Engineering Papers⌕ Search

Engineering topics

Hinedi, S.

Publications and source records attributed to Hinedi, S..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Digital Modem Design Based on Multirate Filter Banks

A new approach for the architecture of an all digital modem design is presented. The key feature is a lower processing rate than that of the Nyquist rate (the input sampling rate) and even the symbol rate. The lower processing rate is achieved by the use of a parallel structure, based on multirate filter banks concepts. In this proposed scheme, matched filtering is implemented in the subbands of an analysis/synthesis filter bank.

digital modem design↗
NASA NTRS1994

Limitations on the Subcarrier Frequency-to-Symbol Rate Ratio

For space missions in which tracking the residual carrier is absolutely critical, the use of a subcarrier to separate the data from the residual carrier is the best way to maximize residual-carrier tracking performance.

subcarrier-to-symbol rate ratio↗
NASA NTRS1994

Arraying Techniques for the Galileo S-Band Mission, Part I - Full Spectrum Combining

It has been known for some time now that when signals from a single source are received at multiple antennas, these antennas can be arrayed to enhance the quality of the received signal. What has been relatively unknown, however, is that the quality of the combined signal critically depends on the arraying algorithm, as well as, the characteristics of the transmitted signal.

arraying algorithms↗
NASA NTRS1993

On the effects of phase jitter on QPSK lock detection

The performance of a QPSK (quadrature phase-shift keying) lock detector is described, taking into account the degradation due to carrier phase jitter. Such an analysis is necessary for accurate performance prediction purposes in scenarios where both the loop SNR is low and the estimation period is short. The derived formulas are applicable to several QPSK loops and are verified using computer simulations.

Mileant, A.↗
NASA NTRS1993

L-Band Mobile Terminal Antennas for Helicopters

The feasibility of using a low gain antenna (LGA) as a mobile terminal antenna for helicopters is described in this paper. The objectives are 1) to select the lowest cost antenna system which can be easily mounted on a helicopter and capable of communicating with a satellite, and 2) to determine the best antenna position on the helicopter to mitigate the signal blockage due to rotor blades and the multipath effect from the helicopter's body. The omni-directional low gain antenna (LGA) is selected because it is simple, reliable, and low cost. The helix antenna is selected among the many LGAs because it is the most economical one and has the widest elevation beamwidth. Both 2-arm and 4-arm helices are studied experimentally to determine the antenna's performance and the scattering effects from the helicopter's body. It is found that the LGA should be located near the tail section and at least 8 inches above the helicopter.

helicopter↗
NASA NTRS1993

A functional description of the Buffered Telemetry Demodulator (BTD)

This article gives a functional description of the buffered telemetry demodulator (BTD), which operates on recorded digital samples to extract the symbols from the received signal. The key advantages of the BTD are as follows: (1) its ability to reprocess the signal to reduce acquisition time; (2) its ability to use future information about the signal and to perform smoothing on past samples; and (3) its minimum transmission bandwidth requirement as each sub carrier harmonic is processed individually. The first application of the BTD would be the Galileo S-band contingency mission, where the signal is so weak that reprocessing to reduce the acquisition time is crucial. Moreover, in the event of employing antenna arraying with full spectrum combining, only the sub carrier harmonics need to be transmitted between sites, resulting in significant reduction in data rate transmission requirements. Software implementation of the BTD is described for various general-purpose computers.

