Engineering Papers⌕ Search

Engineering topics

Johnson, J. R.

Publications and source records attributed to Johnson, J. R..

At least 73 records · Page 4

The NH3 spectrum in Saturn's 5 micron window

Spectra of Saturn's 5-micron window were obtained at the Infrared Telescope Facility on Mauna Kea, Hawaii. The spectra have a resolution of 1.2/cm, and some exhibit extremely low amounts of approximately 300-micron ppt telluric H2O. The Saturn spectra show absorptions by the 2nu2 band of NH3. Long-path laboratory comparison spectra of NH3 were acquired and show considerable deviations in intensity from theoretical predictions. The calibration of Saturn's observed NH3 features with the laboratory data gives 2.0 + or - 0.5 m-amagat of NH3 using the 2nu2 Q-branch at 5.32 microns. The R(1) and R(2) lines yield an abundance about 3 times greater. Absorptions outside the range of the Q-branch can be accounted for by solid NH3 of 10-20 microns equivalent path length. The origin of Saturn's 5-micron flux is mostly thermal with some admixture of solar reflected radiation. A depletion of Saturn's NH3 abundance below the solar value is indicated, but confirmation of this conclusion will require a better understanding of the atmospheric penetration depth at 5 microns and more rigorous modeling of the spectral line formation.

Bjoraker, G. L.↗

Full power level development of the Space Shuttle main engine

Development of the Space Shuttle main engine for nominal operation at full power level (109 percent rated power) is continuing in parallel with the successful flight testing of the Space Transportation System. Verification of changes made to the rated power level configuration currently being flown on the Orbiter Columbia is in progress and the certification testing of the full power level configuration has begun. The certification test plan includes the accumulation of 10,000 seconds on each of two engines by early 1983. Certification testing includes the simulation of nominal mission duty cycles as well as the two abort thrust profiles: abort to orbit and return to launch site. Several of the certification tests are conducted at 111 percent power to demonstrate additional safety margins. In addition to the flight test and development program results, future plans for life demonstration and engine uprating will be discussed.

Johnson, J. R.↗

The 1.7- to 4.2-micron spectrum of asteroid 1 Ceres - Evidence for structural water in clay minerals

A high-resolution Fourier spectrum (1.7-3.5 microns) and medium-resolution spectrophotometry (2.7-4.2 microns) were obtained for Asteroid 1 Ceres. The presence of the 3-micron absorption feature due to water of hydration was confirmed. The 3-micron feature is compared with the 3-micron bands due to water of hydration in clays and salts. It is concluded that the spectrum of Ceres shows a strong absorption at 2.7-2.8 microns due to structural OH groups in clay minerals. The dominant minerals on the surface of Ceres are therefore hydrated clay minerals structurally similar to terrestrial montmorillonites. There is also a narrow absorption feature at 3.1 microns which is attributable to a very small amount of water ice on Ceres. This is the first evidence for ice on the surface of an asteroid.

Lebofsky, L. A.↗

Space Shuttle main engine progress through the first flight

A system overview is presented for the Space Shuttle Main Engine (SSME), and extensive performance comparisons are made with the Saturn V booster powerplant showing (1) staged-combustion turbopump pressures of 7,500 vs 1,100 psi for the Saturn V first stage; (2) a specific impulse of 455 vs 300; (3) power density of 100 vs 20 hp/lb; and (4) chamber pressures of 3200 vs 1000 psia. An account is then given of the SSME testing program, engine certification process and flight aboard the Space Shuttle Columbia, with attention to anomalies detected during flight in turbopump operation and mixture ratio sensor function.

Johnson, J. R.↗

Spectrophotometry and upper limit of gaseous CH4 for Triton

Spectra of Triton with a CCD spectrometer yielded a relative spectral reflectivity curve from 0.56 to 1.05 micron at a resolution of 25 A. Using low-temperature band model parameters from Fink et al. (1980), an upper limit for the one-way path gaseous CH4 abundance of 1 m-am was derived.

