Engineering Papers⌕ Search

Engineering topics

Hess, Wayne P

Publications and source records attributed to Hess, Wayne P.

Role of Photoexcitation and Field Ionization in the Measurement of Accurate Oxide Stoichiometry by Laser-Assisted Atom Probe Tomography

Pulsed lasers extend the high spatial and mass resolution of atom probe tomography (APT) to non-conducting materials, such as oxides. For prototypical metal oxide MgO, measured stoichiometry depends strongly upon pulse energy and applied voltage. Very low laser energies (0.02 pJ) and high electric fields yield optimal stoichiometric accuracy, attributed to the field-dependent ionization of photo-desorbed O or O2 neutrals. This emphasizes the importance of considering electronic excitations in APT analysis of oxides ionic materials.

Environmental Molecular Sciences Laboratory↗

Plasmonic enhancement of thin-film solar cells using gold-black coatings

Coatings of conducting gold-black nano-structures on commercial thin-film amorphous-silicon solar cells enhance the short-circuit current by 20% over a broad spectrum from 400 to 800 nm wavelength. The efficiency, i.e. the ratio of the maximum electrical output power to the incident solar power, is found to increase 7% for initial un-optimized coatings. Metal blacks are produced cheaply and quickly in a low-vacuum process requiring no lithographic patterning. The inherently broad particle-size distribution is responsible for the broad spectrum enhancement in comparison to what has been reported for mono-disperse lithographically deposited or self-assembled metal nano-particles. Photoemission electron microscopy reveals the spatial-spectral distribution of hot-spots for plasmon resonances, where scattering of normally-incident solar flux into the plane increases the effective optical path in the thin film to enhance light harvesting. Efficiency enhancement is correlated with percent coverage and particle size distribution, which are determined from histogram and wavelet analysis of scanning electron microscopy images. Electrodynamic simulations reveal how the gold-black particles scatter the radiation and locally enhance the field strength.

14 SOLAR ENERGY↗

Exciton-driven highly hyperthermal O-atom desorption from nanostructured CaO

We report qualitatively new highly-hyperthermal (HHT) oxygen atom emission from nanostructured CaO excited by 6.4 eV nanosecond laser pulses. The kinetic energy distribution of emitted O-atoms peaks at 0.7 eV, which is over four times greater than previously observed. Excitation of MgO and CaO nanostructures with UV laser pulses is known to result in thermal and hyperthermal emission of oxygen atoms when photons with energies below and above the band gap, respectively, are used. The highly energetic atomic desorption we observe, following bulk excitation, challenges the conventional view that bulk excitation can only induce thermal desorption. Using density functional theory and an embedded cluster method, we propose a mechanism for this HHT feature based on the interaction of surface holes with bulk excitons. These experimental and theoretical results suggest that specific atomic desorption mechanisms in wide-bandgap materials can be controlled by selective electronic excitation of not only the surface but also the bulk of these materials

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Plasmonic Field Enhancement of Individual Nanoparticles by Correlated Scanning and Photoemission Electron Microscopy

We present results of a combined two-photon photoemission and scanning electron microscopy investigation to determine the electromagnetic enhancement factors of silver-coated spherical nanoparticles deposited on an atomically flat mica substrate. Femtosecond laser excitation, of the nanoparticles, produces intense photoemission, attributed to near-resonant excitation of localized surface plasmons. Enhancement factors are determined by comparing the respective two-photon photoemission yield measured for equal areas between single nanoparticles to that of the surrounding flat surface. For s-polarized, 400 nm (~ 3.1 eV) femtosecond radiation a distribution of enhancement factors are found with a large percentage (77%) of the nanoparticles falling within a median range. A correlated scanning electron microscopy analysis demonstrated that the nanoparticles typifying the median of the distribution were characterized by ideal spherical shapes and defect-free morphologies. The single largest enhancement factors were in contrast produced by a very small percentage (8%) of the total, for which evidence of silver defect anomalies were found that contributed to the overall structure of the nanoparticle. Comparisons are made between the experimentally measured enhancement factors and previously reported theoretical predictions of the localized surface plasmon near-field intensities for isolated nanometer-sized silver spheres.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Materials Applications of Photoelectron Emission Microscopy

