Engineering PapersSearch

Engineering topics

Heuser, W. R.

Publications and source records attributed to Heuser, W. R..

An Open Specification for Space Project Mission Operations Control Architectures

An 'open specification' for Space Project Mission Operations Control Architectures is under development in the Spacecraft Control Working Group of the American Institute for Aeronautics and Astro- nautics. This architecture identifies 5 basic elements incorporated in the design of similar operations systems: Data, System Management, Control Interface, Decision Support Engine, & Space Messaging Service.

spacecraft ground systems

Industrial Protocols for Spacecraft Command and Control

A standard data interface for spacecraft and intelligent spacecraft devices will have a major impact on the cost of building and flying satellites. The Space Messaging Service is a key element in a proposed 'open' standard for Space Project Mission Operations Control Architecture. The rationale for a messaging service is examined. Selection of specifications are discussed. Modifications are proposed.

Spacecraft Ground Systems Command and Control Mess

Using Manufacturing Message Specification for Monitor and Control at Venus

A new approach to the monitor and control of spacecraft tracking systems has been developedbased on the Open Systems Interconnection (OSI) process control standard Manufacturing MessageSpecification (MMS). Station subsystems are interconnected using commercial MMS software tosupport interprocessor communication across a Local Area Network (LAN). Significant cost savingsare realized through the incorporation of commercial Software Control and Data Acquisition(SCADA) packages to support the operator interface. A pilot system has been installed and is inoperation at the Deep Space Network (DSN) experimental Venus complex. The DSN operates a new34-meter beam waveguide antenna (DSS-13) at the Goldstone Venus complex in California. The complex composed of various pieces of equipment with some equipment under computer automated control...

Urista, J.

DSS-13 - Using an OSI process control standard for monitor and control

The flexibility and robustness of a monitor and control (M&C) system are a direct result of the underlying inter-processor communications architecture. A new architecture for M&C at the Deep Space Communications Complexes has been developed based on the manufacturing message specification (MMS) process control standard of the open system interconnection (OSI) suite of protocols. This architecture has been tested both in a laboratory environment and under operational conditions at the Deep Space Network experimental station (DSS-13). The DSS-13 experience in the application of OSI standards to support M&C has been extremely successful. MMS meets the functional needs of the station and provides a level of flexibility and responsiveness previously unknown in that environment. The architecture is robust enough to meet current operational needs and flexible enough to provide a migration path for new subsystems. This paper describes the architecture of the DSS-13 M&C system, discuss how MMS was used and the requirements this imposed on other parts of the system, and provides results from systems and operational testing at DSS-13.

Heuser, W. R.

An OSI architecture for the Deep Space Network

This article presents an Open Systems Interconnection (OSI) architecture developed for the Deep Space Network. An historical review is provided to establish the context for current United States Government policy on interprocessor communication standards. An introduction to the OSI architecture, its seven-layer approach, and an overview of application service entities are furnished as a tutorial. Finally, the results of a prototype system developed for monitor and control of a Deep Space Station are also presented.

Heuser, W. R.

Laboratory actinide partitioning - Whitlockite/liquid and influence of actinide concentration levels

The partition coefficients between synthetic whitlockite (beta Ca-phosphate) and coexisting silicate melts are determined for the actinide elements Th, U and Pu. Experiments were performed at 1 bar pressure and 1250 C at oxygen fugacities from 10 to the -8.5 to 10 to the -0.7 bars, and partitioning was determined from trace element radiography combined with conventional electron microprobe analysis. Results show Pu to be more readily incorporated into crystalline phases than U or Th under reducing conditions, which is attributed to the observation that Pu exists primarily in the trivalent state, while U and Th are tetravalent. Corrected partition coefficients for whitlockite of 3.6, less than or equal to 0.6, 1.2, 0.5 and less than or equal to 0.002 are estimated for Pu(+3), Pu(+4), Th(+4), U(+4) and U(+6), respectively. Experiments performed at trace levels and percent levels of UO2 indicate that Si is involved in U substitution in whitlockite, and show a reduced partition coefficient at higher concentrations of U that can be explained by effects on melt structure or the fraction of tetravalent U.

Benjamin, T. M.

Actinide crystal-liquid partitioning for clinopyroxene and Ca3/PO4/2

Coefficients for the partitioning of the actinide elements Th, U and Pu, which are used as indicators of r-process nucleosynthesis and the ages of meteorite and lunar samples, between diopsidic clinopyroxene, whitlockite and silicate liquid at 20 kbar are measured. Fission and alpha track radiography techniques are employed to detect element concentrations in synthetic crystals made using spiked starting materials, under the assumptions of equilibrium partitioning at the crystal-liquid interface and actinide zoning. Analysis of the data indicates results to be consistent with interface equilibrium except at high cooling rates. Th/U/Pu partition coefficients of about 0.002/0.002/O.06 are measured for clinopyroxene and 1.2/0.5/3.4 for whitlockite. The greater incorporation of Pu into the crystalline phases is attributed to the importance of trivalent Pu, and the similarity of its partition coefficient into clinopyroxene to that of the light rare earths supports the concept of Pu/rare earth dating.

Benjamin, T.

Laboratory studies of actinide partitioning relevant to 244Pu chronometry

Actinide partitioning and light lanthanide fractionation have been studied to gain an understanding of Pu chemistry under meteoritic and lunar conditions. The goal of the study was to identify conditions and samples from which chronological information can be retrieved. The laboratory investigations involved particle track radiography of the crystal/liquid partitioning of Th, U and Pu among diopsidic clinopyroxene, whitlockite and liquid. It is found that trivalent Pu plays an important role in partitioning for lunar and most meteoritic conditions. The use of Pu/Nd for relative age assessments is supported to some extent by the investigations; samples with unfractionated U, Th and Nd abundances (relative to average solar system values) may be suitable for Pu chronometry.

Benjamin, T.