Engineering Papers⌕ Search

Engineering topics

Huffman, J. K.

Publications and source records attributed to Huffman, J. K..

35 records · Page 2

Subsonic longitudinal aerodynamic characteristics of a vectored-engine-over-wing configuration having spanwise leading-edge vortex enhancement

A configuration which integrates a close coupled canard wing combination, spanwise blowing for enhancement of the wing leading edge vortex, an engine-over-wing concept, and a wing trailing edge coanda-effect flap is studied. The data on the configuration are presented in tabular from without discussion. The investigation was conducted in the Langley 7- by 10-foot high speed tunnel at a Mach number of 0.166 through an angle-of-attack range from -2 to 22 deg. Rectangular main engine nozzles of aspect ratio 4, 6, and 8 were tested over a momentum coefficient range from 1.0 to 1.8.

Huffman, J. K.↗

Longitudinal and lateral-directional static aerodynamic characteristics of an unpowered escape system extraction rocket model with attached launch tubes

An escape system extraction rocket proposed for use on the Rotor Systems Research Aircraft was tested at Mach numbers of 0.1 and 0.3 through an angle of attack range from -2 deg to 102 deg and an angle of sideslip range from 0 deg to 15 deg in the Langley 7- by 10-foot high speed tunnel. The data are presented without analysis.

Huffman, J. K.↗

Aerodynamic characteristics of a tandem wing configuration of a Mach number of 0.30

An investigation was conducted to determine the aerodynamic characteristics of a tandem wing configuration. The configuration had a low forward mounted sweptback wing and a high rear mounted sweptforward wing jointed at the wing tip by an end plate. The investigation was conducted at a Mach number of 0.30 at angles of attack up to 20 deg. A comparison of the experimentally determined drag due to lift characteristics with theoretical estimates is also included.

Henderson, W. P.↗

Effect of vertical-tail location on the aerodynamic characteristics at subsonic speeds of a close-coupled canard configuration

The effects were studied of various vertical-tail configurations on the longitudinal and lateral directional-stability characteristics of a general research fighter model utilizing wing-body-canard. The study indicates that the addition of the high canard resulted in an increase in total lift at angles of attack above 4 deg with a maximum lift coefficient about twice as large as that for the wing-body configuration. For the wing-body (canard off) configuration, the center-line vertical tail indicates positive vertical-tail effectiveness throughout the test angle-of-attack range; however, for this configuration none of the wing-mounted vertical-tail locations tested resulted in a positive directional-stability increment at the higher angles of attack. For the wing-body-canard configuration several outboard locations of the wing-mounted vertical tails were found.

Huffman, J. K.↗

Lateral-directional stability characteristics of a wing-fuselage configuration at angles of attack up to 44 deg

An investigation has been conducted to determine the effects of configuration variables on the lateral-directional stability characteristics of a wing-fuselage configuration. The variables under study included variations in the location of a single center-line vertical tail and twin vertical tails, wing height, fuselage strakes, and horizontal tails. The study was conducted in the Langley high-speed 7-by 10-foot tunnel at a Mach number of 0.30, at angles of attack up to 44 deg and at sideslip angles of 0 deg and plus or minus 5 deg.

Henderson, W. P.↗

Investigation of the static lift capability of a low-aspect-ratio wing operating in a powered ground-effect mode

A preliminary experimental investigation has been made to evaluate the powered ground-effect capability of a low-aspect-ratio, wing-body configuration with forward-mounted propulsion. The tests were limited to static ground-effect conditions in order to obtain information on an air-cushion mode of operation. The results indicate, in general, that an air-cushion mode is within the capability of the type of configuration examined. The conditions examined indicated the possibility of hover mode and also forward acceleration capability in near-ground effect. Center-of-pressure movement did not appear to be a problem. However, it was recognized that longitudinal trim would be a problem to consider in both the hover and acceleration modes.

Huffman, J. K.↗

Effect of canard position and wing leading-edge flap deflection on wing buffet at transonic speeds

A generalized wind-tunnel model, with canard and wing planform typical of highly maneuverable aircraft, was tested. The addition of a canard above the wing chord plane, for the configuration with leading-edge flaps undeflected, produced substantially higher total configuration lift coefficients before buffet onset than the configuration with the canard off and leading-edge flaps undeflected. The wing buffet intensity was substantially lower for the canard-wing configuration than the wing-alone configuration. The low-canard configuration generally displayed the poorest buffet characteristics. Deflecting the wing leading-edge flaps substantially improved the wing buffet characteristics for canard-off configurations. The addition of the high canard did not appear to substantially improve the wing buffet characteristics of the wing with leading-edge flaps deflected.

Gloss, B. B.↗

Effects of wing-pivot location and forewing configuration on the low-speed aerodynamic characteristics of a variable-sweep airplane model

An investigation has been made to determine the effects of the location of the wing pivot and geometry of the forewing on the static longitudinal aerodynamic characteristics at subsonic speeds of a model representing a variable-sweep supersonic fighter airplane. Results indicate that as the wing-pivot location moves aft and outboard, the change in static margin due to wing sweep is reduced. Increasing the forewing area resulted in a forward shift of the aerodynamic center as well as a slight reduction in the aerodynamic-center variation due to wing sweep.

Huffman, J. K.↗

Effect of wing design on the longitudinal aerodynamic characteristics of a wing-body model at subsonic speeds

An investigation has been conducted to determine the effects of wing camber and twist on the longitudinal aerodynamic characteristics of a wingbody configuration. Three wings were used each having the same planform (aspect ratio of 2.5 and leading-edge sweep angle of 44 deg.) but differing in amounts of camber and twist (wing design lift coefficient). The wing design lift coefficients were 0, 0.35, and 0.70. The investigation was conducted over a Mach number range from 0.20 to 0.70 at angles of attack up to about 22 deg. The effect of wing strakes on the aerodynamic characteristics of the cambered wings was also studied. A comparison of the experimentally determined aerodynamic characteristics with theoretical estimates is also included.

Henderson, W. P.↗

Experimental investigation of the aerodynamic effects of distributed spanwise blowing on a fighter configuration

The results of wind tunnel tests at NASA Langley targeted at the performance and configurational characteristics of 0.1 and 0.13 scale model spanwise blowing (SWB) jet wing concepts are reported. The concept involves redirection of engine compressor bleed air to provide SWB at the fuselage-wing juncture near the wing leading edge. The tests covered the orientation of the outer panel nozzles, the effects of SWB operation on the performance of leading and trailing edge flaps and the effects of SWB on lateral stability. The trials were run at low speeds and angles of attack from 24-45 deg (landing). Both lift and longitudinal stability improved with the SWB, stall and leading edge vortex breakdown were delayed and performance increased with the SWB rate. Lateral stability was degraded below 20 deg angle of attack while instabilities were delayed above 20 deg due to roll damping.

Huffman, J. K.↗