Engineering Papers⌕ Search

Engineering topics

Hurley, D. M.

Publications and source records attributed to Hurley, D. M..

14 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2019

The Young Age of the LAMP-Observed Frost in Lunar Polar Cold Traps

The Lunar Reconnaissance Orbiter/Lyman Alpha Mapping Project (LAMP) ultraviolet instrument detected a 0.5–2% icy regolith mix on the floor of some of the southern pole permanently shadowed craters of the Moon. We present calculations indicating that most or all of this icy regolith detected by LAMP (sensed to a depth of <1 μm) has to be relatively young—less than 2,000 years old—due to the surface erosional loss by plasma sputtering (external ionized gas‐surface interactions), meteoric impact vaporization, and meteoric impact ejection. These processes, especially meteoric impact ejection, will disperse water along the crater floor, even onto warm regions where it will then undergo desorption. We have determined that there should be a water exosphere over polar craters (e.g., like Haworth crater) and calculated that a model 40‐km‐diameter crater should emit ~10(exp 19) H2O per second into the exosphere in the form of free molecules and ice‐embedded particulates.

Farrell, W. M.↗
NASA NTRS2018

Solar Wind Implantation Into the Lunar Regolith: Monte Carlo Simulations of H Retention in a Surface With Defects and the H2 Exosphere

The solar wind implants protons into the top 20–30 nm of lunar regolith grains, and the implanted hydrogen will diffuse out of the regolith but also interact with oxygen in the regolith oxides. We apply a statistical approach to estimate the diffusion of hydrogen in the regolith hindered by forming temporary bonds with regolith oxygen atoms. A Monte Carlo simulation was used to track the temporal evolution of bound OH surface content and the H2 exosphere. The model results are consistent with the interpretation of the Chandrayaan‐1 M3 observations of infrared absorption spectra by surface hydroxyls as discussed in Li and Milliken (2017, https://doi.org/10.1126/sciadv.1701471). The model reproduced the latitudinal concentration of OH by using a Gaussian energy distribution of f(U(sub 0) = 0.5 eV, U(sub W) = 0.078–0.1 eV) to characterize the activation energy barrier to the diffusion of hydrogen in space weathered regolith. In addition, the model results of the exospheric content of H2 are consistent with observations by the Lyman Alpha Mapping Project on the Lunar Reconnaissance Orbiter. Therefore, we provide support for hydroxyl formation by chemically trapped solar wind protons.

Tucker, O. J.↗
NASA NTRS2018

Solar Wind Implantation into Lunar Regolith II: Monte Carlo Simulations of Hydrogen Retention in a Surface with Defects and the Hydrogen (H, H2) Exosphere

Recently, the near-infrared observations of the OH veneer on the lunar surface by the Moon Mineralogy Mapper (M3) have been refined to constrain the OH content to 500-750 parts per million (ppm). The observations indicate diurnal variations in OH up to 200 ppm possibly linked to warmer surface temperatures at low latitude. We examine the M3 observations using a statistical mechanics approach to model the diffusion of implanted H in the lunar regolith. We present results from Monte Carlo simulations of the diffusion of implanted solar wind H atoms and the subsequently derived H and H2 exospheres.

Exosphere↗
NASA NTRS2017

The Statistical Mechanics of Solar Wind Hydroxylation at the Moon, Within Lunar Magnetic Anomalies, and at Phobos

We present a new formalism to describe the outgassing of hydrogen initially implanted by the solar wind protons into exposed soils on airless bodies. The formalism applies a statistical mechanics approach similar to that applied recently to molecular adsorption onto activated surfaces. The key element enabling this formalism is the recognition that the interatomic potential between the implanted H and regolith-residing oxides is not of singular value but possess a distribution of trapped energy values at a given temperature, F(U,T). All subsequent derivations of the outward diffusion and H retention rely on the specific properties of this distribution. We find that solar wind hydrogen can be retained if there are sites in the implantation layer with activation energy values exceeding 0.5eV. We especially examine the dependence of H retention applying characteristic energy values found previously for irradiated silica and mature lunar samples. We also apply the formalism to two cases that differ from the typical solar wind implantation at the Moon. First, we test for a case of implantation in magnetic anomaly regions where significantly lower-energy ions of solar wind origin are expected to be incident with the surface. In magnetic anomalies, H retention is found to be reduced due to the reduced ion flux and shallower depth of implantation. Second, we also apply the model to Phobos where the surface temperature range is not as extreme as the Moon. We find the H atom retention in this second case is higher than the lunar case due to the reduced thermal extremes (that reduces outgassing).

