Engineering Papers⌕ Search

Engineering topics

Jones, W. R.

Publications and source records attributed to Jones, W. R..

15 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Description, characteristics and testing of the NASA airborne radar

Presented here is a description of a coherent radar scattermeter and its associated signal processing hardware, which have been specifically designed to detect microbursts and record their radar characteristics. Radar parameters, signal processing techniques and detection algorithms, all under computer control, combine to sense and process reflectivity, clutter, and microburst data. Also presented is the system's high density, high data rate recording system. This digital system is capable of recording many minutes of the in-phase and quadrature components and corresponding receiver gains of the scattered returns for selected spatial regions, as well as other aircraft and hardware related parameters of interest for post-flight analysis. Information is given in viewgraph form.

Jones, W. R.↗
NASA NTRS1989

Airborne Doppler radar flight experiments for the detection of microbursts

In the interest of aviation safety, NASA and the FAA are jointly conducting research to determine the applicability of airborne, coherent Doppler radar techniques to detect early microburst in wind shear conditions during aircraft takeoff and landing. Researchers have developed a computer model of the radar which predicts its response when viewing a simulated microburst against the simulated clutter background of an airport, the so-called radar microburst ground clutter model. Studies employing this model revealed that Doppler radar can accurately detect microburst ahead of the aircraft in time for pilot evasive response, but flight experiments will be required for complete performance evaluation of the system. An experimental X band radar is being developed for future flight experiments to verify the simulation modeling results. A description of the experimental radar, recording equipment, and its installation on the NASA 515 aircraft is presented. The flight experiments to be conducted are also described.

Blume, Hans-J. C.↗
NASA NTRS1988

Airborne Doppler radar detection of low altitude windshear

NASA and the FAA, as part of a joint research effort aimed at the development of airborne sensor technology for low altitude windshear detection during aircraft takeoffs and landings, are giving attention to the potential usefulness of a microwave Doppler radar operating at X-band or above. A preliminary feasibility study was conducted with a microburst/clutter/radar simulation program. It is found that, using bin-to-bin automatic gain control, clutter filtering, limited detection range, and suitable antenna tilt, the windshear generated from a high-moisture microburst can be detected with 10-65 sec of warning time.

Bracalente, E. M.↗
NASA NTRS1986

A computer modeling methodology and tool for assessing design concepts for the Space Station Data Management System

A computer modeling tool is being developed to assess candidate designs for the Space Station Data Management System (DMS). The DMS is to be a complex distributed computer system including the processor, storage devices, local area networks, and software that will support all processing functions onboard the Space Station. The modeling tool will allow a candidate design for the DMS, or for other subsystems that use the DMS, to be evaluated in terms of parameters. The tool and its associated modeling methodology are intended for use by DMS and subsystem designers to perform tradeoff analyses between design concepts using varied architectures and technologies.

Jones, W. R.↗
NASA NTRS1986

Space station data management system assessment methodology

A computer-aided modeling tool and methodology was developed and is currently being used to assess candidate designs for the Space Station Data Management System (DMS). The DMS will be a complex distributed computer system including processors, storage devices, local area networks, and software that will support all processing functions on board the Space Station. The methodology produces assessments of the performance, reliability, cost, and physical attributes of the candidate designs. This paper describes the architecture and design of the modeling tool and presents the modeling methodology.

Jones, W. R.↗
NASA NTRS1984

Transportation - Space Station interfaces

A study aimed at identifying conceptual mechanisms for the transfer and manipulation of various masses in the vicinity of or on the Space Station is presented. These transfers encompass mass transfers involved in the arrivals or departures of various vehicles including the Shuttle, Orbital Manuever Vehicles (OMVs), and Orbital Transfer Vehicles (OTVs); point-to-point mass transfer of a nonroutine nature around the Space Station; and routine transfer of cargo and spacecraft around the Space Station, including the mating and processing of OMVs, OTVs, propellants, and payloads.

Macconchie, Ian O.↗
NASA NTRS1983

Preliminary results of the comparison of the electrochemical behavior of a thioether and biphenyl

An electrochemical cell was constructed to explore the feasibility of using electrochemical techniques to simulate the tribochemistry of various substances. The electrochemical cell was used to study and compare the behavior of a thioether 1,3-bis(phenylthio) benzene and biphenyl. It is found that under controlled conditions biphenyl undergoes a reversible reduction to a radical anion whereas the thioether undergoes an irreversible reduction yielding several products. The results are discussed in relationship to boundary lubrication.

Morales, W.↗
NASA NTRS1982

Tribological characteristics of nitrogen (N+) implanted iron

The effect of implantation of nitrogen ions (1.5 MeV) on the friction and wear characteristics of pure ion sliding against M-50 steel (unimplanted) was studied in a pin-on-disk sliding friction apparatus. Test conditions included room temperature (25 C), a dry air atmosphere, a load of 1/2 kg (4.9 N), sliding velocities of 0.043 to 0.078 m/sec (15 to 25 rpm), a pure hydrocarbon lubricant (n-hexadecane), or a U.S.P. mineral oil and nitrogen ion implantation doses of 5x10 to the 15th power and 5x10 to the 17th power ions/sq cm. No differences in wear rates were observed in the low dose experiments. In the high dose experiments, small reductions in initial (40 percent) and steady state (20 percent) wear rates were observed for nitrogen implanted iron riders as compared with unimplanted controls. No differences in average friction coefficients were noted for either dose. Auger electron spectroscopy combined with argon ion bombardment revealed a subsurface Gaussian nitrogen distribution with a maximum concentration of 6 atomic percent at a depth of 0.8 microns. Similar analysis within the wear scar of an implanted rider after 20 microns of wear yielded only background nitrogen concentration. No inward migration of nitrogen ions was observed.