Photoelectron emission microscopy (PEEM) is a versatile technique that can image a variety of materials including metals, semiconductors and even insulators. Under favorable conditions the most advanced aberration corrected instruments have a spatial resolution approaching 2 nm. Although PEEM cannot compete with transmission or scanning electron microscopies for ultimate resolution, the technique is much more gentle and has the unique advantage of imaging structure as well as electronic and magnetic states on the nanoscale. Since the image contrast is derived from spatial variations in electron photoemission intensity, PEEM is ideal for interrogating both static and dynamic electronic properties of complex nanostructured materials. PEEM can be performed using a variety of photoexcitation sources including synchrotron emission, femtosecond laser pulses and conventional UV lamp emission. Each source has advantages, for example, fs laser excitation enables time-resolved imaging for study of ultrafast dynamics of surface intermediate states while tunable synchrotron sources allow chemically specific excitation. Even more detail can be extracted from energy resolved PEEM. Here, we review the key principles and contrast mechanisms of PEEM and briefly summarize materials applications of PEEM with examples of a thermally-induced structural phase transformation in barium titanate, inter-diffusion between thin metal copper and ruthenium layers, and multiphoton imaging of polystyrene nanoparticles on a silver coated substrate.

43 PARTICLE ACCELERATORS↗

Surface-Specific Laser Matter Interactions and Dynamics

Neutral magnesium atom desorption is induced using infrared and visible femtosecond laser pulses at energies well below the excitation threshold of the bulk material. We find that infrared femtosecond laser excitation of MgO nanocrystalline samples desorbs neutral Mg-atoms with hyperthermal kinetic energies ranging from 0.1 to 0.6 eV, while visible femtosecond excitation desorbs neutral Mg-atoms with thermal kinetic energies ranging from 0.01 to 0.1 eV. The hyperthermal kinetic energy distribution is similar to the distribution observed previously under nanosecond laser excitation in the ultraviolet. The hyperthermal kinetic energy distribution supports the contention that emission is induced predominantly by electron trapping at Mg corner surface sites. The results demonstrate that femtosecond photon pulses can serve as a powerful tool for probing desorption dynamics at surfaces.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Effect of Surface Charge on Laser-induced Neutral Atom Desorption

When an ionic metal oxide crystal is cleaved, inhomogeneous electrical charging of the surface can be a result. Such an effect has been well-documented in magnesium oxide (100). For example, recent rigorous AFM studies indicate that nanoscale charged clusters of MgO are created during cleavage, with high concentrations often located at terrace step edges.[1] In addition, ablation processes of freshly cleaved magnesium oxide crystals may be effected by remnant surface charging and microstructures.[2] We report here that such surface charging strongly impacts even neutral atom desorption, even under conditions of extremely mild excitation of surface terrace features. In our experiments, single crystal MgO (100) is cleaved in air and placed in an ultra-high vacuum chamber (UHV). We irradiate the crystal at 6.4 eV, photon energy resonant with five-coordinated (5-C) terrace sites and probe desorbing neutral oxygen atoms. It is found that a significant fraction of desorbed neutral oxygen atoms from the charged surface possess kinetic energies in excess of 0.7 eV. This is in contrast to uncharged samples (discharged in vacuo over 24 hours) that display a near-thermal oxygen atom distribution.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Photodesorption of excited iodine atoms from KI (100)

Band-to-band photoexcitation of potassium iodide single crystals with UV photons produces thermal and hyperthermal I-atom emission in both the ground I(2P3/2) and spin orbit excited I*(2P1/2) states. Thermal halogen atom emission is preceded by H-center diffusion from bulk to surface and excited atom emission indicates that the excited hole spin state relaxation is incomplete before H-center diffusion to the surface. The hyperthermal I-atom kinetic energy distribution is inverted in the sense that the electronically excited I*(2P1/2) atoms are more energetic than the ground state I(2P3/2) atoms. The mechanism for hyperthermal emission of halogen atoms and their kinetic energy distributions is discussed in terms of recent calculations and a simple curve crossing model for the dynamical desorption process.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Two-color Laser Desorption of Nanostructured MgO Thin Films

Neutral magnesium atom emission from nanostructured MgO thin films is induced using two-color nanosecond laser excitation. We find that combined visible/UV excitation, for single-color pulse energies below the desorption threshold, induces neutral Mg-atom emission with hyperthermal kinetic energies in the range of 0.1- 0.2 eV. The observed metal atom emission is consistent with a mechanism involving rapid electron transfer to 3-coordinated Mg surface sites. The two-color Mg-atom signal is significant only for parallel laser polarizations and temporally overlapped laser pulses indicating that intermediate excited states are short-lived compared to the 5 nanosecond laser pulse duration.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Excitons in Potassium Bromide: A Study using Embedded Time-dependent Density Functional Theory and Equation-of-Motion Coupled Cluster Methods

