Engineering topics
Publications and source records attributed to Hodge, D. B..
An empirical model was generated to estimate diversity gain on Earth-space propagation paths as a function of Earth terminal separation distance, link frequency, elevation angle, and angle between the baseline and the path azimuth. The resulting model reproduces the entire experimental data set with an RMS error of 0.73 dB.
The results of gain degradation measurements using the Comstar D/3 19.04 GHz beacon are reported. This experiment utilized 0.6 and 5 m aperture antennas aligned along the same propagation path to examine propagation effects which are related to the antenna aperture size. Sample data for clear air, scintillation in clear air, and precipitation fading are presented. Distributions of the received signal levels and variances for both antennas are also presented.
A model of the microwave and millimeter wave link in the presence of atmospheric turbulence is presented with emphasis on satellite communications systems. The analysis is based on standard methods of statistical theory. The results are directly usable by the design engineer.
The amplitude and angle of arrival measurements on an Earth-space path using the 28.56 GHz COMSTAR D3 satellite beacon are described. These measurements were made by the Ohio State University ElectroScience Laboratory during the period September 1978 to September 1979. Monthly, quarterly, and annual distributions of attenuation, angle of arrival, and variance of both these parameters are reported. During this period, fades exceeding 29 dB for .00% of the time and angle of arrival fluctuations exceeding .12 degrees for .01% of the time were observed.
The objective of the experiment was to determine the statistical behavior of attenuation and angle of arrival on an Earth-space propagation path using the CTS 11.7 GHz beacon. Measurements performed from 1976 to 1978 form the data base for analysis. The statistics of the signal attenuation and phase variations due to atmospheric disturbances are presented. Rainfall rate distributions are also included to provide a link between the above effects on wave propagation and meteorological conditions.
The atmospheric refractivity can be expressed as a function of temperature, pressure, water vapor content, and operating frequency. Based on twenty-year meteorological data, statistics of the atmospheric refractivity were obtained. These statistics were used to estimate the variation of dispersion, attenuation, and refraction effects on microwave and millimeter wave signals propagating along atmospheric paths. Bending angle, elevation angle error, and range error were also developed for an exponentially tapered, spherical atmosphere.
Measurements of angle of arrival and amplitude fluctuations on millimeter wavelength Earth-space communication links are described. Measurement of rainfall attenuation and radiometric temperature statistics and the assessment of the performance of a self-phased array as a receive antenna on an Earth-space link are also included.
Explore the source record for details and available documents.
Spectral characteristics of 2 and 30 GHz signals received from the Applications Technology Satellite-6 (ATS-6) are analyzed in detail at elevation angles ranging from 0 deg to 44 deg. The spectra of the received signals are characterized by slopes and break frequencies. Statistics of these parameters are presented as probability density functions. Dependence of the spectral characteristics on elevation angle is investigated. The 2 and 30 GHz spectral shapes are contrasted through the use of scatter diagrams. The results are compared with those predicted from turbulence theory. The average spectral slopes are in close agreement with theory, although the departure from the average value at any given elevation angle is quite large.
A meteorological radar calibration technique is developed. It is found that the integrated, range corrected, received power saturates under intense rain conditions in a manner analogous to that encountered for the radiometric path temperature. Furthermore, it is found that this saturation condition establishes a bound which may be used to determine an absolution radar calibration for the case of radars operating at attenuating wavelengths. In the case of less intense rainfall or for radars at nonattenuating wavelengths, the relationship for direct calibration in terms of an independent measurement of radiometric path temperature is developed. This approach offers the advantage that the calibration is in terms of an independent measurement of the rainfall through the same elevated region as that viewed by the radar.
It is shown that a simple physical model is adequate for the prediction of the long term statistics of both the reduced signal levels and increased peak-to-peak fluctuations. The model is based on conventional atmospheric turbulence theory and incorporates both amplitude and angle of arrival fluctuations. This model predicts the average variance of signals observed under clear air conditions at low elevation angles on earth-space paths at 2, 7.3, 20 and 30 GHz. Design curves based on this model for gain degradation, realizable gain, amplitude fluctuation as a function of antenna aperture size, frequency, and either terrestrial path length or earth-space path elevation angle are presented.
The equivalent reflectivity, specific attenuation and volumetric backscatter cross section of rain are calculated and tabulated at a number of frequencies from 1 to 500 GHz using classical Mie theory. The first two parameters are shown to be closely approximated as functions of rain rate by the power law aR to the b power. The a's and b's are also tabulated and plotted for convenient reference.
The diurnal motion of a synchronous satellite necessitates mechanical tracking when a large aperture, high gain antenna is employed at the earth terminal. An alternative solution to this tracking problem is to use a self phased array consisting of a number of fixed pointed elements, each with moderate directivity. Non-mechanical tracking and adequate directive gain are achieved electronically by phase coherent summing of the element outputs. The element beamwidths provide overlapping area coverage of the satellite motion but introduce a diurnal variation into the array gain. The optimum element beamwidth and pointing direction of these elements can be obtained under the condition that the array gain is maximized simultaneously with the minimization of the diurnal variation.
Amplitude scintillation measurements were made simultaneously at 2.075 and 30 GHz on earth-space propagation paths over elevation angles in the range 0.4 to 44 deg. The experiment was performed as the Applications Technology Satellite (ATS-6) was moved slowly from a synchronous position over Africa to a new synchronous position over the United States. The received signal, variance, level, covariance, spectra and fade distributions are discussed as functions of the path elevation angle. These results are also compared wherever possible with similar measurements made earlier at 20 and 30 GHz.
Extensive amplitude scintillation measurements were made simultaneously at 2.075 and 30 GHz on earth-space propagation paths. These measurements were performed as the Applications Technology Satellite (ATS-6) was moved slowly from a synchronous position over India to a new synchronous position over the United States. The variance, path loss, covariance, and spectra are discussed as functions of the path elevation angle. These results are also compared with earlier simultaneous scintillation measurements at 20 and 30 GHz during the movement of ATS-6 to its position over India.
Extensive amplitude scintillation measurements have been made simultaneously at 2.075 and 30 GHz on earth-space propagation paths. These measurements were performed as the Applications Technology Satellite (ATS-6) was moved slowly from a synchronous position over India to a new synchronous position over the United States. The variance, path loss, covariance, and spectra are discussed as functions of the path elevation angle. These results are also compared with earlier simultaneous scintillation measurements at 20 and 30 GHz during the movement of ATS-6 to its position over India.
A four element self phased array was developed for propagation measurements utilizing the Communication Technology Satellite 11.7 GHz downlink. The parameters of interest in measurements were attenuation, amplitude scintillation, and angle of arrival variability. Simultaneous scintillation measurements were also conducted at 360 MHz, 2.075 GHz, and 30 GHz utilizing ATS-6. The unique movement of ATS-6 during 1976 permitted extensive measurement of scintillation characteristics as a function of path elevation angle.
A self phased array was developed for propagation measurements on an earth-space path. The 11.7 GHz CTS beacon was used as the signal source. The self phased array was used to measure angle of arrival as well as attenuation and scintillation statistics. The performance of the array is described, and sample data are presented. The tracking capability of the self phased array was also studied. This technique permits fully electronic, nonmechanical satellite tracking, thus simplifying unmanned operation and eliminating severe weather tracking constraints.