Engineering Papers⌕ Search

Engineering topics

Hoover, R. B.

Publications and source records attributed to Hoover, R. B..

At least 37 records · Page 2

Diatoms on earth, comets, Europa and in interstellar space

There exists a close correspondence between the measured infrared properties of diatoms and the infrared spectrum of interstellar dust as observed in the Trapezium nebula and toward the galactic center source GC-IRS 7. Diatoms and bacteria also exhibit an absorbance peak near 2200 A, which is found to agree with the observed ultraviolet absorbance properties of interstellar grains. The observational data are reviewed, and the known properties of diatoms and bacteria are considered. It is suggested that these characteristics are consistent with the concept of a cosmic microbiological system in which these or similar microorganisms might exist on comets, Europa and in interstellar space.

Hoover, R. B.↗

Spectral slicing X-ray telescope with variable magnification

A telescope for viewing high frequency radiation (soft X-ray, extreme ultraviolet) is described. This telescope has a long focal length with a selection of magnifications despite a short housing. Light enters the telescope and is reflected by the telescope's primary optical system to one of several secondary mirrors at different locations on a movable frame. The secondary mirrors have varying degrees of magnification and select narrow spectral slices of the incident radiation. Thus, both the magnification and effective focal length field of view and wavelength can be altered by repositioning the moving frame. Configurations for spaceborne applications are discussed.

Hoover, R. B.↗

The Extended Range X-Ray Telescope center director's discretionary fund report

An Extended Range X-Ray Telescope (ERXRT) of high sensitivity and spatial resolution capable of functioning over a broad region of the X-ray/XUV portion of the spectrum has been designed and analyzed. This system has been configured around the glancing-incidence Wolter Type I X-ray mirror system which was flown on the Skylab Apollo Telescope Mount as ATM Experiment S-056. Enhanced sensitivity over a vastly broader spectral range can be realized by the utilization of a thinned, back-illuminated, buried-channel Charge Coupled Device (CCD) as the X-ray/XUV detector rather than photographic film. However, to maintain the high spatial resolution inherent in the X-ray optics when a CCD of 30 micron pixel size is used, it is necessary to increase the telescope plate scale. This can be accomplished by use of a glancing-incidence X-ray microscope to enlarge and re-focus the primary image onto the focal surface of the CCD.

Hoover, R. B.↗

Preserving Color in Developed Photographic Film

Controlled-atmosphere vault retards fading and deterioration of developed high speed film. Vault with externally controlled valve regulates flow of nitrogen gas from internally mounted tank. Gas purges ambient air from vault through purge valve and maintains vault pressure slightly above ambient.

Hoover, R. B.↗

Method for retarding dye fading during archival storage of developed color photographic film

Dye fading during archival storage of developed color photographic film is retarded by placing the film in a sealed, opaque vault, introducing a dry, pressurized inert gas into the vault while the latter is vented, and sealing the vault after the air within the vault has been purged and replaced by the inert gas. Preferably, the gas is nitrogen; and the vault is stored at a temperature below room temperature to preserve the color photographic emulsions on the film contained within the vault. For short-term storage, sodium thiocyanate pads charged with water are placed within the vault. For long term storage, the interior of the vault is kept at a low relative humidity.

Hoover, R. B.↗

Extended range X-ray telescope

An X-ray telescope system is described which is comprised of a tubular mount having a collecting region remote from the one axial end. A soft X-ray/XUV subsystem associated with the collecting region directs only relatively soft, near on-axis X-rays/XUV radiation incident on a first portion of the collecting region into a first detector sensitive to relatively soft X-rays/XUV radiation. A hard X-ray subsystem associated with the collecting region directs only relatively hard near on-axis X-rays incident on a second portion of the collecting region into a second detector sensitive to relatively hard X-rays.

Hoover, R. B.↗

S056 X-ray telescope experiment on the Skylab Apollo Telescope Mount

This paper describes the S056 X-ray instrument which was carried aboard the Skylab Apollo Telescope Mount as part of the solar instrument cluster. The instrument, which was built at the NASA Marshall Space Flight Center, consisted of a glancing incidence X-ray telescope to record solar images in the 6-40-A region, together with an X-ray event analyzer to monitor the total solar soft X-ray flux in several wavelength bands. The X-ray telescope used film as a recording medium and thin foil filters to isolate specific wavelength bands. The instrument subsystems are described in detail and typical results presented.

Underwood, J. H.↗

Results of correlative studies of a complex solar active region /McMath 12387/ during the Skylab mission

Results of correlative studies employing Skylab/ATM X-Ray Telescope filter-heliograms, solar magnetograms, and H alpha spectroheliograms of the complex solar active region McMath 12387 for 10-18 June 1973 are presented. Evolutionary changes within the complex region are discussed. Magnetic field calculations, using both potential and force-free models, have been performed and the results are presented. We also determine temperatures, emission measures, and electron densities and show the variation with time of the X-ray emission from the entire complex.

