Engineering topics

Hung, R. J.

Publications and source records attributed to Hung, R. J..

At least 73 records · Page 4

NASA NTRS1991

Remote sensing of mesospheric and thermospheric density perturbations induced by subtropical heavy rainfalls for spacecraft environment study

The simultaneous measurements of VHF radar and HF Doppler array systems are used to observe three-dimensional wind speeds and gravity waves with the purpose of determining the density perturbations at different heights of mesosphere and thermosphere induced by the convective motions associated with subtropical heavy rainfall during the time period of the raining season. Frequency, horizontal wavelength, vertical wavelength, and phase velocity of the gravity waves are determined from the Fourier power spectral analysis of horizontal and vertical wind velocities. The results are compared with those of density perturbations caused by typhoons, tropical storms, and winter-time drizzles associated with convective motions. It is shown that the maximum amplitude of the density perturbations caused by the gravity waves is +/- 10 pct which is greater than that of density perturbations caused by gravity waves associated with weak convective motions in winter time and is smaller than that caused by the gravity waves associated with tropical storms.

Hung, R. J.↗

NASA NTRS1991

Response of gravity level fluctuations on the Gravity Probe-B Spacecraft propellant system

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled fluids in a rotating dewar under microgravity environment have been investigated. Results show that there is a group of wave trains, both in longitudinal and transverse modes, with various frequencies and wavelengths of slosh waves generated by the restoring force field of gravity jitters and centrifugal forces in this study. The longest wave periods of slosh waves, either the longitudinal or transverse modes, are responsible for the production of wave modes with highest ratio of maximum wave amplitude to wavelength. Also, the lower frequency slosh waves are the wave modes with higher wave energy than that of the higher frequency slosh waves.

Hung, R. J.↗

NASA NTRS1991

Gravity jitter response slosh wave excitation on the fluid in a rotating dewar

The present study investigates the dynamical behavior of fluids, in particular, the effect of surface tension on partially filled fluids in a rotating dewar in a microgravity environment. It is shown that there is a group of wave trains, both in longitudinal and transverse modes, with various frequencies and wavelengths of slosh waves generated by the restoring field force field of gravity jitters and centrifugal forces. The longest wave periods of slosh waves, either the longitudinal or transverse modes, are found to be responsible for the production of wave modes with the highest ratio of maximum wave amplitude to wavelength. The lower frequency slosh waves are the wave modes with higher wave energy than that of the higher frequency slosh waves.

Hung, R. J.↗

NASA NTRS1991

Gravity jitter effected slosh waves and the stability of a rotating bubble under microgravity

The instability of liquid and gas interface can be induced by the pressure of longitudinal and lateral accelerations, vehicle vibration, and rotational fields of spacecraft in a microgravity environment. Characteristics of slosh waves excited by the restoring force field of gravity jitters have been investigated. Results show that lower frequency gravity jitters excite slosh wave with higher ratio of maximum amplitude to wave length than that of the slosh waves generated by the higher frequency gravity jitters.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation in the gravity probe-B spacecraft propulsion system

The dynamical behavior of fluids in a Gravity Probe-B Spacecraft tank imposed by various frequencies of gravity jitters have been investigated. Fluid stress distribution also have been investigated. Results show that fluid stress distribution exerted on the outer and inner walls of rotating dewar are closely related to the characteristics of slosh waves excited on the liquid-vapor interface in the rotating dewar tank.

Hung, R. J.↗

NASA NTRS1991

Cryogenic liquid resettlement activated by impulsive thrust in space-based propulsion system

The purpose of present study is to investigate most efficient technique for propellant resettling through the minimization of propellant usage and weight penalties. Comparison between the constant reverse gravity acceleration and impulsive reverse gravity acceleration to be used for the activation of propellant resettlement, it shows that impulsive reverse gravity thrust is superior to constant reverse gravity thrust for liquid reorientation in a reduced gravity environment. Comparison among impulsive reverse gravity thrust with 0.1, 1.0 and 10 Hz frequencies for liquid filled level in the range between 30 to 80 percent, it shows that the selection of 1.0 Hz frequency impulsive thrust over the other frequency ranges of impulsive thrust is most proper based on the present study.

