Engineering Papers⌕ Search

Engineering topics

Kalaga, Kaushik

Publications and source records attributed to Kalaga, Kaushik.

Apparent Increasing Lithium Diffusion Coefficient with Applied Current in Graphite

In this study, we assert that the apparent lithium diffusion coefficient in graphite active particles in the negative electrodes of lithium-ion cells increases appreciably with the intercalation rate. This assertion is based on an electrochemical model analysis of a wide range of electrochemical micro-reference electrode full cell studies on a coated natural graphite and other literature results. Although the mechanism for this increase is a subject of further investigation, the results of our study suggest that the lithium transport in the graphite does not limit the maximum attainable charging rate in typical lithium-ion cells for electric vehicles.

25 ENERGY STORAGE↗

Insights on the cycling behavior of a highly-prelithiated silicon–graphite electrode in lithium-ion cells

Nanosized silicon materials are being developed for use in the anodes of high-energy lithium-ion batteries. However, the high surface areas of these materials increase the rate of parasitic reactions in the electrode, which consume cyclable Li + and degrade battery performance. Prelithiation offers a realistic strategy to compensate for this reactivity, by injecting additional charge into the cell to counterbalance the Li + loss. Interestingly, the benefits offered by prelithiation extend beyond its more obvious purpose. Here, by using a reference electrode in NMC532//Si–Gr cells, we show how prelithiation alters the cycling potentials experienced by the Si-containing anode and how that translates into gains in cycle life. The rate of consumption of the prelithiated charge is lower than that expected from the behavior of non-prelithiated cells. Curiously, the Si particles become partially unresponsive during the C/3 cycling apparently because of kinetic constraints. Electrochemical studies on harvested electrodes in half-cells show that capacities are intact after the long-term cycling and that most of the lithium reservoir is still present in the anode. We conclude that the high capacity retention displayed by the prelithiated cells mainly results from a higher participation of graphite particles during the extended electrochemical cycling.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Insights from incorporating reference electrodes in symmetric lithium-ion cells with layered oxide or graphite electrodes

Symmetric cells provide complementary means to probe electrochemical processes in lithium-ion batteries. Here, positive and negative electrodes harvested from conventional oxide/graphite cells are cross-paired, and the assembled reference-electrode-bearing symmetric cells are cycled/aged. For graphite symmetric cells, the electrode potentials and impedances remain nearly constant during calendar aging and the parasitic currents are typically small. However, at higher cell voltages when the “positive” graphite potential exceeds 1.0 V vs. Li/Li + , the capacity loss is higher, indicating that even a mild (but prolonged) overdischarge can damage the SEI. For the layered-oxide symmetric cells there are strong parasitic currents and a persistent slide of the electrode potential over time during calendar aging. Significant cell impedance rise, especially at higher hold voltages, is also observed. Curiously, the impedance rise in the “negative” oxide electrode, which experiences potentials below 4.0 V vs. Li/Li + , is greater than in the “positive” oxide electrode that experiences much higher potentials. We postulate that electrolyte oxidation is responsible for the behavior of these oxide symmetric cells, as it supplies electrons (that bind more Li + into the cathode, causing the potential slide) and protons (that contribute to impedance rise). Furthermore, these insights can guide the development of future lithium-ion cell chemistries.

25 ENERGY STORAGE↗

Dehydration Rather Than HF Capture Explains Performance Improvements of Li-Ion Cells by Ceramic Nanoparticles

Instability of nickel-rich layered oxides at high voltages is an impediment to their wider use in Li-ion batteries. HF generated via LiPF 6 hydrolysis accelerates corrosion, further destabilizing the material. Ceramic particles are believed to interfere with this corrosion by scavenging HF. Furthermore, we show that the likely mechanism is, in fact, disruption of the hydrolytic cycle due to adsorption of water on ceramic particles, of which MgO performed the best. We suggest that hydrolysis prevention rather than post factum remediation of hydrolytic damage makes a more efficient strategy for protection of the high-voltage cathodes.

25 ENERGY STORAGE↗

Fast Charging of Li-Ion Cells: Part I. Using Li/Cu Reference Electrodes to Probe Individual Electrode Potentials

Increasing the charge rate of Li-ion cells over 1–2C (full charge in 30–60 min) would be highly desirable, but high currents flowing through the active materials push these cells to their endurance limits. In this article, we aim to understand how such high-current regimes affect electrochemical properties of the cells. Formation of Li metal deposits is a recognized hazard of high-rate charging, as Li plating can overtake lithium intercalation in the negative electrode. Here we demonstrate how microprobe Li/Cu reference electrodes can be used to characterize the graphite anode and layered oxide (NCM523) cathode during constant-current (≤ 6C) voltage-limited (4.39 V) charging of Li-ion cells. These reference electrodes are used to monitor the onset of Li plating conditions in situ during cell charging. As the current increases over 3C, the anode potentials decrease below -40 mV causing lithium nucleation. Surprisingly, this nucleation (at least, initially) does not result in capacity fade or a higher anode impedance even in strongly polarized cells, so it appears that the nascent Li nuclei are isolated from electrolyte by the pre-existing solid electrolyte interphase. Our study shows that microprobe reference electrodes are an important diagnostic tool to characterize full-cell behavior in the high-current regimes.

