Engineering topics

Iversen, J. D.

Publications and source records attributed to Iversen, J. D..

33 records · Page 2

NASA NTRS1976

Windblown dust on earth, Mars and Venus

Attempts to predict threshold speeds for windblown dust and sand on Mars and Venus have raised new questions about the mechanism of soil and sand transport by wind. Estimates of threshold speeds on Mars and Venus are made including the effects of both Reynolds number and interparticle forces of cohesion. The current estimates show lower threshold speeds for small particles than previous estimates by Hess, who assumed that Reynolds number is the only important parameter. These estimates, on the other hand, show somewhat higher threshold speeds than those of Sagan and Bagnold, who assumed that the particles are cohesionless. An optimum particle size results, for which threshold speed is a minimum, contrary to Sagan and Bagnold's prediction.

Iversen, J. D.↗

NASA NTRS1976

Estimated grain saltation in a Martian atmosphere

Mariner 9 spacecraft images showing evidence of variable surface features and surface erosion resulting from atmospheric wind on Mars have caused a renewed interest in the eolian mechanics of saltating grains. To study this phenomenon, both experimental investigation in an atmospheric wind tunnel and numerical solutions of the equations of motion of a single grain under Martian surface conditions were conducted. The numerical solutions for earth were used and empirically adjusted to correlate with existing experimental data for Mars. These modified equations were then solved to estimate grain motion for Mars. These calculations show the importance of a lifting force on the grain to initiate motion in both earth and Mars calculations. Major findings include a comparison of earth and Mars grain trajectories that show Mars length scales to be longer and to fall with a higher terminal grain velocity. The grains in the Mars calculation also made a smaller collision angle with the surface on rebound.

White, B. R.↗

NASA NTRS1976

Saltation threshold on Mars - The effect of interparticle force, surface roughness, and low atmospheric density

Results are reported for wind-tunnel experiments performed to determine the threshold friction speed of particles with different densities. Experimentally determined threshold speeds are plotted as a function of particle diameter and in terms of threshold parameter vs particle friction Reynolds number. The curves are compared with those of previous experiments, and an A-B curve is plotted to show differences in threshold speed due to differences in size distributions and particle shapes. Effects of particle diameter are investigated, an expression for threshold speed is derived by considering the equilibrium forces acting on a single particle, and other approximately valid expressions are evaluated. It is shown that the assumption of universality of the A-B curve is in error at very low pressures for small particles and that only predictions which take account of both Reynolds number and effects of interparticle forces yield reasonable agreement with experimental data. Effects of nonerodible surface roughness are examined, and threshold speeds computed with allowance for this factor are compared with experimental values. Threshold friction speeds on Mars are then estimated for a surface pressure of 5 mbar, taking into account all the factors considered.

Iversen, J. D.↗

NASA NTRS1976

The effect of vertical distortion in the modeling of sedimentation phenomena - Martian crater wake streaks

Theoretical mass flow rate and the particle trajectory equations of motion of granular material in saltation are used to correlate experimental data for the rate of erosion in the wake regions of wind-tunnel-model Martian craters. Vertical geometric distortion is inherent in the simulation because of the equivalent roughness height characteristic of a turbulent boundary layer, which is affected by material in saltation. It is thus necessary to distort topographic model geometry in the vertical direction. A systematic similitude which is based on erosion rate and equivalent roughness in saltation is shown to correlate time-dependent model data as long as the model Reynolds number is higher than a critical value.

Iversen, J. D.↗

NASA NTRS1976

Correlation of turbulent trailing vortex decay data

A correlation function, derived on the basis of self-similar variable eddy-viscosity decay, is introduced and utilized to correlate aircraft trailing vortex velocity data from ground and flight experiments. The correlation function collapses maximum tangential velocity data from scale-model and flight tests to a single curve. The resulting curve clearly shows both the inviscid plateau and the downstream decay regions. A comparison between experimental data and numerical solution shows closer agreement with the variable eddy viscosity solution than the constant viscosity analytical solution.

Iversen, J. D.↗

NASA NTRS1975

Eolian erosion of the Martian surface. I - Erosion rate similitude

A similitude parameter is derived which is based on theoretical considerations of erosion due to sand in saltation. This parameter has been used to correlate wind tunnel experiments of particle flow over model craters. The characteristics of the flow field in the vicinity and downstream of a crater are discussed and it is shown that erosion is initiated in areas lying under a pair of trailing vortices. The erosion rate parameter is used to calculate erosion rates on Mars, reported in Part 2, to be published later.

Iversen, J. D.↗

NASA NTRS1975

Estimates of saltation threshold and erosion rates on Mars

The Mariner 9 photographs of the Martian surface include many which show crater-associated streaks caused by atmospheric winds. Due to the low density atmosphere of Mars, the wind speeds necessary to move surface particles and thus cause the streaks are apparently very high. The atmospheric-boundary-layer wind tunnel has been used to determine threshold speeds for particles of varying density and diameter and the results for small particles have been extrapolated to estimate somewhat lower threshold speeds on Mars than previous estimates. A series of streak modeling tests is used to derive an erosion-rate correlation function, which is in turn used to estimate erosion rates to the lee of some of the craters on Mars which exhibited time-dependent streak behavior during the mission.