Hung, R. J.↗

NASA NTRS1991

Gravity jitters excited slosh waves in rotating propellant tank under microgravity environment

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full-scale Gravity Probe-B Spacecraft propellant tank without probe imposed by various frequencies of gravity jitters have been investigated. Results disclose the conditions for the excitation of large amplitude slosh waves which shall be avoided in the design of cryogenic liquid propellant system.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation in a partially filled rotating tank due to gravity jitters in a microgravity environment

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor), in a full-scale Gravity Probe-B Spacecraft propellant tank without probe imposed by various frequencies of gravity jitters have been investigated. Twelve case studies of slosh wave excitation due to various frequencies of gravity jitters under different rotating speeds of propellant tank and different levels of background gravity environment have been numerically simulated. Results disclose the conditions for the excitation of large amplitude slosh waves which shall be avoided in the design of cryogenic liquid propellant system.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation of cryogenic liquid helium in gravity Probe-B rotating dewar

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full scale Gravity Probe-B Spacecraft propellant dewar tank imposed by various frequencies of gravity jitters have been investigated. Fluid stress distribution, caused by the excitation of slosh waves and their associated large amplitude disturbances on the liquid-vapor interface, exerted on the outer and inner walls of rotating dewar container also have been investigated. Results show that fluid stress distribution exerted on the outer and inner walls of rotating dewar are closely related to the characteristics of slosh waves excited on the liquid-vapor interface in the rotating dewar tank.

Hung, R. J.↗

NASA NTRS1991

Gravity jitter excited cryogenic liquid slosh waves in microgravity environment

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full-scale Gravity Probe-B Spacecraft liquid helium container tank without probe imposed by various frequencies of gravity jitter have been investigated. Results disclose the conditions for the excitation of large amplitude slosh waves which should be avoided in the design of cryogenic liquid propellant system.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation due to cryogenic liquid reorientation in space-based propulsion system

The objective of the cryogenic fluid management of the spacecraft propulsion system is to develop the technology necessary for acquistion or positioning of liquid and vapor within a tank in reduced gravity to enable liquid outflow or vapor venting. In this study slosh wave excitation induced by the resettling flow field activated by 1.0 Hz medium frequency impulsive reverse gravity acceleration during the course of liquid fluid reorientation with the initiation of geyser for liquid filled levels of 30, 50, and 80 percent have been studied. Characteristics of slosh waves with various frequencies excited are discussed.

Hung, R. J.↗

NASA NTRS1991

Cryogenic liquid resettlement activated by impulsive thrust in space-based propulsion system

The purpose of present study is to investigate the most efficient technique for propellant resettling through the minimization of propellant usage and weight penalties. Comparison between the constant reverse gravity acceleration and impulsive reverse gravity acceleration to be used for the activation of propellant resettlement shows that impulsive reverse gravity thrust is superior to constant reverse gravity thrust for liquid reorientation in a reduced gravity environment. Comparison among impulsive reverse gravity thrust with 0.1, 1.0, and 10 Hz frequencies for liquid-filled level in the range between 30 to 80 percent shows that the selection of a medium frequency of 1.0 Hz impulsive thrust over the other frequency ranges of impulsive thrust is the most proper.

Hung, R. J.↗

NASA NTRS1990

Microgravity liquid propellant management

The requirement to settle or to position liquid fluid over the outlet end of a spacecraft propellant tank prior to main engine restart, poses a microgravity fluid behavior problem. Resettlement or reorientation of liquid propellant can be accomplished by providing optimal acceleration to the spacecraft such that the propellant is reoriented over the tank outlet without any vapor entrainment, any excessive geysering, or any other undersirable fluid motion for the space fluid management under microgravity environment. The most efficient technique is studied for propellant resettling through the minimization of propellant usage and weight penalties. Both full scale and subscale liquid propellant tank of Space Transfer Vehicle were used to simulate flow profiles for liquid hydrogen reorientation over the tank outlet. In subscale simulation, both constant and impulsive resettling acceleration were used to simulate the liquid flow reorientation. Comparisons between the constant reverse gravity acceleration and impulsive reverse gravity acceleration to be used for activation of propellant resettlement shows that impulsive reverse gravity thrust is superior to constant reverse gravity thrust.