Tsou, H.↗
NASA NTRS1993

Mobile terminal antennas for helicopters

In this paper, the feasibility of using an L-band low gain antenna (LGA) as a mobile terminal antenna for helicopters is described. The objective is to select the lowest cost antenna system which can be easily mounted on a helicopter and capable of communicating with a geosynchronous satellite. To ensure that all the antenna options are being considered, the steerable high gain reflector and medium gain array antennas as well as LGA are studied and compared in an exhaustive survey. The high gain reflector antenna in L-band is usually very large in size and heavy in weight. In addition, a bulky and expensive tracking system is needed to steer the antenna beam to the satellite direction. The medium gain antennas (including mechanically and electronically steered arrays) are also more expensive and less reliable than an LGA due to the addition of a beam steering system to track the satellite. The omni-directional LGA is simple, reliable, and inexpensive. It is typically ten times smaller than the medium gain antenna. This makes the position, selection, and mounting on the helicopter relatively easier. Therefore, the LGA is selected as a mobile terminal antenna for helicopters. Among the many LGA's (cross-dipole, helix, spiral, and slot antennas), the helix antenna is the most inexpensive. One can also change the size, shape, or pitch angle of the helix to optimize the gain in the desired direction. Therefore, the helix antenna is selected for further study. Both 2-arm and 4-arm helices are studied theoretically and experimentally to determine the antenna's performance and the scattering effects from the helicopter body and the blades. The multipath, Doppler, and Doppler rate issues as well as the periodic fading effects caused by the helicopter rotor blades will be briefly discussed in the paper.

Wu, Te-Kao↗
NASA NTRS1993

L-band mobile terminal antennas for helicopters

The feasibility of using a low gain antenna (LGA) as a mobile terminal antenna for a helicopter is described in this paper. The objectives are to select the lowest cost antenna system which can be easily mounted on a helicopter and capable of communicating with a satellite, and to determine the best antenna position on the helicopter to mitigate the signal blockage due to rotor blades and the multipath effect from the helicopter's body. The omnidirectional LGA is selected because it is simple, reliable, and low cost. The helix antenna is selected among the many LGA's because it is the most economical one and has the widest elevation beamwidth. Both 2-arm and 4-arm helices are studied experimentally to determine the antenna's performance and the scattering effects from the helicopter's body. It is found that the LGA should be located near the tail section and at least eight inches above the helicopter.

Wu, T. K.↗
NASA NTRS1992

Application of multirate digital filter banks to wideband all-digital phase-locked loops design

A new class of architecture for all-digital phase-locked loops (DPLL's) is presented in this article. These architectures, referred to as parallel DPLL (PDPLL), employ multirate digital filter banks (DFB's) to track signals with a lower processing rate than the Nyquist rate, without reducing the input (Nyquist) bandwidth. The PDPLL basically trades complexity for hardware-processing speed by introducing parallel processing in the receiver. It is demonstrated here that the DPLL performance is identical to that of a PDPLL for both steady-state and transient behavior. A test signal with a time-varying Doppler characteristic is used to compare the performance of both the DPLL and the PDPLL.

Sadr, R.↗
NASA NTRS1992

Acquisition performance of various QPSK carrier tracking loops

The frequency and phase acquisition performance of three quadrature phase shift keying (QPSK) carrier tracking loops, the MAP estimation loop, the Costas crossover loop, and the generalized Costas loop, is described. Acquisition time and probability of acquisition as a function of both loop signal-to-noise ratio and frequency offset to loop bandwidth ratio are obtained via computer simulations for type II and III loops. It is shown that the MAP loop, which results in the smallest squaring loss for all signal-to-noise ratios, is sometimes outperformed by the other two loops in terms of acquisition time and acquisition probability.

Hinedi, S.↗
NASA NTRS1992

Lock detection in Costas loops

Previous analyses of lock detector algorithms for Costas loops have ignored the effects of the inherent correlation between samples of the phase error process. In this paper, both analysis and simulations are used to quantify the effects of phase correlation on lock detection for the 'square law' and 'absolute value' type detectors. Results are obtained which depict the lock detection probability as a function of loop signal-to-noise ratio for a given false alarm rate. It is shown that the square law detector experiences less degradation due to phase jitter than the absolute value detector and that the degradation in detector signal-to-noise ratio is more pronounced for squarewave than for sinewave signals.

