Engineering Papers⌕ Search

Engineering topics

Hwang, C.

Publications and source records attributed to Hwang, C..

36 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

Adaptive flutter suppression, analysis and test

Methods of adaptive control have been applied to suppress a potentially violent flutter condition of a half-span model of a lightweight figher aircraft. This marked the confluence of several technologies with active flutter suppression, digital control and adaptive control theory the primary contributors. The control algorithm was required to adapt both to slowly varying changes, corresponding to changes in the flight condition or fuel loading and to rapid changes, corresponding to a store release or the transition from a stable to an unstable flight condition. The development of the adaptive control methods was followed by a simulation and checkout of the complete system and a wind tunnel demonstration. As part of the test, a store was released from the model wing tip, transforming the model abruptly from a stable configuration to a violent flutter condition. The adaptive algorithm recognized the unstable nature of the resulting configuration and implemented a stabilizing control law in a fraction of a second. The algorithm was also shown to provide system stability over a range of wind tunnel Mach numbers and dynamic pressures.

Johnson, E. H.↗
NASA NTRS1980

Wind tunnel test of a fighter aircraft wing/store flutter suppression system: An international effort

A 30% scale, half span model of a lightweight fighter aircraft with an active wing/store flutter suppression system was tested in the NASA Langley Research Center sixteen foot transonic dynamics tunnel. The test featured a store configuration that was intentionally designed to exhibit a violent flutter condition. In addition to Northrop organized control laws, three European countries also contributed control laws to stabilize this condition. After the control laws were mechanized by Northrop, they were tested at the Langley facility. The model was tested up to 170% of the open loop flutter dynamic pressure in a number of cases, with the indication that a substantially greater improvement was achievable. Some special features of the test model are discussed and the design and implementation of the control laws as well as the test monitoring techniques and results are presented.

Hwang, C.↗
NASA NTRS1979

Demonstration of aircraft wing/store flutter suppression systems

A wind tunnel test program was conducted to demonstrate the active wing/store flutter suppression systems on a lightweight fighter aircraft. The program, completed in mid-1978, included the design, analysis, fabrication, and testing of a scale model. The tests were conducted at the NASA Langley 16-ft Transonic Dynamics Tunnel. Three store configurations were selected for testing. Two of these configurations were deliberately designed to exhibit low flutter speeds with rapid reductions in damping at the incipient flutter condition. After initial tunnel entries, which showed the need for certain improvements in the model and the control system design, substantial increases in the flutter speeds were achieved using both leading- and trailing-edge control surfaces, separately. For the most critical configuration, a demonstrated improvement of 18% and a projected improvement of 29% in the dynamic pressure were achieved.

Hwang, C.↗
NASA NTRS1979

Some observations on the mechanism of aircraft wing rock

A scale model of the Northrop F-5A was tested in NASA Ames Research Center Eleven-Foot Transonic Tunnel to simulate the wing rock oscillations in a transonic maneuver. For this purpose, a flexible model support device was designed and fabricated, which allowed the model to oscillate in roll at the scaled wing rock frequency. Two tunnel entries were performed to acquire the pressure (steady state and fluctuating) and response data when the model was held fixed and when it was excited by flow to oscillate in roll. Based on these data, a limit cycle mechanism was identified, which supplied energy to the aircraft model and caused the Dutch roll type oscillations, commonly called wing rock. The major origin of the fluctuating pressures that contributed to the limit cycle was traced to the wing surface leading edge stall and the subsequent lift recovery. For typical wing rock oscillations, the energy balance between the pressure work input and the energy consumed by the model's aerodynamic and mechanical damping was formulated and numerical data presented.

Hwang, C.↗
NASA NTRS1979

Aircraft wake flow effect and horizontal tail buffet

As part of a program to investigate the fluctuating pressure distribution and response behavior of a fighter aircraft in transonic maneuver, an F-5A scale model has previously been tested in an 11-ft transonic wind tunnel. The model, with a number of static and dynamic pressure transducers imbedded in the lifting surfaces was tested at various angles of attack up to 16 deg. In this paper, test results of particular interest to wake flow and horizontal tail buffet are described. It is shown that the dynamic pressure data on the tail surface at the specified flight conditions serve to determine the local dynamic loads. They also influence the control performance of the aircraft under maneuver conditions where buffet is encountered. The data presented demonstrate a number of contributing factors that affect the tail dynamic pressures in the transonic regime.

Hwang, C.↗
NASA NTRS1978

Investigation of steady and fluctuating pressures associated with the transonic buffeting and wing rock of a one-seventh scale model of the F-5A aircraft

A wind tunnel test of a 1/7 scale F-5A model is described. The pressure, force, and dynamic response measurements during buffet and wing rock are evaluated. Effects of Mach number, angle of attack, sideslip angle, and control surface settings were investigated. The mean and fluctuating static pressure data are presented and correlated with some corresponding flight test data of a F-5A aircraft. Details of the instrumentation and the specially designed support system which allowed the model to oscillate in roll to simulate wing rock are also described. A limit cycle mechanism causing wing rock was identified from this study, and this mechanism is presented.

