Engineering Papers⌕ Search

Engineering topics

Johnson, W. A.

Publications and source records attributed to Johnson, W. A..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

Long-term microwave power drift of a cesium frequency standard and its effect on output frequency

It has been shown that the long-term frequency stability of a cesium (Cs) frequency standard is affected by variations in the standard's internal microwave power source. Studies were performed on a commercial Cs frequency standard for a period of 20 days, to determine the stability of its microwave power source. The results were then analyzed statistically, and the effects of microwave power drift on the standard's frequency stability were calculated.

Johnson, W. A.↗
NASA NTRS1985

The key to successful management of STS operations: An integrated production planning system

Space Transportation System operations managers are being confronted with a unique set of challenges as a result of increasing flight rates, the demand for flight manifest/production schedule flexibility and an emphasis on continued cost reduction. These challenges have created the need for an integrated production planning system that provides managers with the capability to plan, schedule, status and account for an orderly flow of products and services across a large, multi-discipline organization. With increased visibility into the end-to-end production flow for individual and parallel missions in process, managers can assess the integrated impact of changes, identify and measure the interrelationships of resource, schedule, and technical performance requirements and prioritize productivity enhancements.

Johnson, W. A.↗
NASA NTRS1984

Effects of tin on microstructure and mechanical behavior of Inconel 718

Columbium, for which the United States is 100 percent import reliant, is of strategic importance to the U.S. aerospace industry. A major amount of the Cb is used in Inconel 718. Should Cb sources be disrupted, it may be desired to use a grade of Cb melting stock having greater Sn content then the preferred vacuum rade. Additions of Sn to Inconel 718 were varied from none added to 1 wt %. The Sn additions below 800 ppm had no detrimental effects on 650 C stress rupture behavior; however, 1-wt % Sn severely degraded both life and ductility. Additions of Sn in excess of 200 ppm were slightly detrimental to the 425 C tensile yield strength and ductility. The Sn additions had no effect on the microstructure of Inconel 718 even after stress rupture testing for over 6000 hr at 650 C.

Dreshfield, R. L.↗
NASA NTRS1977

Development of an integrated configuration management/flight director system for piloted STOL approaches

A system analysis method for the development of an integrated configuration management/flight director system for IFR STOL approaches is presented. Curved descending decelerating approach trajectories are considered. Considerable emphasis is placed on satisfying the pilot centered requirements (acceptable workload) as well as the usual guidance and control requirements (acceptable performance). The Augmentor Wing Jet STOL Research Aircraft was utilized to allow illustration by example, and to validate the analysis procedure via manned simulation.

Hoh, R. H.↗
NASA NTRS1974

Analysis of vortex wake encounter upsets

The problem of an airplane being upset by encountering the vortex wake of a large transport on takeoff or landing is currently receiving considerable attention. This report describes the technique and results of a study to assess the effectiveness of automatic control systems in alleviating vortex wake upsets. A six-degree-of-freedom nonlinear digital simulation was used for this purpose. The analysis included establishing the disturbance input due to penetrating a vortex wake from an arbitrary position and angle. Simulations were computed for both a general aviation airplane and a commercial jet transport. Dynamic responses were obtained for the penetrating aircraft with no augmentation, and with various command augmentation systems, as well as with human pilot control. The results of this preliminary study indicate that attitude command augmentation systems can provide significant alleviation of vortex wake upsets; and can do it better than a human pilot.

Johnson, W. A.↗
NASA NTRS1974

Configuration management during transition for a powered lift STOL aircraft

Presented in this paper are the analytical and moving-base simulation results of a study to improve flight safety and operations of V/STOL type aircraft. One of the more significant and novel aspects of the work accomplished has been the concept and implementation of a configuration management flight control system designed to take the guesswork out of, and improve the operational safety of, transition flight in the region from cruise to STOL.

Johnson, W. A.↗
NASA NTRS1973

Design of a flight director/configuration management system for piloted STOL approaches

The design and characteristics of a flight director for V/STOL aircraft are discussed. A configuration management system for piloted STOL approaches is described. The individual components of the overall system designed to reduce pilot workload to an acceptable level during curved, decelerating, and descending STOL approaches are defined. The application of the system to augmentor wing aircraft is analyzed. System performance checks and piloted evaluations were conducted on a flight simulator and the results are summarized.

