Karamcheti, K.

Publications and source records attributed to Karamcheti, K..

At least 37 records · Page 2

NASA NTRS1979

Acoustic resonances and sound scattering by a shear layer

The energy reflection coefficient is evaluated numerically for plane waves incident on a plane shear layer having a linear velocity profile. The shear layer is found to exhibit no resonances and no Brewster angles. The behavior of the reflection coefficient depends crucially on the parameter tau, a nondimensional measure of the disturbance Strouhal number with respect to the disturbance Mach number in the mean flow direction. For moderate values of tau, the amplified reflection regime degenerates into the total reflection one, whereas in the ordinary reflection regime the variation of the reflection coefficient with tau depends on whether or not the corresponding vortex sheet has a Brewster angle. The results indicate that caution should be exercised in uncritically modeling a finite thickness shear layer by a corresponding vortex sheet.

Koutsoyannis, S. P.↗

NASA NTRS1979

An experimental study of multiple jet mixing

Measurements of an incompressible jet issuing from an array of rectangular lobes, equally spaced with their small dimensions in a line, both as a free jet, and as a confined jet, are carried out in three parts: (1) on a single rectangular free jet, (2) on the same jet in a multiple free jet configuration, and (3) on the same jet in a multiple jet configuration with confining surfaces (two parallel plates are symmetrically placed perpendicular to the long dimension of each lobe covering the entire flow field under consideration). In the case of a single rectangular free jet, the flow field of the jet is characterized by the presence of three distinct regions in the axial mean velocity decay and are referred to as: potential core region, two dimensional type region, and axisymmetric type region. In the case of a multiple free jet, the flow field for downstream distance X greater than 60D (D = width of a lobe) resembles that of a jet exiting from a two dimensional nozzle with its short dimension being the long dimension of the lobe.

Krothapalli, D.↗

NASA NTRS1979

Some observations of flow structure in multiple jet mixing

Results of hot wire measurements in an incompressible jet issuing from an array of rectangular lobes, equally spaced with their small dimensions in a line, both as a free jet, and as a confined jet, are presented. In the case of a multiple free jet, the flow field for downstream distance x greater than 60D (D = width of a lobe) resembles that of a jet exiting from a two-dimensional nozzle with its short dimension being the long dimension of the lobe. The field of turbulence is found to be nearly isotropic in the plane containing the small dimension of the lobes for x greater than 60D. In the case of a confined multiple jet, the flow field is observed to be nearly homogeneous and isotropic for x greater than 60D.

Krothapalli, A.↗

NASA NTRS1979

Turbulence measurements in a rectangular jet

The paper deals with hot-wire measurements in a rectangular incompressible jet issuing into a medium at rest. The flow field of the jet was found to be characterized by the presence of three distinct regions with respect to the mean axial velocity on the center line, referred to as potential core region, two-dimensional type region, and axisymmetric type region. The onset of the second region appears to be at downstream locations where the shear layers from the short dimension of the nozzle meet. Similarly, the center line velocity decay is first of axisymmetric nature at a downstream location where the two shear layers from the long dimension of the nozzle meet. The conditions for the existence of a rectangular jet of an aspect ratio of 16.7 with the laminar tophat profile at the exit are identified.

Krothapalli, A.↗

NASA NTRS1979

An experimental investigation of the flow field of a rectangular wall jet

The structure of a laminar, rectangular wall jet developing from an initially parabolic velocity profile was investigated with measurements of the mean and fluctuating velocity field, and with Schlieren flow visualization. The effects on mean and fluctuating velocity fields of changes in the jet Reynolds number over the range of from 0 to 4800, and of various wall lengths ranging from 0 to 312 jet widths were studied. For a given wall length and Reynolds number, disturbances in the flow field were regular and periodic, and of a constant frequency in a large region of the flow field. Small, self-excited disturbances at the nozzle exit were observed to grow exponentially with downstream distance, and roll up to form a convecting array of discrete vortices. For certain values of wall length and jet speed, discrete audible tones were detected, and appeared to be associated with an enhancement of the regularity and stability of the vortex array.

Horne, C.↗

NASA NTRS1978

Propagation of sound through a sheared flow

Sound generated in a moving fluid must propagate through a shear layer in order to be measured by a fixed instrument. These propagation effects were evaluated for noise sources typically associated with single and co-flowing subsonic jets and for subcritical flow over airfoils in such jets. The techniques for describing acoustic propagation fall into two categories: geometric acoustics and wave acoustics. Geometric acoustics is most convenient and accurate for high frequency sound. In the frequency range of interest to the present study (greater than 150 Hz), the geometric acoustics approach was determined to be most useful and practical.