Johnson, J. R.↗

Deposition and material response from Mach 0.3 burner rig combustion of SRC 2 fuels

Collectors at 1173K (900 C) were exposed to the combustion products of a Mach 0.3 burner rig fueled with various industrial turbine liquid fuels from solvent refined coals. Four fuels were employed: a naphtha, a light oil, a wash solvent and a mid-heavy distillate blend. The response of four superalloys (IN-100, U 700, IN 792 and M-509) to exposure to the combustion gases from the SRC-2 naphtha and resultant deposits was also determined. The SRC-2 fuel analysis and insights obtained during the combustion experience are discussed. Particular problems encountered were fuel instability and reactions of the fuel with hardware components. The major metallic elements which contributed to the deposits were copper, iron, chromium, calcium, aluminum, nickel, silicon, titanium, zinc, and sodium. The deposits were found to be mainly metal oxides. An equilibrium thermodynamic analysis was employed to predict the chemical composition of the deposits. The agreement between the predicted and observed compounds was excellent. No hot corrosion was observed. This was expected because the deposits contained very little sodium or potassium and consisted mainly of the unreactive oxides. However, the amounts of deposits formed indicated that fouling is a potential problem with the use of these fuels.

Santoro, G. J.↗

Detection of a CH4 atmosphere on Pluto

A ratio spectrum of Pluto shows methane absorption bands at 6200, 7200, 7900, 8400, 8600, 8900, and 10,000 A. The heavy saturation of the 8900 band as compared to the other bands indicates a gaseous origin for the observed absorptions. A total methane abundance of 80 + or - 20 m-am is derived, and an upper limit to the total pressure of approximately .05 atm is set. The methane atmosphere would be stable if the mass of Pluto is increased 50% over its present value and its radius is 1400 km. A heavier gas mixed with the methane atmosphere would also aid its stability.

Fink, U.↗

Update on the development of the Space Shuttle main engine /as of June 20, 1978/

During the last year, significant progress was made toward the development of the Space Shuttle Main Engine which will provide propulsion for the Space Shuttle Orbiter Vehicle. Component and subsystem testing was conducted at the Rocketdyne Santa Susana Field Laboratory on combustion devices, turbomachinery, and the engine POGO suppression system. Engine testing continued at the National Space Technology Laboratories on both single engines and a three-engine cluster. As a result of these tests, hardware limitations were identified and design modifications were incorporated and evaluated by further testing. Current effort is being directed toward the delivery of the first flight engines and certification of the SSME for manned flight.

Johnson, J. R.↗

Update on development of the Space Shuttle main engine /as of 5 May 1977/

The development and testing of the Space Shuttle main engine are described. The preburners, main injector, main combustion chamber, and 35:1 expansion ratio test nozzle were successfully run at full power level (109 percent of rated power level). Integral combustion stability aids damped induced instability oscillations within 6 milliseconds. Three significant turbomachinery problems were identified and solved during the past year. These problems involved high-pressure fuel turbopump subsynchronous whirl, severe overheating of the turbine bearing and components and, in the high-pressure oxidizer turbopump, burning that first occurred in the drain cavity downstream of the primary oxidizer seal.

Johnson, J. R.↗

Inventory and monitoring of natural vegetation and related resources in an arid environment: A comprehensive evaluation of ERTS-1 imagery

The author has identified the following significant results. A vegetation classification, with 31 types and compatible with remote sensing applications, was developed for the test site. Terrain features can be used to discriminate vegetation types. Elevation and macrorelief interpretations were successful on ERTS photos, although for macrorelief, high sun angle stereoscopic interpretations were better than low sun angle monoscopic interpretations. Using spectral reflectivity, several vegetation types were characterized in terms of patterns of signature change. ERTS MSS digital data were used to discriminate vegetation classes at the association level and at the alliance level when image contrasts were high or low, respectively. An imagery comparison technique was developed to test image complexity and image groupability. In two stage sampling of vegetation types, ERTS plus high altitude photos were highly satisfactory for estimating kind and extent of types present, and for providing a mapping base.