Mileant, A.↗
NASA NTRS1991

The Advanced Receiver II telemetry test results at Goldstone

The telemetry performance of the Advanced Receiver II (ARX-II) in tracking and demodulating signals from various deep space missions is described. The tests were performed at Goldstone, and the spacecrafts tracked were Pioneer 10, Pioneer 11, Voyager 2, Magellan, and the International Cometary Explorer (ICE). These missions present a broad range of operating conditions to test the ARX-II in terms of signal-to-noise ratio (SNR) and the symbol rate of the received signal.

Sadr, R.↗
NASA NTRS1991

Symbol lock detection in the ARX 2 and Block 5 receivers

The performances of 5 symbol-lock detectors are compared. These detectors are the square-law detector with overlapping (SQOD) and nonoverlapping integrators, the absolute-value detectors with overlapping and nonoverlapping integrators, and the signal-power estimator detector (SPED). The analysis considers various scenarios in which the observation interval is much larger than or equal to the symbol-synchronizer loop bandwidth, and which were not considered in previous analyses. Also, the case of threshold setting in the absence of signal is considered. It is shown, that the SQOD outperforms all others when the threshold is set in the presence of a signal, independent of the relationship between loop bandwidth and observation period. On the other hand, the SPED outperforms all others when the threshold is set in the presence of noise only.

Shihabi, M.↗
NASA NTRS1991

Overview of arraying techniques in the deep space network

Four different arraying schemes that can be used by the Deep Space Network are functionally discussed and compared. These include symbol stream combining (SSC), baseband combining (BC), carrier arraying (CA), and full spectrum combining (FSC). In addition, sibeband aiding (SA) is also included and compared even though it is not an arraying scheme, since it uses a single antenna. Moreover, combinations of these schemes are discussed, such as carrier arraying with sideband aiding and baseband combining (CA/SA/BC) or carrier arraying with symbol stream combining (CA/SSC). Complexity versus performance is traded off and the benefits to the reception of existing spacecraft signals are discussed. Recommendations are made as to the best techniques for particular configurations.

Mileant, A.↗
NASA NTRS1991

The advanced receiver 2: Telemetry test results in CTA 21

Telemetry tests with the Advanced Receiver II (ARX II) in Compatibility Test Area 21 are described. The ARX II was operated in parallel with a Block-III Receiver/baseband processor assembly combination (BLK-III/BPA) and a Block III Receiver/subcarrier demodulation assembly/symbol synchronization assembly combination (BLK-III/SDA/SSA). The telemetry simulator assembly provided the test signal for all three configurations, and the symbol signal to noise ratio as well as the symbol error rates were measured and compared. Furthermore, bit error rates were also measured by the system performance test computer for all three systems. Results indicate that the ARX-II telemetry performance is comparable and sometimes superior to the BLK-III/BPA and BLK-III/SDA/SSA combinations.

Hinedi, S.↗
NASA NTRS1990

QPSK loop lock detection in the advanced receiver

The Advanced Receiver (ARX 2) currently being developed uses a Costas crossover loop to acquire and track the phase of an incoming quadrature phase-shift-keyed (QPSK) signal. The performance is described for the QPSK lock detector to be implemented, taking into account the phase jitter in the tracking loop. Simulations are used to verify the results of the analysis.

Mileant, A.↗
NASA NTRS1990

A functional description of the advanced receiver

The breadboard Advanced Receiver 2 (ARX 2) that is currently being built for future use in NASA's Deep Space Network (DSN) is described. The hybrid analog/digital receiver performs multiple functions including carrier, subcarrier, and symbol synchronization. Tracking can be achieved for residual, suppressed, or hybrid carriers and for both sinusoidal and square-wave subcarriers. Other functions such as time-tagged Doppler extraction and monitor/control are also discussed, including acquisition algorithms and lock-detection schemes. System requirements are specified and a functional description of the ARX 2 is presented. The various digital signal-processing algorithms used are also discussed and illustrated with block diagrams.

Hinedi, S.↗