Woolley, J. P.↗

NASA NTRS1978

Some features of a wake tone flow field

An experimental investigation of a two-dimensional model of bluff body wake-surface interaction noise examines the changes in the flow field associated with changes in sound generated. Results show three distinct flow regimes separated by large differences in wake structure. In the first, with the surface in the near wake, discrete frequency sound is totally suppressed. At greater separation distances an amplified discrete frequency tone, a wake tone, is generated with the frequency a function of the separation distance. The final regime, with the surface in the far wake, is similar to a wake with no surface interaction.

Smith, C. A.↗

NASA NTRS1976

An analytical study of noise generation by subsonic flows in the presence of rigid surfaces

A general analytical method is developed for determination of the radiated noise field from highly sheared, subsonic flows in the presence of rigid surfaces. The method is specifically formulated to use measurable flow field properties as the basis input data for calculations. The governing equations of a viscous, incompressible fluid are employed to determine approximately the so-called shear noise source strength distribution in the flow. Mean rates of strain and fluctuating velocity covariances are the fundamental input data for calculations. The method is applied to the wall jet region of a circular jet impinging at 45 deg to an infinite plane surface. Velocity field measurements of Foss are used to describe the required flow properties. Comparisons of calculated results with measured surface pressures and sound pressure levels are given and discussed.

Wooley, J. P.↗

NASA NTRS1976

Effects of friction and heat conduction on sound propagation in ducts

The theory of sound propagation is examined in a viscous, heat-conducting fluid, initially at rest and in a uniform state, and contained in a rigid, impermeable duct with isothermal walls. Topics covered include: (1) theoretical formulation of the small amplitude fluctuating motions of a viscous, heat-conducting and compressible fluid; (2) sound propagation in a two dimensional duct; and (3) perturbation study of the inplane modes.

Huerre, P.↗

NASA NTRS1976

Pressure fluctuations on the surface of a cylinder in uniform flow

The problem of determining the pressure fluctuations induced on the surface of a cylinder by the fluctuating wake behind it is formulated. A formal solution relating the unsteady surface pressure field to the velocity field in the wake is derived and used to obtain general results independent of cylinder shape and Reynolds number. The case of the circular cylinder is then examined in detail.

Ayoub, A.↗

NASA NTRS1976

An experimental study of the structure and acoustic field of a jet in a cross stream

The plane of symmetry of a high speed circular jet was surveyed to measure the mean and turbulent velocity fields by using constant temperature hot wire anemometry. The intensity of the noise radiated from the jet was determined in the tunnel test section by utilizing the cross-correlation at a particular time delay between the signals of two microphones suitably located along a given direction. Experimental results indicate that the turbulent intensity inside the crossflow jet increases by a factor of (1 + 1/2) as compared to the turbulent intensity of the same jet under free conditions, with r indicating the ratio of the jet velocity by the cross stream velocity. The peak observed in the turbulence spectra obtained inside the potential core of the jet has a frequency that increases by the same factor with respect to the corresponding frequency measured in the case of the free jet. The noise radiated by the jet becomes more intense as the crossflow velocity increases. The measured acoustic intensity of the crossflow jet is higher than the value which would be expected from the increase of the turbulent intensity only.

Camelier, I.↗

NASA NTRS1975

An experimental study of the structure and acoustic field of a jet in a cross stream

The investigation reported is related to studies of the noise generated by a lifting jet in forward motion such as in the case of a V/STOL aircraft. The investigation involved experiments in a subsonic wind tunnel. The two-microphone cross-correlation method used for measuring the acoustic intensity provides data concerning the noise directly radiated from the source, practically free from any reflection effects. The theoretical basis of the two-microphone method is discussed along with the experimental apparatus, the characteristics of the flow inside the jet, and the features of the acoustic field.

Camelier, I.↗

NASA NTRS1975

Effects of friction and heat conduction on sound propagation in ducts

A theoretical formulation of the propagation of sound in a viscous and heat conducting medium is presented. The problem is reduced to the determination of two scalar potentials related to pressure and entropy fluctuations respectively, and a vector potential related to vorticity fluctuations. The particular case of a two-dimensional duct of constant width is thoroughly investigated in the low, high, and very high frequency ranges. It is shown that three distinct families of modes may propagate along the duct axis, namely, pressure, entropy, and vorticity dominated modes. Perturbation methods are used to study the variations of attenuation rates, phase velocities, and mode shapes, as a function of frequency and duct width.