Jones, W. R.↗
NASA NTRS1981

Effect of gamma irradiation on the friction and wear of ultrahigh molecular weight polyethylene

The effect of sterilization gamma irradiation on the friction and wear properties of ultrahigh molecular weight polyethylene (UHMWPE) sliding against stainless steel 316L in dry air at 23 C is investigated, the results to be used in the development of artificial joints which are to surgically replace diseased human joints. A pin-on-disk sliding friction apparatus is used, a constant sliding speed in the range 0.061-0.27 m/s is maintained, a normal load of 1 kgf is applied with dead weight, and the irradiation dose levels are: 0, 2.5, and 5.0 Mrad. Wear and friction data and conditions for each of the ten tests are summarized, and include: (1) wear volume as a function of the sliding distance for the irradiation levels, (2) incremental wear rate, and (3) coefficient of friction as a function of the sliding distance. It is shown that (1) the friction and wear properties of UHMWPE are not significantly changed by the irradiation doses of 2.5 and 5.0 Mrad, (2) the irradiation increases the amount of insoluble gel as well as the amount of low molecular weight material, and (3) after run-in the wear rate is either steady or gradually decreases as a function of the sliding distance.

Jones, W. R.↗
NASA NTRS1980

Driver gas flow with fluctuations

A shock tube's driver gas can apparently provide flow with turbulent bursts. The fluctuations are interpreted using a boundary layer model of contact surface flow and results form a kinetic theory of turbulence. With this, a lower limit of 4 on the ratio of maximum to minimum turbulent intensities in contact surface instabilities has been estimated.

Johnson, J. A., III↗
NASA NTRS1980

Analysis of wear-debris from full-scale bearing fatigue tests using the ferrograph

The ferrograph was used to determine the types and quantities of wear particles generated during full-scale bearing fatigue tests. Deep-groove ball bearings made from AISI 52100 steel were used. A MIL-L-23699 tetraester lubricant was used in a recirculating lubrication system containing a 49 mm absolute filter. Test conditions included a maximum Hertz stress of 2.4 GPa, a shaft speed of 15,000 rpm, and a lubricant supply temperature of 74 C (165 F). Four fatigue failures were detected by accelerometers in this test set. In general, the ferrograph was more sensitive (up to 23 hr) in detecting spall initiation than either accelerometers or the normal spectrographic oil analysis. Four particle types were observed: normal rubbing wear particles, spheres, nonferrous particles, and severe wear (spall) fragments.

Jones, W. R.↗
NASA NTRS1980

Recommendations for the NASA Avionics program for the 1980's

NASA is examining the merits of a significant expansion of its avionics, controls, and human factors technology program for the 1980's. The rationale for an expanded program is related to two factors. One factor is related to a utilization of recent and anticipated significant advances in microelectronics. The second factor is the need to develop new concepts in avionics and control systems for more efficient aircraft operation and better utilization of extremely limited airport capacity. Substantial benefits could be realized in three major categories, including improved aircraft efficiency, improved flight operations, and improved/extended operational capability. The NASA Avionics, Controls, and Human Factors Technology Plan is the report of a task force of agency personnel working in close cooperation with industry, DOD, and FAA. Attention is given to the NASA role, aircraft controls, crew station technology, flight management, integration and interfacing, commercial transports, general aviation, rotorcraft, V/STOL, and high performance aircraft.

Spitzer, C. R.↗
NASA NTRS1979

Infrared analysis of polyethylene wear specimens using attenuated total reflection spectroscopy

Attenuated total reflection infrared spectroscopy was used to analyze ultrahigh molecular weight polyethylene wear test specimens. Three different specimens were analyzed. One specimen was gamma irradiated to a dose of 5.0 MRad, another to a dose of 2.5 MRad, and the final specimen was unirradiated. There was no conclusive evidence of chemical changes (i.e., unsaturation or oxidation) in the surface regions of any of the polyethylene samples. Therefore, it was concluded that the gamma irradiation sterilization procedure shoud not alter the boundary lubricating properties of the polyethylene.

Jones, W. R.↗
NASA NTRS1974

Pressure-viscosity measurements for several lubricants to 5.5 x 10 to the 8th power Newtons per square meter (8 x 10 to the 4th psi) and 149 C (300 F)

A capillary viscometer was used to measure viscosity as a function of pressure, temperature, and shear stress for a number of lubricants. The conditions under which the measurements were made are specified. The results obtained for each material are analyzed. It was determined that all pressure-viscosity coefficients decreased with increasing temperature. Data from other techniques such as optical elastohydrodynamics, oscillating crystal, and low shear capillary viscometry were compared with the results obtained.

Jones, W. R.↗