Engineering topics

Hermann, Raphael P.

Publications and source records attributed to Hermann, Raphael P..

26 records · Page 2

DOE OSTI2021

Oxidation and Associated Pore Structure Modification During Experimental Alteration of Granite

Weathering plays a crucial role in a number of environmental processes, and the microstructure and evolution of multi-scale pore space is a critically important factor in the weathering of geological formations. In igneous rocks the infiltration of meteoric water into initially relatively dry material can cause the rock to begin to disaggregate, increasing porosity and surface area, and allowing further disaggregation and weathering to occur. These processes, in turn, allow biota to colonize the rock, further enhancing the weathering rate. In some igneous rocks this may be driven by oxidation of primary minerals. One such mineral, biotite, has been repeatedly mentioned as a cause of cracking during oxidation. However, the scale-dependence of the processes by which this occurs are poorly understood. We cannot, therefore, accurately extrapolate laboratory reaction rates to the field in predictive numerical models. In order to better understand the effects of oxidation and test the hypothesis that fracture and disaggregation are initiated by swelling of oxidizing biotites, we reacted granite cores in a selenic acid-rich aqueous solution at 200°C for up to 438 days. Elevated temperatures and selenic acid were used to provide relatively fast reaction rates and highly oxidizing conditions in sealed reaction vessels. These experiments were analyzed using a combination of imaging, X-ray diffraction, Mössbauer spectroscopy, and small- and ultra-small angle neutron scattering to interrogate porosity and microfracture formation. The experimental results show little observable biotite swelling, but significant transport and growth of iron oxides and/or clays along grain boundaries throughout the sample. Significant increases in porosity were also observed at the sample rim, likely associated with feldspar alteration. Fractures and transport were observed throughout the core, suggesting that stresses due to crystallization pressures caused by the growing iron phases may be the initiating factors in granite weathering, possibly followed by biotite swelling after sufficient permeability is achieved.

Anovitz, Lawrence M.↗

DOE OSTI2020

High frequency atomic tunneling yields ultralow and glass-like thermal conductivity in chalcogenide single crystals

Crystalline solids exhibiting glass-like thermal conductivity have attracted substantial attention both for fundamental interest and applications such as thermoelectrics. In most crystals, the competition of phonon scattering by anharmonic interactions and crystalline imperfections leads to a non-monotonic trend of thermal conductivity with temperature. Defect-free crystals that exhibit the glassy trend of low thermal conductivity with a monotonic increase with temperature are desirable because they are intrinsically thermally insulating while retaining useful properties of perfect crystals. However, this behavior is rare, and its microscopic origin remains unclear. Here, we report the observation of ultralow and glass-like thermal conductivity in a hexagonal perovskite chalcogenide single crystal, BaTiS 3 , despite its highly symmetric and simple primitive cell. Elastic and inelastic scattering measurements reveal the quantum mechanical origin of this unusual trend. A two-level atomic tunneling system exists in a shallow double-well potential of the Ti atom and is of sufficiently high frequency to scatter heat-carrying phonons up to room temperature. While atomic tunneling has been invoked to explain the low-temperature thermal conductivity of solids for decades, our study establishes the presence of sub-THz frequency tunneling systems even in high-quality, electrically insulating single crystals, leading to anomalous transport properties well above cryogenic temperatures.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Temperature-dependent lattice dynamics in iridium

The characterization of simple elemental systems is key to benchmarking first-principles modeling of electronic and vibrational behaviors of materials. A large body of literature has been built for most elemental systems in the periodic table. However, surprisingly little neutron work has been performed to probe the vibrational properties of iridium, likely due to its large neutron absorption cross section. Nonetheless, iridium is of significant scientific and technological interest due to large relativistic electron effects and electron-phonon coupling, particularly in strongly correlated iridate compounds. In this paper, we report temperature-dependent inelastic neutron scattering measurements of the vibrational properties of iridium, from which we extract key thermodynamic properties. To overcome the challenge of the large neutron absorption of iridium, we developed a simple post-processing correction procedure. The measured densities of phonon states compare well with quasiharmonic density functional theory calculations, although the obtained experimental phonon Grüneisen parameters are much larger than expected, reaching as high as γ=4.5, indicating substantial anharmonicity.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Phonon Spectroscopy in Antimony and Tellurium Oxides