Schrumpf, B. J.↗

Small scale photo probability sampling and vegetation classification in southeast Arizona as an ecological base for resource inventory

The author has identified the following significant results. The broad scale vegetation classification was developed for a 3,200 sq mile area in southeastern Arizona. The 31 vegetation types were derived from association tables which contained information taken at about 500 ground sites. The classification provided an information base that was suitable for use with small scale photography. A procedure was developed and tested for objectively comparing photo images. The procedure consisted of two parts, image groupability testing and image complexity testing. The Apollo and ERTS photos were compared for relative suitability as first stage stratification bases in two stage proportional probability sampling. High altitude photography was used in common at the second stage.

Johnson, J. R.↗

Inventory and monitoring of natural vegetation and related resources in an arid environment: A comparative evaluation of ERTS-1 imagery

The author has identified the following significant results. A comparative evaluation of an ERTS-1 MSS color reconstitution and an Apollo 6 and Gemini 4 color photograph for information content was conducted. A greater variety of image detail was indicated for the Apollo 6 imagery. A study of terrain feature variable-vegetation relationships has been concluded. However, there were no substantial differences among space photo types when macrorelief classes were interpreted. Vegetation distribution is influenced in varying degrees by characteristics of the terrain, some of which are quite apparent on ERTS-1 imagery and, therefore, provide the means for inferring possible vegetation types for a specified location. Spectral signatures have been determined for some natural vegetation systems from the ERTS-1 MSS data. Those signatures have been used to classify ERTS-1 data for a portion of the study area. Work continues on multistage sampling for natural vegetation, terrain feature identification of ERTS-1 photographs, plant phenology, and spectral signature studies.

Schrumpf, B. J.↗

Inventory and monitoring of natural vegetation and related resources in an arid environment

The author has identified the following significant results. A vegetation classification has been established for the test site (approx. 8300 sq km); 31 types are recognized. Some relationships existing among vegetation types and associated terrain features have been characterized. Terrain features can be used to discriminate vegetation types. Macrorelief interpretations on ERTS-1 imagery can be performed with greater accuracy when using high sun angle stereoscopic viewing rather than low sun angle monoscopic viewing. Some plant phenological changes are being recorded by the MSS system.

Schrumpf, B. J.↗

Oxidation and thermal fatigue of coated and uncoated NX-188 nickel-base alloy in a high velocity gas stream

A cast nickel-base superalloy, NX-188, coated and uncoated, was tested in a high-velocity gas stream for resistance to oxidation and thermal fatigue by cycling between room temperature and 980, 1040, and 1090 C. Contrary to the behavior of more conventional nickel-base alloys, uncoated NX-188 exhibited the greatest weight loss at the lowest test temperature. In general, on the basis of weight change and metallographic observations a coating consisting of vapor-deposited Fe-Cr-Al-Y over a chromized substrate exhibited the best overall performance in resistance to oxidation and thermal fatigue.

Johnson, J. R.↗

Inventory and analysis of natural vegetation and related resources from space and high altitude photography

A high altitude photomosaic resource map of Site 29 was produced which provided an opportunity to test photo interpretation accuracy of natural vegetation resource features when mapped at a small (1:133,400) scale. Helicopter reconnaissance over 144 previously selected test points revealed a highly adequate level of photo interpretation accuracy. In general, the reasons for errors could be accounted for. The same photomosaic resource map enabled construction of interpretive land use overlays. Based on features of the landscape, including natural vegetation types, judgements for land use suitability were made and have been presented for two types of potential land use. These two, agriculture and urbanization, represent potential land use conflicts.

Poulton, C. E.↗

Inventory of native vegetation and related resources from space photography

The application of space and high flight photography to vegetational resources in Arizona is discussed. Ecologically based vegetation-landform and land use maps are prepared. The use of material from the Apollo 9 flight and high flight aerial photography are discussed. Land uses that result in a conversion or strong modification of the natural vegetation are presented. The vegetation-landform units have an ecological basis and are meaningful from a land use point of view because they identify areas with unique potentials or limitations for use or development under various land uses. Examples of these relationships are given.

Poulton, C. E.↗