Huerre, P.↗

NASA NTRS1975

Aerodynamic sound generation due to the interaction of an unsteady wake with a rigid surface

Some aspects of sound generation by the interaction between a wedge and the wake of a circular cylinder in a uniform incompressible stream are studied experimentally. There is a minimum separation distance between the cylinder and the wedge when a tone is first generated. As the separation distance increases beyond the minimum, the frequency increases and asymptotically approaches the frequency normally present in the free wake. The Strouhal number defined as the ratio fd/U where f is the frequency, d is the cylinder diameter and U the free-stream speed is found to be in general a function of the Reynolds number (based on d) and h/d, where h is the separation distance. The minimum distance is in general a function of the Reynolds number. Flow visualization studies show that considerable differences exist between the flow below the minimum separation distance and just above it.

Smith, C. A.↗

NASA NTRS1974

Aerodynamic design of a rotor blade for minimum noise radiation

An analysis of the aerodynamic design of a hovering rotor blade for obtaining minimum aerodynamic rotor noise has been carried out. In this analysis, which is based on both acoustical and aerodynamic considerations, attention is given only to the rotational noise due to the pressure fluctuations on the blade surfaces. The lift distribution obtained in this analysis has different characteristics from those of the conventional distribution. The present distribution shows negative lift values over a quarter of the span from the blade tip, and a maximum lift at about the midspan. Results are presented to show that the noise field is considerably affected by the shape of the lift distribution along the blade and that noise reduction of about 5 dB may be obtained by designing the rotor blade to yield minimum noise.

Karamcheti, K.↗

NASA NTRS1974

Rarefied gas dynamics; Proceedings of the Eighth International Symposium, Stanford University, Stanford, Calif., July 10-14, 1972

Recent studies in the theory of rarefied gases (kinetic theory, shock structure, molecular forces and interactions, evaporation and condensation, expansions and jets, flow past bodies, gas-solid interactions) are presented along with descriptions of numerous experiments in these areas. Some of the topics covered include: singular limits of solutions of Boltzmann's equations, the Boltzmann and Klimontovich formalisms with reference to turbulent resolution, higher-order kinetic theory for the Lorentz gas, intermolecular potentials from shock structure experiments, cooling of particles in aerosol beams, hypersonic-subsonic transition in spherically symmetric expanding flows, absolute velocity measurements in a rarefied gas flow by an ion time-of-flight technique, the product distribution of gas-solid reactions from absolute rate theory, and relaxation of a gas with internal degrees of freedom. Individual items are announced in this issue.

Karamcheti, K.↗

NASA NTRS1973

Propagation of plane waves in flow through a variable area duct

Duct geometry is an important factor that influences the transmission of sound in a duct. Nonconstant area produces variations in steady flow quantities through the duct, which can cause reflections of acoustic disturbances and the creation of standing wave patterns, and which can attenuate and disperse propagating waves. To study the problem, a second-order-accurate numerical method has been developed. The method of characteristics is used to solve the acoustic equations with the assumption of quasi-one-dimensional flow in the duct. Numerical results are presented over a broad range of frequencies. Low-frequency results are compared with approximate solutions for compact nozzles and high-frequency calculations are compared with results from the short-wave theory. The numerical results are also compared with an analytical solution of the acoustic equations for exponential horn sections with zero mean flow to further establish the validity of the numerical method.

King, L. S.↗

NASA NTRS1973

The role of jet stability in edgetone generation.

Consideration of the role of stability of the mean jet flow of an edgetone system in the edgetone operation. A brief description of the main features of the edgetone operation and a brief review of the pertinent background are presented. This is followed by a discussion of the inadequacy of parallel flow stability considerations in explaining edgetone features. An analysis is made of the stability characteristics of a slightly nonparallel jet flow, and the role of jet stability based on these considerations in the edgetone operation is discussed. It is shown that the characteristics obtained by considering the nonparallel nature of the jet flowfield lead to a satisfactory description of the phenomenon, including a frequency selection criterion based on the concept of the most amplified disturbance frequency at each edge position.

Woolley, J. P.↗