Solar Wind↗
NASA NTRS2016

Grain-Scale Supercharging and Breakdown on Airless Regoliths

Interactions of the solar wind and emitted photoelectrons with airless bodies have been studied extensively. However, the details of how charged particles interact with the regolith at the scale of a single grain have remained largely uncharacterized. Recent efforts have focused upon determining total surface charge under photoemission and solar wind bombardment and the associated electric field and potential. In this work, theory and simulations are used to show that grain-grain charge differences can exceed classical sheath predictions by several orders of magnitude, sometimes reaching dielectric breakdown levels. Temperature-dependent electrical conductivity works against supercharging by allowing current to leak through individual grains; the balance between internal conduction and surface charging controls the maximum possible grain-to-grain electric field. Understanding the finer details of regolith grain charging, conductive equilibrium, and dielectric breakdown will improve future numerical studies of space weathering and dust levitation on airless bodies.

airless↗
NASA NTRS2016

The Gas-Surface Interaction of a Human-Occupied Spacecraft with a Near-Earth Object

NASA's asteroid redirect mission (ARM) will feature an encounter of the human-occupied Orion spacecraft with a portion of a near- Earth asteroid (NEA) previously placed in orbit about the Moon by a capture spacecraft. Applying a shuttle analog, we suggest that the Orion spacecraft should have a dominant local water exosphere, and that molecules from this exosphere can adsorb onto the NEA. The amount of adsorbed water is a function of the defect content of the NEA surface, with retention of shuttle-like water levels on the asteroid at 10(exp 15) H2O's/m2 for space weathered regolith at T approximately 300 K.

Asteroid↗
NASA NTRS2015

LADEE Science Results and Implications for Exploration

NASA's Lunar Atmosphere and Dust Environment Explorer, LADEE, concluded a fully successful investigation of the Moon's tenuous gas and dust atmosphere on April 18, 2014. LADEE hosted three science instruments to address atmospheric and dust objectives, and a technology demonstration of deep-space optical communication. The three science instruments were an ultraviolet-visible spectrometer (UVS), a neutral mass spectrometer (NMS), and a lunar dust experiment (LDEX). All data acquired by these instruments have been submitted to the Planetary Data System. A mission overview and science instrument descriptions are readily available. LADEE inserted into a low-altitude, retrograde lunar orbit optimized for observations at the sunrise terminator, where surface temperatures rise abruptly. LADEE also carried out observations over a wide range of local times and altitudes. Here we describe some of the initial results.

LADEE↗
NASA NTRS2014

Solar Wind Implantation into Lunar Regolith: Hydrogen Retention in a Surface with Defects

Solar wind protons are implanted directly into the top 100 nm of the lunar near-surface region, but can either quickly diffuse out of the surface or be retained, depending upon surface temperature and the activation energy, U, associated with the implantation site. In this work, we explore the distribution of activation energies upon implantation and the associated hydrogen-retention times; this for comparison with recent observation of OH on the lunar surface. We apply a Monte Carlo approach: for simulated solar wind protons at a given local time, we assume a distribution of U values with a central peak, U(sub c) and width, U(sub w), and derive the fraction retained for long periods in the near-surface. We find that surfaces characterized by a distribution with predominantly large values of U (greater than 1 eV) like that expected at defect sites will retain implanted H (to likely form OH). Surfaces with the distribution predominantly at small values of U (less than 0.2 eV) will quickly diffuse away implanted H. However, surfaces with a large portion of activation energies between 0.3 eV less than U less than 0.9 eV will tend to be H-retentive in cool conditions but transform into H-emissive surfaces when warmed (as when the surface rotates into local noon). These mid-range activation energies give rise to a diurnal effect with diffusive loss of H at noontime.

regolith↗
NASA NTRS2012

Redistribution of Lunar Polar Water to Mid-latitudes and its Role in Forming an OH veneer - Revisited