Smith, J. B., Jr.↗

Multiplate focusing collimator

An appartus is described for scanning relatively small near sources of penetrating radiation to obtain the energy distribution thereof, wherein a collimator assembly is interposed between a radiation source and a radiation detector. The collimator assembly has a plurality of plates aligned in parallel planes with respect to a common axis normal to their centers. All the plates have similar random distribution of apertures. All apertures on each plate are the same size. The size of respective plates, the size of the apertures of said respective plates, and the spacing between said respective plates vary precisely according to a predetermined ratio to produce radiation channels which converge to a focal point. The radiation incident to the radiation detector is maximized when the focal point and the radiation source are co-incident.

Hoover, R. B.↗

Analysis of Skylab/Apollo Telescope Mount S-056 observations based on a force-free magnetic field model

Data obtained from the S-056 X-ray experiment on Skylab/ATM have been analyzed based on the assumption that the magnetic fields in the chromosphere and lower corona are force-free. Underlying the analysis is the hypothesis that the observed X-ray filaments coincide with magnetic field lines. The photographic recording of the filaments can then be compared with the projection along the line of sight of the computed magnetic field lines of the model. Ground-based observations of the longitudinal magnetic field component complement the X-ray data and are used in the theoretical interpretation.

Meyer, R. X.↗

Three mirror glancing incidence system for X-ray telescope

A telescope suitable for soft X-ray astronomical observations consists of a paraboloid section for receiving rays at a grazing angle and a hyperboloid section which receives reflections from the paraboloid at a grazing angle and directs them to a predetermined point of focus. A second hyperboloid section is centrally located from the other two surfaces and positioned to reflect from its outer surface radiation which was not first reflected by the paraboloid. A shutter is included to assist in calibration.

Hoover, R. B.↗

Collimator of multiple plates with axially aligned identical random arrays of apertures

A collimator is disclosed for examining the spatial location of distant sources of radiation and for imaging by projection, small, near sources of radiation. The collimator consists of a plurality of plates, all of which are pierced with an identical random array of apertures. The plates are mounted perpendicular to a common axis, with like apertures on consecutive plates axially aligned so as to form radiation channels parallel to the common axis. For near sources, the collimator is interposed between the source and a radiation detector and is translated perpendicular to the common axis so as to project radiation traveling parallel to the common axis incident to the detector. For far sources the collimator is scanned by rotating it in elevation and azimuth with a detector to determine the angular distribution of the radiation from the source.

Hoover, R. B.↗

An automatic lightning detection and photographic system

Conventional 35-mm camera is activated by an electronic signal every time lightning strikes in general vicinity. Electronic circuit detects lightning by means of antenna which picks up atmospheric radio disturbances. Camera is equipped with fish-eye lense, automatic shutter advance, and small 24-hour clock to indicate time when exposures are made.

Wojtasinski, R. J.↗

Automatic lightning detection and photographic system

A system is presented for monitoring and recording lightning strokes within a predetermined area with a camera having an electrically operated shutter with means for advancing the film in the camera after activating the shutter. The system includes an antenna for sensing lightning strikes which, in turn, generates a signal that is fed to an electronic circuit which generates signals for operating the shutter of the camera. Circuitry is provided for preventing activation of the shutter as the film in the camera is being advanced.

Wojtasinski, R. J.↗

Advances in solar and cosmic X-ray astronomy - A survey of experimental techniques and observational results.

The current status of X-ray astronomy is surveyed by reviewing observational results and theoretical conclusions gained within the past two years in areas dealing with the quiet-sun, slowly-varying, and burst components of solar X-radiation and with the features of cosmic X-ray sources. Thermal and nonthermal processes responsible for a wide variety of X-ray emission mechanisms in nature are explained, and characteristics of X radiation from specific solar structures are described. Attention is given to the effects of interstellar and intergalactic matter on cosmic X-rays; the properties of galactic and extragalactic X-ray sources; and the specifications of such instruments as gas-filled ionization detectors, proportional counters, Geiger counters, scintillation detectors, photoelectric detectors, polarimeters, collimators, spectrometers, and imaging systems.

Hoover, R. B.↗

A multiple-plate, multiple-pinhole camera for X-ray gamma-ray imaging

Plates with identical patterns of precisely aligned pinholes constitute lens system which, when rotated about optical axis, produces continuous high resolution image of small energy X-ray or gamma ray source. Camera has applications in radiation treatment and nuclear medicine.

Hoover, R. B.↗

Glancing incidence optics for X-ray and ultraviolet astronomy.

Glancing incidence telescopes of the kind first described by Wolter have now been physically realized, so that it is possible to obtain high-resolution images of celestial objects at all wavelengths greater than about 3 A. The GSFC-MSFC X-ray telescope for the Apollo telescope mount uses Wolter type 1 optics and is capable of forming images of the sun in the 8-70 A region with spatial resolution of the order of one arc second. The GSFC extreme ultraviolet spectroheliometer for OSO H uses type 2 optics and can obtain images of the sun in spectral lines in the 170-400 A region with a spatial resolution of about ten arc seconds. Theoretical (ray trace) and laboratory data on these systems are presented.

Underwood, J. H.↗