Hwang, C.↗
NASA NTRS1978

Some observations on the mechanism of aircraft wing rock

A pressure scale model of Northrop F-5A was tested in NASA Ames Research Center Eleven-Foot Transonic Tunnel to simulate the wing rock oscillations in a transonic maneuver. For this purpose, a flexible model support device was designed and fabricated which allowed the model to oscillate in roll at the scaled wing rock frequency. Two tunnel entries were performed to acquire the pressure (steady state and fluctuating) and response data when the model was held fixed and when it was excited by flow to oscillate in roll. Based on these data, a limit cycle mechanism was identified which supplied energy to the aircraft model and caused the Dutch roll type oscillations, commonly called wing rock. The major origin of the fluctuating pressures which contributed to the limit cycle was traced to the wing surface leading edge stall and the subsequent lift recovery. For typical wing rock oscillations, the energy balance between the pressure work input and the energy consumed by the model aerodynamic and mechanical damping was formulated and numerical data presented.

Hwang, C.↗
NASA NTRS1977

Separated-flow unsteady pressures and forces on elastically responding structures

Broadband rms, spectral density, and spatial correlation information that characterizes the fluctuating pressures and forces that cause aircraft buffet is presented. The main theme is to show the effects of elasticity. In order to do so, data are presented that were obtained in regions of separated flow on wings of wind-tunnel models of varying stiffness and on the wing of a full-scale aircraft. Reynolds number effects on the pressure fluctuations are also discussed.

Coke, C. F.↗
NASA NTRS1977

Separated-flow unsteady pressures and forces on elastically responding structures

Broadband rms, spectral density, and spatial correlation information that characterizes the fluctuating pressures and forces that cause aircraft buffet is presented. The main theme of the paper in describing buffet excitation is to show the effects of elasticity. Data are presented that were obtained in regions of separated flow on wings of wind-tunnel models of varying stiffness and on the wing of a full scale aircraft. Reynolds number effects on the pressure fluctuations are also discussed.

Coe, C. F.↗
NASA NTRS1975

Northrop F-5A aircraft transonic buffet pressure data acquisition and response analysis

Flight tests were performed on an extensively instrumented F-5A aircraft to investigate the dynamic buffet pressure distribution on the wing surfaces and the responses during a series of transonic maneuvers called the windup turns. The maneuvers were performed at three Mach number-altitude combinations with a constant q of approximately 14,360 N/sq m (300 psf). The fluctuating buffet pressure data at 24 stations on the right wing of the F-5A were acquired by miniaturized semiconductor type pressure transducers mounted on the wing. A new transducer mounting and wiring technique was applied where the interference with the natural flow condition was minimized. The data acquired in this manner were found adequate to trace the shock origin, the movement of the shock front and the development of the separated flow (shock-induced or leading-edge induced) on the wing surface. An analytical procedure, called a 'segmentwise stationary procedure', was introduced to compute the aircraft response spectra based on the measured buffet pressures. The analytical response data computed in this manner are correlated with the test response data obtained in the same flights.

Hwang, C.↗
NASA NTRS1975

Transonic buffet behavior of Northrop F-5A aircraft

Flight tests were performed on an extensively instrumented F-5A aircraft to investigate the dynamic buffet pressure distribution on the wing surfaces and the responses during a series of transonic maneuvers called the windup turns. The maneuvers to maximum lift were performed at three Mach number-altitude combinations with a constant 'q' of approximately 14,360 N/sq m (300 psf). The fluctuating buffet pressure data at 24 stations on the right wing of the F-5A were acquired by miniaturized semiconductor type pressure transducers mounted on the wing. A new transducer mounting and wiring technique was applied where the interference with the natural flow condition was minimized. The data acquired in this manner were found adequate to trace the shock origin, the movement of the shock front and the development of the separated flow (shock induced or leading edge induced) on the wing surface.

Hwang, C.↗
NASA NTRS1974

Transonic buffet behavior of Northrop F-5A aircraft

Flight tests were performed on an F-5A aircraft to investigate the dynamic buffet pressure distribution on the wing surfaces and the responses during a series of transonic maneuvers called wind-up turns. The conditions under which the tests were conducted are defined. The fluctuating buffet pressure data on the right wing of the aircraft were acquired by miniaturized semiconductor-type pressure transducers flush mounted on the wing. Processing of the fluctuating pressures and responses included the generation of the auto- and cross-power spectra, and of the spatial correlation functions. An analytical correlation procedure was introduced to compute the aircraft response spectra based on the measured buffet pressures.

Hwang, C.↗
NASA NTRS1973

Investigation of Vibrational Energy Transfer in Connected Structures

The results are reported of an analytical and experimental investigation on the vibrational energy transfer between connected substructures under random excitation. In the analytical area, the basic foundation and assumptions of the statistical energy analysis (SEA) method, a major tool in random response analysis of structures, were examined and reviewed. A new SEA formulation based on the strong coupling condition of the substructures was carried out and presented. Also presented were the results of vibration energy transfer study based on the wave equations applied to connected structures. In the experimental phase, three simple structural models were fabricated and tested. Additional tests were performed on selected substructures which formed parts of the test models. The test results were presented and evaluated against the analytical data.

Hwang, C.↗