Hoh, R. H.↗
NASA NTRS1973

Study of control system effectiveness in alleviating vortex wake upsets.

The problem of an airplane being upset by encountering the vortex wake of a large transport on takeoff or landing is currently receiving considerable attention. This paper describes the technique and results of a study to assess the effectiveness of automatic control systems in alleviating vortex wake upsets. A six-degree-of-freedom nonlinear digital simulation was used for this purpose. The analysis included establishing the disturbance input due to penetrating a vortex wake from an arbitrary position and angle. Simulations were computed for both a general aviation airplane and a commercial jet transport. Dynamic responses were obtained for the penetrating aircraft with no augmentation and with various command augmentation systems. The results of this preliminary study indicate that it is feasible to use an automatic control system to alleviate vortex encounter upsets.

Johnson, W. A.↗
NASA NTRS1972

Lifting-surface theory for calculating the loading induced on a wing by a flap

A method is described for using lifting-surface theory to obtain the pressure distribution on a wing with a trailing-edge flap or control surface. The loading has a logarithmic singularity at the flap edges, which may be determined directly by the method of matched asymptotic expansions. Expressions are given for the singular flap loading for various flap hinge line and side edge geometries, both for steady and unsteady flap deflection. The regular part of the flap loading must be obtained by inverting the lifting-surface-theory integral equation relating the pressure and the downwash on the wing: procedures are described to accomplish this for a general wing and flap geometry. The method is applied to several example wings, and the results are compared with experimental data. Theory and test correlate well.

Johnson, W. A.↗
NASA NTRS1972

Development of a category 2 approach system model

An analytical model is presented which provides, as its primary output, the probability of a successful Category II approach. Typical applications are included using several example systems (manual and automatic) which are subjected to random gusts and deterministic wind shear. The primary purpose of the approach system model is to establish a structure containing the system elements, command inputs, disturbances, and their interactions in an analytical framework so that the relative effects of changes in the various system elements on precision of control and available margins of safety can be estimated. The model is intended to provide insight for the design and integration of suitable autopilot, display, and navigation elements; and to assess the interaction of such elements with the pilot/copilot.

Johnson, W. A.↗
NASA NTRS1972

Determination of ILS category 2 decision height window requirements

A method for determining the appropriate longitudinal and lateral decision height dispersion limits for any airplane/control system combination during an instrument landing approach is presented. An example is worked out to clarify the steps required. It is shown that the current longitudinal decision height dispersion limits are well suited for a DC-8 with the example control system, but that the lateral limits are too loose to guarantee acceptable touchdowns with the example system subjected to recommended wind and shear disturbances.

Johnson, W. A.↗
NASA NTRS1972

Development of approach control system requirements with applications to a jet transport

The development of requirements for an approach control system and example applications to a jet transport aircraft are presented. The material is divided into a general discussion of approach control requirements, and a specific application resulting in the design of three alternative longitudinal controllers. The point of view taken is that the essential features of the system structure are the feedbacks themselves, their equalization, and their combinations to create control commands. Use is made of the fact that for sucessful systems the possible feedback structures are very limited. They derive primarily from guidance, control, and regulation demands; and secondarily from dynamic response characteristics desired by the pilot. From the systems view it is the satisfaction of these requirements that is important rather than the means automatic, manual, or hygrid manual/automatic approach systems.

Mcruer, D. T.↗
NASA NTRS1972

Application of an approach and landing system model to the space shuttle orbiter vehicle

An analytic model and procedure are described which can be used to estimate probability distributions of touchdown conditions, without utilizing a Monte Carlo simulation. Example applications are presented, including one-step and two-step flare strategies for the space shuttle orbiter. The computed probability distributions for the two-step flare are compared with the corresponding histograms from an independent Monte Carlo simulation of the same situation. The computed distributions are very good fits to the Monte-Carlo-generated histograms for pertinent longitudinal and lateral variables at three points (including touchdown) along the vehicle's final approach trajectory. The model, thus verified, has more inherent power for assessing the effects of system element changes than conventional Monte Carlo techniques.

Johnson, W. A.↗