We present a study of the electronic excitations in insulating materials using an embedded- cluster method. The excited states of the embedded cluster are studied systematically using time-dependent density functional theory (TDDFT) and high-level equation-of-motion coupled cluster (EOMCC) methods. In particular, we have used EOMCC models with singles and doubles (EOMCCSD) and two approaches which account for the e®ect of triply excited con¯gurations in non-iterative and iterative fashions. We present calculations of the lowest surface excitations of the well-studied potassium bromide (KBr) system and compare our results with experiment. The bulk-surface exciton shift is also calculated at the TDDFT level and compared with experiment.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Photoinduced Formation of Zinc Nanoparticles by UV Laser Irradiation of ZnO

Simple exposure of single-crystal ZnO to 193 11m excimer laser radiation at room temperature results in unexpected coloration. The gray to nearly black colored material. seen principally in the irradiated laser spot, is superficial. We present unambiguous evidence that this coloration is due to high densities of metallic Zn nanoparticles growing on the exposed surface of the crystal. Higher fluence laser exposure generates accumulated surface metal just outside of the irradiated spot. We suggest that the near surface bulk is photodecomposing; thermally driven diffusion leads to surface Zn metal aggregation.

36 MATERIALS SCIENCE↗

Excitation, Ionization, and Desorption: How Sub-band gap Photons Modify the Structure of Oxide Nanoparticles

Nanoparticles of wide-band-gap materials MgO and CaO, subjected to low-intensity ultraviolet irradiation with 266 nm (4.66 eV) photons, emit hyperthermal oxygen atoms with kinetic energies up to ~ 0.4 eV. We use ab initio embedded cluster methods to study theoretically a variety of elementary photoinduced processes at both ideal and defect-containing surfaces of these nanoparticles and develop a mechanism for the desorption process. The proposed mechanism includes multiple local photoexcitations resulting in sequential formation of localized excitons, their ionization, and further excitations. It is suggested that judicious choice of sub-band-gap photon energies can be used to selectively modify surfaces of nanomaterials.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Electronic Energy Transfer on CaO Surfaces

We excite low-coordinated surface sites of nanostructured CaO samples using tunable UV laser pulses and observe hyperthermal O-atom emission indicative of an electronic excited-state desorption mechanism. The O-atom yield increases dramatically with photon energy, between 3.75 and 5.4 eV, below the bulk absorption threshold. The peak of the kinetic energy distribution does not increase with photon energy in the range 3.9 to 5.15 eV. These results are analyzed in the context of a laser desorption model developed previously for nanostructured MgO samples. The data are consistent with desorption induced by exciton localization at corner-hole trapped surface sites following either direct corner excitation or diffusion and localization of excitons from higher coordinated surface sites.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Energy and Site Selectivity in O-Atom Photodesorption from Nanostructured MgO

Electronic excitation of wide gap ionic solids can induce desorption of neutral atoms with distinct hyperthermal and thermal kinetic energy distributions. Hyperthermal atomic desorption results from electronic surface excitation while thermal desorption is initiated primarily by bulk excitation. Calculations indicate that surface-localized transitions can be excited independently from bulk transitions using selected photon energies. The photon energy required to excite specific surface sites depends upon the site coordination with successively lower energies required to excite terrace, step, and corner sites. Here, we excite low-coordinated surface sites of nanostructured MgO samples using 4.7 eV UV laser pulses and observe dominant hyperthermal O-atom emission. We then selectively excite bulk sites of nanostructured MgO, using a 7.9 eV laser, and observe dominant thermal O-atom desorption. These results are analyzed in terms of laser desorption models developed previously for alkali halide crystals. We propose a multi-step mechanism for hyperthermal O-atom desorption, under surface selective excitation, based on hole trapping at 3C (corner) O-atom sites followed by exciton decomposition. The proposed “hole plus exciton” model has similarities to the surface exciton desorption model, established for alkali halides, but is more complex and requires more steps. Nonetheless, the principle of site-specific photoreaction, established for alkali halide crystals, is clearly extendable to a prototypical metal oxide.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