Engineering Papers⌕ Search

Engineering topics

Hiller, J

Publications and source records attributed to Hiller, J.

X-ray nanotomography of SiO{sub 2}-coated Pt{sub 90}Ir{sub 10} tips with sub-micron conducting apex

Hard x-ray nanotomography provides an important three-dimensional view of insulator-coated ''smart tips'' that can be utilized for modern emerging scanning probe techniques. Tips, entirely coated by an insulating SiO{sub 2} film except at the very tip apex, are fabricated by means of electron beam physical vapor deposition, focused ion beam milling and ion beam-stimulated oxide growth. Although x-ray tomography studies confirm the structural integrity of the oxide film, transport measurements suggest the presence of defect-induced states in the SiO{sub 2} film. The development of insulator-coated tips can facilitate nanoscale analysis with electronic, chemical, and magnetic contrast by synchrotron-based scanning probe microscopy.

36 MATERIALS SCIENCE↗

From micro- to nano-scale molding of metals : size effect during molding of single crystal Al with rectangular strip punches.

A single crystal Al specimen was molded at room temperature with long, rectangular, strip diamond punches. Quantitative molding response curves were obtained at a series of punch widths, ranging from 5 {micro}m to 550 nm. A significant size effect was observed, manifesting itself in terms of significantly increasing characteristic molding pressure as the punch width decreases to 1.5 {micro}m and below. A detailed comparison of the present strip punch molding results was made with Berkovich pyramidal indentation on the same single crystal Al specimen. The comparison reveals distinctly different dependence of the characteristic pressure on corresponding characteristic length. The present results show the feasibility of micro-/nano-scale compression molding as a micro-/nano-fabrication technique, and offer an experimental test case for size-dependent plasticity theories.

36 MATERIALS SCIENCE↗

Nonvolatile logic elements based on magnetically coupled FSF structures.

We demonstrate the evolution of the anisotropic conductivity in the superconductor that is magnetically coupled with two adjacent ferromagnetic layers. Stripe magnetic domain structure in the ferromagnetic layers results in directional superconducting order parameter in the superconducting layer. The conductance anisotropy strongly depends on the period of the magnetic domains and the strength of the local magnetization. The anisotropic conductivity of up to three orders of magnitude can be achieved with spatial critical temperature modulation of 5% of Tc. The effect could be exploited in low temperature nonvolatile logic and storage elements

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