25 ENERGY STORAGE↗

Operando Quantification of (De)Lithiation Behavior of Silicon-Graphite Blended Electrodes for Lithium-Ion Batteries

Due to the high lithium capacity of silicon, the composite (blended) electrodes containing silicon (Si) and graphite (Gr) particles are attractive alternatives to the all-Gr electrodes used in conventional lithium-ion batteries. In this Communication, the lithiation and delithiation in the Si and Gr particles in a 15 wt% Si composite electrode is quantified for each component using energy dispersive X-ray diffraction. This quantification is important as the components cycle in different potential regimes, and interpretation of cycling behavior is complicated by the potential hysteresis displayed by Si. The lithiation begins with Li alloying with Si; lithiation of Gr occurs at later stages when the potential dips below 0.2 V (all potentials are given vs. Li/Li + ). In the 0.2 – 0.01 V range, the relative lithiation of Si and Gr is ~58% and 42%, respectively. During delithiation, Li + ion extraction occurs preferentially from Gr in the 0.01 – 0.23 V range and from Si in the 0.23 – 1.0 V range; that is, the delithiation current is carried sequentially, first by graphite and then by silicon. Furthermore, these trends can be used for rational selection of electrochemical cycling windows that limits volumetric expansion in Si particles, thereby extending cell life.

25 ENERGY STORAGE↗

Lithium Acetylide: A Spectroscopic Marker for Lithium Deposition During Fast Charging of Li-Ion Cells

Rapid charging of lithium-ion batteries being developed for electric vehicles is a formidable challenge. Electrochemical polarization of cells during fast charging favors deposition of metallic Li onto the surface of the graphite electrode, and this Li plating compromises safety and accelerates performance degradation. Observing the onset of Li nucleation is essential for elucidation of mechanisms and defining conditions favoring this Li plating, but presently available methods are not sufficiently sensitive and selective while also allowing satisfactory spatial resolution. We demonstrate the use of Raman spectroscopy as a sensitive means to identify Li nucleation and map Li deposition. Metallic Li is detected indirectly by probing the vibrations in an acetylide species (represented as Li—C≡C—X) that is formed on the exposed surface of Li nuclei in contact with the solid electrolyte interphase on graphite. Surface-enhanced Raman scattering (SERS) involving this species on Li nuclei appears to dramatically increase sensitivity and selectivity of this detection, making our method an excellent complement to the existing spectroscopy and microscopy approaches for determining Li deposition.

25 ENERGY STORAGE↗

Calendar-life versus cycle-life aging of lithium-ion cells with silicon-graphite composite electrodes

The use of blended silicon-graphite (Si-Gr) negative electrodes increases the energy density of lithium-ion cells over those containing only graphite (Gr) electrodes. However, volume changes in the Si particles that occur during cycling causes deterioration of the solid-electrolyte interphase (SEI) layer on the particles resulting in further electrolyte reduction that immobilizes Li+ ions and, therefore, capacity fade. Because the volume changes are not expected to occur during a potentiostatic hold (referred to as calendar-life aging), by comparison of cycle-life and calendar-life aged cells one can expect to assess the role of volume changes in the deterioration of cell performance. To this end, cells with Si-Gr and Gr negative electrodes (and Li 1.03 (Ni 0.5 Co 0.2 Mn 0.3 ) 0.97 O 2 containing positive electrodes) were assembled, tested, and compared using cycle-life and calendar-life aging protocols. As expected, the capacity loss of the cycle-life aged cells was higher than that of the calendar-life aged cells. However, the measurable capacity loss for the calendar-life aged cells indicated continued immobilization of Li + ions. Furthermore, electrolytes extracted from the calendar-life aged cells showed more LiPF 6 hydrolysis products than those extracted from the cycle-life aged cells. In conclusion, we discuss possible mechanistic causes for the observed aging behaviors in this article.

25 ENERGY STORAGE↗

Auger Electrons as Probes for Composite Micro- and Nano- structured Materials: Application to Solid Electrolyte Interphases in Graphite and Silicon-Graphite Electrodes

In this study, Auger electron spectroscopy (AES) combined with ion sputtering profilometry, Xray photoelectron spectroscopy (XPS), and scanning electron microscopy (SEM) have been used in a complementary fashion to examine chemical and microstructural changes in graphite (Gr) and silicon/graphite (Si/Gr) blends contained in the negative electrodes of lithium-ion cells. We demonstrate how AES can be used to characterize morphology of the solid-electrolyte interphase (SEI) deposits in such heterogeneous media, complementing well-established methods, such as XPS and SEM. In this way we demonstrate that the SEI does not consist of uniformly thick layers on the graphite and silicon; the thickness of the SEI layers in cycle-life aged electrodes follows an exponential distribution with a mean of ca. 13 nm for the graphite and ca. 20-25 nm for the silicon nanoparticles (with a crystalline core of 50-70 nm in diameter). Furthermore, a “sticky-sphere” model, in which Si nanoparticles are covered with a layer of polymer binder (that is replaced by the SEI during cycling) of variable thickness is introduced to account for the features observed.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Graphene as an atomically thin interface for growth of vertically aligned carbon nanotubes

Growth of vertically aligned carbon nanotube (CNT) forests is highly sensitive to the nature of the substrate. This constraint narrows the range of available materials to just a few oxide-based dielectrics and presents a major obstacle for applications. Using a suspended monolayer, we show here that graphene is an excellent conductive substrate for CNT forest growth. Furthermore, graphene is shown to intermediate growth on key substrates, such as Cu, Pt, and diamond, which had not previously been compatible with nanotube forest growth. We find that growth depends on the degree of crystallinity of graphene and is best on mono- or few-layer graphene. The synergistic effects of graphene are revealed by its endurance after CNT growth and low contact resistances between the nanotubes and Cu. Our results establish graphene as a unique interface that extends the class of substrate materials for CNT growth and opens up important new prospects for applications.

CONDENSED-MATTER PHYSICS↗