Engineering PapersSearch

Engineering topics

Ivan Bertaska

Publications and source records attributed to Ivan Bertaska.

The Flight Dynamics Risk Assessment of Artemis I

With launch vehicles and spacecraft, it is necessary to dynamically test the structure to validate structural models. These validated models are then used to determine a launch vehicle's control stability margin and the loads on the structure. While often a dedicated structural test article is used to correlate the integrated structure in preparation for the final analysis cycles, the Artemis I flight is using an approach where the components of the launch vehicle are dynamically tested and the component models validated. The fully integrated vehicle is not tested until a few months before launch, which limits the ability to fully correlate a model prior to launch. This paper introduces the Flight Dynamics Risk Assessment of the vehicle, which is the process being used to determine the adequacy of the vehicle structural model after the Integrated Modal Test. This work outlines the process of quickly tuning a model post-test then determining any control margin violations and increases in loads due to that tuned model.

Eric C Stewart

The Flight Dynamics Risk Assessment of Artemis I

With launch vehicles and spacecraft, it is necessary to dynamically test the structure to validate structural models. These validated models are then used to determine a launch vehicle's control stability margin and the loads on the structure. While often a dedicated structural test article is used to correlate the integrated structure in preparation for the final analysis cycles, the Artemis I flight is using an approach where the components of the launch vehicle are dynamically tested and the component models validated. The fully integrated vehicle is not tested until a few months before launch, which limits the ability to fully correlate a model prior to launch. This paper introduces the Flight Dynamics Risk Assessment of the vehicle, which is the process being used to determine the adequacy of the vehicle structural model after the Integrated Modal Test. This work outlines the process of quickly tuning a model post-test then determining any control margin violations and increases in loads due to the tuning of the model.

Eric C Stewart

Independent Verification and Validation for Artemis I Ascent Integrated Flight Performance Simulation

The NASA Engineering and Safety Center (NESC) has performed independent model development to support cross-model verification for the Space Launch System (SLS) Program since 2012 which culminated, for Artemis I, in a postflight reconciliation analysis of the Artemis I ascent trajectory (validation). This post-flight analysis was completed by both the NESC and the SLS Program. Upon successful completion of the Artemis I mission, multiple preflight simulations of the nominal ascent trajectory were updated with Day of Launch (DOL) conditions and simulated results were compared to reconstructed flight data derived from telemetry measurements. Dispersed trajectories were also produced using a combination of DOL conditions and preflight uncertainties, which ideally should bound the Artemis I flight data. Finally, multibody dynamics were simulated for some of the separation events to support clearance analyses. This paper focuses on validating and understanding the accuracy of the models by comparing simulated results against the Artemis I flight data. In addition, discrepancies uncovered between simulations led to opportunities to investigate areas for potential model improvement to refine preflight simulations for future Artemis missions. Included in this paper is background on the flight performance simulation tools, the postflight analysis approach, and a comparison of simulation results against the Artemis I flight data. Simulated results were found to generally be in close agreement with each other and the Artemis I flight data.

Jacob Fleck