Brushlike arrays of carbon nanotubes embedded in microstrip waveguides provide highly efficient (high-Q) mechanical resonators that will enable ultraminiature radio-frequency (RF) integrated circuits. In its basic form, this invention is an RF filter based on a carbon nanotube array embedded in a microstrip (or coplanar) waveguide, as shown in Figure 1. In addition, arrays of these nanotube-based RF filters can be used as an RF filter bank. Applications of this new nanotube array device include a variety of communications and signal-processing technologies. High-Q resonators are essential for stable, low-noise communications, and radar applications. Mechanical oscillators can exhibit orders of magnitude higher Qs than electronic resonant circuits, which are limited by resistive losses. This has motivated the development of a variety of mechanical resonators, including bulk acoustic wave (BAW) resonators, surface acoustic wave (SAW) resonators, and Si and SiC micromachined resonators (known as microelectromechanical systems or MEMS). There is also a strong push to extend the resonant frequencies of these oscillators into the GHz regime of state-of-the-art electronics. Unfortunately, the BAW and SAW devices tend to be large and are not easily integrated into electronic circuits. MEMS structures have been integrated into circuits, but efforts to extend MEMS resonant frequencies into the GHz regime have been difficult because of scaling problems with the capacitively-coupled drive and readout. In contrast, the proposed devices would be much smaller and hence could be more readily incorporated into advanced RF (more specifically, microwave) integrated circuits.

Hoppe, Daniel↗

NASA NTRS1998

System and method for controlling the phase of an antenna array

A system and method for controlling power transferred to an aircraft. The system includes a master antenna and a plurality of slave antennas on the ground. Each slave antenna transmits an uplink signal of a unique phase modulated frequency. The master antenna transmits a master uplink signal. The aircraft receives all the uplink signals and modulates a composite of those signals to produce a downlink beacon that has multiple phase components, each of which corresponds to one of the slave antennas and has a unique frequency. Each of the slave antennas receives the downlink beacon and uses the corresponding phase component to adjust the phase of the slave uplink signal relative to the master uplink signal.

Conroy, Bruce↗

NASA NTRS1986

Conceptual design of high power Ka-band radar transmitter

A proposed conceptual design of a 400-kW CW Ka-band transmitter and associated microwave components to be used for planetary radar and serve as a prototype for future spacecraft uplinks is discussed. System requirements for such a transmitter are presented. Performance of the proposed high-power millimeter-wave tube, the gyroklystron, is discussed. Parameters of the proposed power amplifier, beam supply, and monitor and control devices are also presented. Microwave transmission-line components consisting of signal-monitoring devices, mode converter, and an overmoded corrugated feed are discussed. Finally, an assessment of the state-of-the-art technology to meet the system requirements is given, and possible areas of difficulty are summarized.

Bhanji, Alaudin↗