Engineering Papers⌕ Search

Engineering topics

Hopkins, M. A.

Publications and source records attributed to Hopkins, M. A..

Effect of the barrier growth mode on the luminescence and conductivity micron scale uniformity of InGaN light emitting diodes

In this paper, we present a combined cathodoluminescence (CL) and electron beam induced current (EBIC) study of the optical and electrical properties of InGaN light emitting diodes grown using different active region growth methods. In one device, both the quantum wells and quantum barriers were deposited at their optimum temperatures (2 T), whereas in the other device, each barrier was grown in a two step process with the first few nanometers at a lower temperature (Q2T). It was found that in the Q2T sample, small micron scale domains of lower emission intensity correlate strongly to a lower EBIC signal, whereas in the 2 T sample which has a more uniform emission pattern and an anti-correlation exists between CL emission intensity and EBIC signal.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

The impact of trench defects in InGaN/GaN light emitting diodes and implications for the “green gap” problem

The impact of trench defects in blue InGaN/GaN light emitting diodes (LEDs) has been investigated. Two mechanisms responsible for the structural degradation of the multiple quantum well (MQW) active region were identified. It was found that during the growth of the p-type GaN capping layer, loss of part of the active region enclosed within a trench defect occurred, affecting the top-most QWs in the MQW stack. Indium platelets and voids were also found to form preferentially at the bottom of the MQW stack. The presence of high densities of trench defects in the LEDs was found to relate to a significant reduction in photoluminescence and electroluminescence emission efficiency, for a range of excitation power densities and drive currents. This reduction in emission efficiency was attributed to an increase in the density of non-radiative recombination centres within the MQW stack, believed to be associated with the stacking mismatch boundaries which form part of the sub-surface structure of the trench defects. Investigation of the surface of green-emitting QW structures found a two decade increase in the density of trench defects, compared to its blue-emitting counterpart, suggesting that the efficiency of green-emitting LEDs may be strongly affected by the presence of these defects. Our results are therefore consistent with a model that the “green gap” problem might relate to localized strain relaxation occurring through defects.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Bias dependence and correlation of the cathodoluminescence and electron beam induced current from an InGaN/GaN light emitting diode

Micron-scale mapping has been employed to study a contacted InGaN/GaN LED using combined electroluminescence (EL), cathodoluminescence (CL), and electron beam induced current (EBIC). Correlations between parameters, such as the EBIC and CL intensity, were studied as a function of applied bias. The CL and EBIC maps reveal small areas, 2–10 μm in size, which have increased nonradiative recombination rate and/or a lower conductivity. The CL emission from these spots is blue shifted, by 30–40 meV. Increasing the reverse bias causes the size of the spots to decrease, due to competition between in-plane diffusion and drift in the growth direction. EL mapping shows large bright areas (∼100 μm) which also have increased EBIC, indicating domains of increased conductivity in the p and/or n-GaN.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Buffet Load Alleviation

High performance aircraft are, by their very nature, often required to undergo maneuvers involving high angles of attack. Under these conditions unsteady vortices emanating from the wing and the fuselage will impinge on the twin fins (required for directional stability) causing excessive buffet loads, in some circumstances, to be applied to the aircraft. These loads result in oscillatory stresses, which may cause significant amounts of fatigue damage. Active control is a possible solution to this important problem. A full-scale test was carried out on an F/A-18 fuselage and fins using piezoceramic actuators to control the vibrations. Buffet loads were simulated using very powerful electromagnetic shakers. The first phase of this test was concerned with the open loop system identification whereas the second stage involved implementing linear time invariant control laws. This paper looks at some of the problems encountered as well as the corresponding solutions and some results. It is expected that flight trials of a similar control system to alleviate buffet will occur as early as 2001.

Ryall, T. G.↗

Measurement of minority-carrier drift mobility in solar cells using a modulated electron beam

A determination of diffusivity on solar cells is here reported which utilizes a one dimensional treatment of diffusion under sinusoidal excitation. An intensity-modulated beam of a scanning electron microscope was used as a source of excitation. The beam was injected into the rear of the cell, and the modulated component of the induced terminal current was recovered phase sensitively. A Faraday cup to measure the modulated component of beam current was mounted next to the sample, and connected to the same electronics. A step up transformer and preamplifier were mounted on the sample holder. Beam currents on the order of 400-pA were used in order to minimize effects of high injection. The beam voltage was 34-kV, and the cell bias was kept at 0-V.

Othmer, S.↗