We suggest that energization processes like ion sputtering and impact vaporization can eject/release polar water molecules residing within lunar cold trapped regions with sufficient velocity to allow their redistribution to mid-latitudes. We consider the possibility that these polar-ejected molecules can be an additional (but not dominant) contribution to the water/OH veneer observed as a 3 micron absorption feature at mid-latitudes by Chandrayaan-I, Cassini, and EPOXI. Taking the conservative case that polar water is ejected only from the floor of polar craters with an 0.1 % icy regolith then overall source rates are near 10(exp 18) H20s/s. This outflow amounts to approx 10(exp -7) kg/s of water to be ejected from each pole and is a water source rate that is 10(exp .5 lower than the overall exospheric source rate for all species. Hence, the out-flowing polar water is a perturbation in the overall exosphere composition & dynamics. This polar water 'fountain' model may not fully account for the relatively high concentrations in the mid-latitude water veneer observed in the IR (approx 10-1000 ppm). However, it may account for some part of the veneer. We note that the polar water fountain source rates scale linearly with ice concentration, and larger mass fractions of polar crater water should provide correspondingly larger fractions of water emission out of the poles which then 'spills' on to mid-latitude surfaces.

Farrell, W. M.↗
NASA NTRS2011

The Effect on the Lunar Exosphere of a Coroual Mass Ejection Passage

Solar wind bombardment onto exposed surfaces in the solar system produces an energetic component to the exospheres about those bodies. The solar wind energy and composition are highly dependent on the origin of the plasma. Using the measured composition of the slow wind, fast wind, solar energetic particle (SEP) population, and coronal mass ejection (CME), broken down into their various components, we have estimated the total sputter yield for each type of solar wind. We show that the heavy ion component, especially the He++ and 0+7 can greatly enhance the total sputter yield during times when the heavy ion population is enhanced. Folding in the flux, we compute the source rate for several species during different types of solar wind. Finally, we use a Monte Carlo model developed to simulate the time-dependent evolution of the lunar exosphere to study the sputtering component of the exosphere under the influence of a CME passage. We simulate the background exosphere of Na, K, Ca, and Mg. Simulations indicate that sputtering increases the mass of those constituents in the exosphere a few to a few tens times the background values. The escalation of atmospheric density occurs within an hour of onset The decrease in atmospheric density after the CME passage is also rapid, although takes longer than the increase, Sputtered neutral particles have a high probability of escaping the moon,by both Jeans escape and photo ionization. Density and spatial distribution of the exosphere can be tested with the LADEE mission.

Killen, R. M.↗
NASA NTRS2011

Space Environmental Erosion of Polar Icy Regolith

While regions at the floors of permanently shadowed polar craters are isolated from direct sunlight, these regions are still exposed to the harsh space environment, including the interplanetary Lyman-a background, meteoric impacts, and obstacle-affected solar wind. We demonstrate that each of these processes can act to erode the polar icy regolith located at or near the surface along the crater floor. The Lyman-a background can remove/erode the icy-regolith via photon stimulated desorption [1], meteoric impacts can vaporize the regolith [2], and redirected solar wind ions can sputter the ice-regolith mix [3]. As an example we shall examine in detail the inflow of solar wind ions and electrons into polar craters, One might expect such ions to flow horizontally over the crater top (see Figure). However, we find that plasma ambipolar processes act to deflect passing ions into the craters [3]. We examine this plasma process and determine the ion flux as a function of position across a notional crater floor. We demonstrate that inflowing solar wind ions can indeed create sputtering along the crater floor, effectively eroding the surface. Erosion time scales rrom sputtering will be presented. We shall also consider the effect of impact vaporization on buried icy-regolith regions. There will also be a discussion of solar wind electrons that enter into the PSR, demonstrating that these also have the ability rree surface-bound atoms via electron stimulated desorption processes [l].

Farrell, William M.↗
NASA NTRS2010

Observations of the Lunar Impact Plume from the LCROSS Event

We observed emission from sodium (Na) ejected from the Lunar Crater Observing and Sensing Satellite (LCROSS) impact into Cabeus Crater on October 9, 2009, using the McMath-Pierce telescope. In our 88 sq km field of view, we saw on the order of2 g of Na in the first 9 minutes after the LCROSS impact. A comparison of our observed Na above the limb with simulations that assume a gas temperature of 1000 K indicates that 0.5-2.6 (1.5 +/- 1) kg of Na were released during the LCROSS impact. Lower temperatures would result in a lower total sodium release. The model of an isotropic expanding cloud best reproduces the observations.

Killen, R. M.↗