Engineering topics

Huang, M.

Publications and source records attributed to Huang, M..

5 records

DOE OSTI2025

Measuring short-range correlations and quasi-elastic cross sections in A(e,e’) at x > 1 and modest Q 2

We present results from the Jefferson Lab E08-014 experiment, investigating short-range correlations (SRC) through measurements of inclusive quasi-elastic scattering from 2 H, 3 He, 4 He, 12 C, 40 Ca, and 48 Ca. The kinematics were selected to isolate scattering from SRCs, yielding a plateau in the A/ 2 H cross-section ratios due to the universal two-body structure of the 2N-SRCs in light and heavy nuclei. We observe approximate plateaus in the A/ 2 H ratios and provide the first extractions of the A/ 2 H ratio for 40 Ca and 48 Ca. We also examine the A/ 3 He ratio, aiming to identify three-nucleon SRCs (3N-SRCs). Following the approach for isolating 2N-SRCs, searching for 3N-SRC dominance involved measuring the A/ 3 He cross section ratio at modest-to-large Q 2 values and looking for a plateau ratios for x ≳ 2.5. This was not observed in the data, and in fact increasing Q 2 values moved the data further away from the predicted plateau. We show here that, when analyzed in terms of the struck nucleon’s light-cone momentum, the data exhibited the expected trend, progressively approaching the predicted 3N-SRC plateau. These observations suggest that future measurements at higher energies may facilitate a definitive isolation and identification of 3N-SRCs.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2024

Recent advance progress of HL-3 experiments

Since the first plasma realized in 2020, a series of key systems on HL-3 (known as HL-2M before) tokamak have been equipped/upgraded, including in-vessel components (the first wall, lower divertor, and toroidal cryogenic/water-cooling/baking/glow discharge systems, etc.), auxiliary heating system of 11 MW, and 28 diagnostic systems (to measure the plasma density, electron temperature, radiation, magnetic field, etc.). Magnet field systems were commissioned firstly for divertor plasma discharges. During the 2nd experimental campaign of HL-3 tokamak, several great progresses have been achieved. Firstly, the successful operation with plasma current larger than 1 MA was achieved under a divertor configuration. Secondly, the advanced divertor concept with two distinct snowflake configurations was realized. It is found that the distribution of ion saturation current and heat flux on bottom plate becomes wide due to magnetic surface expansion, demonstrating the advantage of such configuration in the heat flux mitigation. In addition, using the combination of NBI, ECRH and LHCD, the standard sawtoothing high confinement mode of megampere plasma was firstly accessed on the HL-3. The successful commissioning of HL-3 is beneficial for the initial operation of ITER.

1 MA plasma↗

NASA NTRS2018

Introduction to CAUSES: Description of Weather and Climate Models and Their Near‐Surface Temperature Errors in 5 Day Hindcasts near the Southern Great Plains

We introduce the Clouds Above the United States and Errors at the Surface (CAUSES) project with its aim of better understanding the physical processes leading to warm screen temperature biases over the American Midwest in many numerical models. In this first of four companion papers, 11 different models, from nine institutes, perform a series of 5 day hindcasts, each initialized from reanalyses. After describing the common experimental protocol and detailing each model configuration, a gridded temperature data set is derived from observations and used to show that all the models have a warm bias over parts of the Midwest. Additionally, a strong diurnal cycle in the screen temperature bias is found in most models. In some models the bias is largest around midday, while in others it is largest during the night. At the Department of Energy Atmospheric Radiation Measurement Southern Great Plains (SGP) site, the model biases are shown to extend several kilometers into the atmosphere. Finally, to provide context for the companion papers, in which observations from the SGP site are used to evaluate the different processes contributing to errors there, it is shown that there are numerous locations across the Midwest where the diurnal cycle of the error is highly correlated with the diurnal cycle of the error at SGP. This suggests that conclusions drawn from detailed evaluation of models using instruments located at SGP will be representative of errors that are prevalent over a larger spatial scale.

Morcrette, C. J.↗

NASA NTRS2007

International Planetary Data Alliance (IPDA) Information Model

This document is the third deliverable of the International Planetary Data Alliance (IPDA) Archive Data Standards Requirements Identification project. The goal of the project is to identify a subset of the standards currently in use by NASAs Planetary Data System (PDS) that are appropriate for internationalization. As shown in the highlighted sections of Figure 1, the focus of this project is the Information Model component of the Data Architecture Standards, namely the object models, a data dictionary, and a set of data formats.

information model↗

NASA NTRS1980

Grid generation for general three-dimensional configurations

A suitable grid system for complex three dimensional configurations such as wing/body/nacelle shape for the solution of nonlinear transonic flow problems was constructed. Two approaches were explored based on Thompson's body fitted coordinate concept. The most general approach was to divide the computational domain into multiple rectangular blocks where the configuration itself was also represented by a set of blocks whose structure follows the natural lines of the configuration. The block structured grid system was adaptable to complex configurations and gives good grid quality near physical corners. However, it introduced algorithm issues for the flow solution concerning the treatment of nonanalytic grid block boundaries and nonstandard grid cells. These issues were explored in relation to the grid generation. A more limited approach treats a wing/body configuration with only a single rectangular block in computational space. The issues involving nonstandard cells were avoided, but other limitations on grid resolution appear. Both a linear and a nonlinear system of grid generation equations were developed including methods of grid control.

Lee, K. D.↗