Iversen, J. D.↗

NASA NTRS1975

Estimated grain saltation in a Martian atmosphere

The aeolian mechanics of saltating grains on Mars is studied using both an experimental investigation in an atmospheric wind tunnel and numerical solutions to the equations of motion of a single grain under Martian surface conditions. Numerical solutions for terrestrial conditions are empirically correlated with experimental data for Mars, and the modified equations are solved to estimate Martian grain motion. The calculations demonstrate the importance of a lifting force in initiating grain motion on both planets. It is found that Martian grain-trajectory length scales are longer than those on earth and fall with a higher terminal grain velocity. The wind-tunnel experiments show that saltating grains have an enhanced erosive capability in crater wakes. It is suggested that this enhanced capability may well explain the streaks associated with craters in certain regions on the Martian surface.

White, B. R.↗

NASA NTRS1975

Particle motion in atmospheric boundary layers of Mars and Earth

To study the eolian mechanics of saltating particles, both an experimental investigation of the flow field around a model crater in an atmospheric boundary layer wind tunnel and numerical solutions of the two- and three-dimensional equations of motion of a single particle under the influence of a turbulent boundary layer were conducted. Two-dimensional particle motion was calculated for flow near the surfaces of both Earth and Mars. For the case of Earth both a turbulent boundary layer with a viscous sublayer and one without were calculated. For the case of Mars it was only necessary to calculate turbulent boundary layer flow with a laminar sublayer because of the low values of friction Reynolds number; however, it was necessary to include the effects of slip flow on a particle caused by the rarefied Martian atmosphere. In the equations of motion the lift force functions were developed to act on a single particle only in the laminar sublayer or a corresponding small region of high shear near the surface for a fully turbulent boundary layer. The lift force functions were developed from the analytical work by Saffman concerning the lift force acting on a particle in simple shear flow.

White, B. R.↗

NASA NTRS1975

Inviscid to turbulent transition of trailing vortices

The plateau region in which trailing vortices initially exhibit slow decay of maximum tangential speed is demonstrated with the aid of constant and variable eddy viscosity models. The existence of the plateau is explained by the presence of the viscous core and by the necessity for transition of the initial, nearly inviscid profile to similarity far downstream. Span loading is shown to affect the initial maximum tangential speed as well as the duration of the plateau region. Triangular span loading is shown to present less hazard to trailing aircraft, at least in the near field, than elliptic loading because the inviscid profile for triangular loading exhibits a finite tangential speed at the vortex centerline and a large inviscid core.

Iversen, J. D.↗

NASA NTRS1974

Wind tunnel studies of Martian aeolian processes

In order to determine the nature of Martian aeolian processes, an investigation is in progress which involves wind tunnel simulations, geologic field studies, theoretical model studies, and analyses of Mariner 9 imagery; this report presents the preliminary results. Threshold speed experiments were conducted for particles ranging in relative density from 1.3 to 11.35 and diameter from 10.2 to 1290 microns to verify and better define Bagnold's (1941) expression for grain movement, particularly for low particle Reynolds numbers and to study the effects of aerodynamic lift and surface roughness. Wind tunnel simulations were conducted to determine the flow field over raised rim craters and associated zones of deposition and erosion.

Greeley, R.↗

NASA NTRS1974

Inviscid to turbulent transition of trailing vortices

The characteristics of the plateau region in the vortex system which trails from a lifting wing are discussed. The decay of the vortex due to viscous or turbulent shear is very slow in the plateau so that the maximum tangential speed in the vortices remains nearly constant for some distance downstream of roll-up and then begins to decrease, becoming inversely proportional to the square root of the distance downstream. Mathematical models are developed to analyze the structure of the plateau area. Solutions are obtained for both constant and variable eddy viscosity models.

Iversen, J. D.↗

NASA NTRS1974

Wind tunnel simulations of light and dark streaks on Mars

Wind tunnel experiments have revealed a characteristic flow field pattern over raised-rim craters which causes distinctive zones of aeolian erosion and deposition. Comparisons of the results with Mariner 9 images of Mars show that some crater-associated dark zones result from wind erosion and that some crater-associated light streaks are depositional.

Greeley, R.↗

NASA NTRS1974

Correlation of turbulent trailing vortex decay data

A correlation function, derived on the basis of self similar variable eddy viscosity decay, is introduced and utilized to correlate aircraft trailing vortex velocity data from ground and flight experiments. The correlation function collapses maximum tangential velocity data from scale model and flight tests to a single curve. The resulting curve clearly shows both the inviscid plateau and the downstream decay regions. A comparison between experimental data and numerical solution shows closer agreement with the variable eddy viscosity solution than the constant viscosity analytical solution.

Iversen, J. D.↗

NASA NTRS1973

Wind tunnel studies of Martian aeolian processes

Preliminary results are reported of an investigation which involves wind tunnel simulations, geologic field studies, theoretical model studies, and analyses of Mariner 9 imagery. Threshold speed experiments were conducted for particles ranging in specific gravity from 1.3 to 11.35 and diameter from 10.2 micron to 1290 micron to verify and better define Bagnold's (1941) expressions for grain movement, particularly for low particle Reynolds numbers and to study the effects of aerodynamic lift and surface roughness. Wind tunnel simulations were conducted to determine the flow field over raised rim craters and associated zones of deposition and erosion. A horseshoe vortex forms around the crater, resulting in two axial velocity maxima in the lee of the crater which cause a zone of preferential erosion in the wake of the crater. Reverse flow direction occurs on the floor of the crater. The result is a distinct pattern of erosion and deposition which is similar to some martian craters and which indicates that some dark zones around Martian craters are erosional and some light zones are depositional.

Greeley, R.↗