Engineering Papers⌕ Search

Engineering topics

Jefferson, D. C.

Publications and source records attributed to Jefferson, D. C..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2012

Navigation of the Twin GRAIL Spacecraft into Science Formation at the Moon

On February 29, 2012 the twin NASA Gravity Recovery And Interior Laboratory (GRAIL) spacecraft, Ebb and flow, achieved precise synchronized formation for collecting highly sensitive lunar gravity data. This was accomplished after performing a total of 27 propulsive maneuvers between the two spacecraft (13 on Ebb, 14 on Flow) over six months. Each 300 kg GRAIL spacecraft independently flew a 3.8-month, low-energy trajectory to reach the Moon after separation from the launch vehicle on September 10, 2011. The space craft were captured into 11.5 hr co- planar polar orbits after performing Lunar Orbit Insertion (LOI) maneuvers on New Years Eve (Dec 31, 2011) and New Years Day (Jan 1, 2012), respectively for Ebb, and Flow. Once captured, each spacecraft performed clusters of period reduction maneuvers to bring their orbit periods down to just less than 2 hrs. Finally, the orbiters we replaced into science formation by performing five strategic maneuvers (2 on Ebb, 3 on Flow). These maneuvers ensured 3 months of orbit life time with mean altitudes of 55 km and separations of 82-217 km by targeting the orbits' eccentricity vectors to specific locations. This paper will discuss the navigation strategy and performance of the twin GRAIL spacecraft from the September 10, 2011 launch through the end of the Prime Mission Science Phase in June 2012.

lunar gravity↗
NASA NTRS2008

Kaguya Orbit Determination from JPL

Selene (re-named 'Kaguya' after launch) is an unmanned mission to the Moon navigated, in part, by JPL personnel. Launched by an H-IIA rocket on September 14, 2007 from Tanegashima Space Center, Kaguya entered a high, Earth-centered phasing orbit with apogee near the radius of the Moon's orbit. After 19 days and two orbits of Earth, Kaguya entered lunar orbit. Over the next 2 weeks the spacecraft decreased its apolune altitude until reaching a circular, 100 kilometer altitude orbit. This paper describes NASA/JPL's participation in the JAXA/Kaguya mission during that 5 week period, wherein JPL provided tracking data and orbit determination support for Kaguya.

lunar navigation↗
NASA NTRS2004

JPL IGS Analysis Center Report, 2001-2003

Three GPS orbit and clock products are currently provided by JPL for consideration by the IGS. Each differs in its latency and quality, with later results being more accurate. Results are typically available in both IGS and GIPSY formats via anonymous ftp. Current performance based on comparisons with the IGS final products is summarized. Orbit performance was determined by computing the 3D RMS difference between each JPL product and the IGS final orbits based on 15 minute estimates from the sp3 files. Clock performance was computed as the RMS difference after subtracting a linear trend based on 15 minute estimates from the sp3 files.

Heflin, M. B.↗
NASA NTRS1999

Precise Clock Solutions Using Carrier Phase from GPS Receivers in the International GPS Service

As one of its activities as an Analysis Center in the International GPS Service (IGS), the Jet Propulsion Laboratory (JPL) uses data from a globally distributed network of geodetic-quality GPS receivers to estimate precise clock solutions, relative to a chosen reference, for both the GPS satellites and GPS receiver internal clocks, every day. The GPS constellation and ground network provide geometrical strength resulting in formal errors of about 100 p sec for these estimates. Some of the receivers in the global IGS network contain high quality frequency references, such as hydrogen masers. The clock solutions for such receivers are smooth at the 20-p sec level on time scales of a few minutes. There are occasional (daily to weekly) shifts at the microsec level, symptomatic of receiver resets, and 200-p sec-level discontinuities at midnight due to 1-day processing boundaries. Relative clock solutions among 22 IGS sites proposed as "fiducial" in the IGS/BIPM pilot project have been examined over a recent 4-week period. This allows a quantitative measure of receiver reset frequency as a function of site. For days and-sites without resets, the Allan deviation of the relative clock solutions is also computed for subdaily values of tau..

Zumberge, J. F.↗
NASA NTRS1997

Precise Point Positioning for the Efficient and Robust Analysis of GPS Data From Large Networks

Networks of dozens to hundreds of permanently operating precision Global Positioning System (GPS) receivers are emerging at spatial scales that range from 10(exp 0) to 10(exp 3) km. To keep the computational burden associated with the analysis of such data economically feasible, one approach is to first determine precise GPS satellite positions and clock corrections from a globally distributed network of GPS receivers. Then, data from the local network are analyzed by estimating receiver specific parameters with receiver-specific data; satellite parameters are held fixed at their values determined in the global solution. This "precise point positioning" allows analysis of data from hundreds to thousands of sites every day with 40 Mflop computers, with results comparable in quality to the simultaneous analysis of all data. The reference frames for the global and network solutions can be free of distortion imposed by erroneous fiducial constraints on any sites.

Zumberge, J. F.↗
NASA NTRS1997

Precise Point Positioning for the Efficient and Robust Analysis of GPS Data from Large Networks

Networks of dozens to hundreds of permanently operating precision Global Positioning System (GPS) receivers are emerging at spatial scales that range from 10(exp 0) to 10(exp 3) km. To keep the computational burden associated with the analysis of such data economically feasible, one approach is to first determine precise GPS satellite positions and clock corrections from a globally distributed network of GPS receivers. Their, data from the local network are analyzed by estimating receiver- specific parameters with receiver-specific data satellite parameters are held fixed at their values determined in the global solution. This "precise point positioning" allows analysis of data from hundreds to thousands of sites every (lay with 40-Mflop computers, with results comparable in quality to the simultaneous analysis of all data. The reference frames for the global and network solutions can be free of distortion imposed by erroneous fiducial constraints on any sites.

Zumberge, J. F.↗
NASA NTRS1996

A Test Of Precision GPS Clock Synchronization

This paper will describe tests of precision GPS time transfer using geodetic-quality TurboRogue receivers. The GPS data are processed with the GIPSY-OASIS II software, which simultaneously estimates the GPS satellite orbits and clocks, receiver locations and clock offsets, as well as other parameters such as earth orientation.

GPS GPS Clock Synchronization↗
NASA NTRS1994

Time and position accuracy using codeless GPS

The Global Positioning System has allowed scientists and engineers to make measurements having accuracy far beyond the original 15 meter goal of the system. Using global networks of P-Code capable receivers and extensive post-processing, geodesists have achieved baseline precision of a few parts per billion, and clock offsets have been measured at the nanosecond level over intercontinental distances. A cloud hangs over this picture, however. The Department of Defense plans to encrypt the P-Code (called Anti-Spoofing, or AS) in the fall of 1993. After this event, geodetic and time measurements will have to be made using codeless GPS receivers. However, there appears to be a silver lining to the cloud. In response to the anticipated encryption of the P-Code, the geodetic and GPS receiver community has developed some remarkably effective means of coping with AS without classified information. We will discuss various codeless techniques currently available and the data noise resulting from each. We will review some geodetic results obtained using only codeless data, and discuss the implications for time measurements. Finally, we will present the status of GPS research at JPL in relation to codeless clock measurements.

Dunn, C. E.↗