Hung, R. J.↗

NASA NTRS1990

Stability and slosh wave for rotating bubble due to gravity-jitters under microgravity

Time-dependent fluid behaviors in microgravity environments are examined with particular attention given to the dynamics of bubble configurations. The initial bubble profiles, computed from the steady-state formulation, are used as the initial input for the time dependent computation. The parameters considered are liquid density and its kinematic viscosity, gas density and its kinematic viscosity, surface tension coefficient, angular velocity, and gravity environment. This computer algorithm can be used to simulate the fluid behavior in a microgravity environment, in particular the excitation of slosh waves due to different frequencies of gravity jitters. Results show that lower-frequency gravity jitters excite slosh waves with a higher ratio of maximum amplitude to wave length than that of the slosh waves generated by the higher frequency gravity jitters.

Hung, R. J.↗

NASA NTRS1990

Gravity wave initiated convection

The vertical velocity of convection initiated by gravity waves was investigated. In one particular case, the convective motion-initiated and supported by the gravity wave-induced activity (excluding contributions made by other mechanisms) reached its maximum value about one hour before the production of the funnel clouds. In another case, both rawinsonde and geosynchronous satellite imagery were used to study the life cycles of severe convective storms. Cloud modelling with input sounding data and rapid-scan imagery from GOES were used to investigate storm cloud formation, development and dissipation in terms of growth and collapse of cloud tops, as well as, the life cycles of the penetration of overshooting turrets above the tropopause. The results based on these two approaches are presented and discussed.

Hung, R. J.↗

NASA NTRS1990

Cryogenic liquid hydrogen reorientation activated by constant reverse gravity acceleration of geyser initiation

A key objective for cryogenic fluid management in a spacecraft propulsion system is development of the technology necessary for acquisition or positioning of liquid outflow or vapor venting. Numerical simulation of positive liquid acquisition is attempted by introducing a reverse gravity acceleration from the propulsive thrust of auxiliary engines which exceeds critical value for the initiation of a geyser. Based on the computer simulation of flow fields during the course of fluid reorientation, six dimensionless parameters resulted. These parameters hold near-constant values through the entire range of liquid filled levels, from 30 to 80 percent, during the course of fluid reorientation.

Hung, R. J.↗

NASA NTRS1990

Superfluid and normal fluid helium II in a rotating tank under low and microgravity environments

The physical behavior of superfluid and normal fluid helium II is discussed. It is shown that the centrifugal force due to a rotating container can never separate the superfluid from the normal fluid helium in a large rotating cylindrical spacecraft. A classical approach is appropriate for treating superfluid and normal fluid cryogenic helium as a mixture without separation in a large rotating cylinder in a spacecraft propellant systems.

Hung, R. J.↗

NASA NTRS1990

Characteristics and performance of the variable polarity plasma arc welding process used in the Space Shuttle external tank

Significant advantages of the Variable Polarity Plasma Arc (VPPA) Welding Process include faster welding, fewer repairs, less joint preparation, reduced weldment distortion, and absence of porosity. Flow profiles and power distribution of argon plasma gas as a working fluid to produce plasma arc jet in the VPPA welding process was analyzed. Major loss of heat transfer for flow through the nozzle is convective heat transfer; for the plasma jet flow between the outlet of the nozzle and workpiece is radiative heat transfer; and for the flow through the keyhole of the workpiece is convective heat transfer. The majority of the power absorbed by the keyhole of the workpiece is used for melting the solid metal workpiece into a molten metallic puddle. The crown and root widths and the crown and root heights can be predicted. An algorithm for promoting automatic control of flow parameters and the dimensions of the final product of the welding specification to be used for the VPPA Welding System operated at MSFC are provided.

Hung, R. J.↗