Engineering topics
Publications and source records attributed to Huston, Steven W..
Computer-controlled system tests metal-oxide/semiconductor field-effect transistors (MOSFET's) at high voltages and currents. Measures seven parameters characterizing performance of MOSFET, with view toward obtaining early indication MOSFET defective. Use of test system prior to installation of power MOSFET in high-power circuit saves time and money.
Relay switch withstands currents of several hundred kiloamperes and potentials of several hundred volts modified to decrease its contact resistance.
Electronic load-bank circuit provides pulsed or continuous low-resistance load to imitate effect of short circuit on Ni/H2 or other electrochemical power cells. Includes safety/warning feature and taps for measurement of cell-output voltage and current.
Circuit designed for measurement of dc current-versus-voltage characteristics of semiconductor devices. Operates in conjunction with x-y pen plotter or digital storage oscilloscope, which records data. Includes large feedback resistors to prevent high currents damaging device under test. Principal virtues: low cost, simplicity, and compactness. Also used to evaluate diodes and transistors.
High-voltage 10-bit digital-to-analog converter operates under computer control to put out voltages up to 500 V at currents up to 35 mA. Circuit includes high-voltage power supply used to generate high-voltage square wave at frequency set by computer at value between 0.2 Hz and 10 Hz. Used to drive 0.02-microfarad, 1-kV capacitor at slewing rate of 1 V/microsecond to provide signal for robotic imaging system.
Welding-current indicator made of surface-mounted components on flexible circuit board. Holds variety of components on surface. After assembly, flexible circuit wrapped to fit around transformer core. Surface-mounted devices make it unnecessary to drill holes in circuit board to accommodate component leads. Use of small surface-mounted devices result in lightweight, compact indicator circuit.
Light flashes on to indicate high current. Simple, inexpensive display circuit indicates when 3,000-A welding current flows in welding gun. Onset of welding current induces voltage and current in 1,000-turn, 28-gauge copper-wire coil. Single-transistor amplifier amplifies induced current, energizing light-emitting diode (LED) connected to collector of transistor. Light from LED gives simple, direct indication of welding current.
Use of ground-fault interrupters in 480-Vac power supplies of portable resistance welding machines proposed. Enhances safety and quality of welds by detecting damage in long power cable to portable resistance welder.
Inexpensive, compact, battery-powered, eight-channel spectrometer produces 8-bit digital data in each channel and records data for subsequent reconstruction in analog form or for transmission to computer for analysis. Unit designed for use in analysis of rocket-exhaust plumes. Modified versions of spectrometer used to analyze combustion in boilers or gas turbines.
Electronic motor-speed control circuit designed to operate in electrically noisy environment. Includes optoelectronic pick-up device, placed inside motor housing to provide speed feedback signal. Automatically maintains speed motor at commanded value. Measures speed of motor in terms of frequency of pulses of infrared light chopped by fan blades of motor. Difference between measured and commanded speeds serves as control signal for external amplifier driving motor. Major advantage of circuit is low cost.