α-Sb 2 O 3 (senarmontite), β-Sb 2 O 3 (valentinite), and α-TeO 2 (paratellurite) are compounds with pronounced stereochemically active Sb and Te lone pairs. The vibrational and lattice properties of each have been previously studied but often lead to incomplete or unreliable results due to modes being inactive in infrared or Raman spectroscopy. Here in this paper, we present a study of the relationship between bonding and lattice dynamics of these compounds. Mössbauer spectroscopy is used to study the structure of Sb in α-Sb 2 O 3 and β-Sb 2 O 3 , whereas the vibrational modes of Sb and Te for each oxide are investigated using nuclear inelastic scattering, and further information on O vibrational modes is obtained using inelastic neutron scattering. Additionally, vibrational frequencies obtained by density functional theory (DFT) calculations are compared with experimental results in order to assess the validity of the utilized functional. Good agreement was found between DFT-calculated and experimental density of phonon states with a 7% scaling factor. The Sb–O–Sb wagging mode of α-Sb 2 O 3 whose frequency was not clear in most previous studies is experimentally observed for the first time at ~340 cm -1 . Softer lattice vibrational modes occur in orthorhombic β-Sb 2 O 3 compared to cubic α-Sb 2 O 3 , indicating that the antimony bonds are weakened upon transforming from the molecular α phase to the layer-chained β structure. The resulting vibrational entropy increase of 0.45 ± 0.1 kB/Sb 2 O 3 at 880 K accounts for about half of the α–β transition entropy. The comparison of experimental and theoretical approaches presented here provides a detailed picture of the lattice dynamics in these oxides beyond the zone center and shows that the accuracy of DFT is sufficient for future calculations of similar material structures.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Structure and electronic properties of CaAl 12₋x Fe x O19 hibonites

Dilution of iron in the AM 12 O 19 has shown promising coupling of magnetic and electric properties in the hexaferrites. In this study, we have prepared samples of low iron content in the isostructural hibonite, CaAl 12 -x Fe x O 19 , to investigate the structural effects of larger iron substitution into the aluminum sites and the resultant properties. We found a solid solution exists for CaAl 12 -x Fe x O 19 where x ≤ 5 . 5. Iron distributes into all sites with the tetrahedral M3 and octahedral M5 sites displaying nominally larger preference at higher Fe content. Paramagnetic behavior was observed for x = 1-3, while x = 4-5.5 displayed a broad ferromagnetic-like transition with increasing Curie temperature. Differences in field-cooled and zero-field-cooled magnetic susceptibility measurements and low magnetic moment indicate the presence of a frustrated antiferromagnetic structure as the source of the ferromagnetic-like behavior. Increasing Fe content also increases the dielectric constant up to 21 at room temperature with high dielectric loss.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

The Fe 4+ / 3+ Redox Mechanism in NaFeO 2 : A Simultaneous Operando Nuclear Resonance and X-ray Scattering Study

Simultaneous operando Nuclear Forward Scattering and transmission X-ray diffraction and 57 Fe Mössbauer spectroscopy measurements were carried out in order to investigate the electrochemical mechanism of NaFeO 2 vs. Na metal using a specifically designed in situ cell. The obtained data were analysed using an alternative and innovative data analysis approach based on chemometric tools such as Principal Component Analysis (PCA) and Multivariate Curve Resolution - Alternating Least Squares (MCR-ALS). This approach, which allows the unbiased extraction of all possible information from the operando data, enabled the stepwise reconstruction of the independent “real” components permitting the description of the desodiation mechanism of NaFeO 2 . This wealth of information allows a clear description of the electrochemical reaction at the redox-active iron centres, and thus an improved comprehension of the cycling mechanisms of this material vs. sodium.

25 ENERGY STORAGE↗

DOE OSTI2020

Lithium Iron Aluminum Nickelate, LiNi x Fe y Al z O 2 —New Sustainable Cathodes for Next–Generation Cobalt–Free Li–Ion Batteries

In recent years, cobalt has become a critical constraint on the supply chain of the Li-ion battery industry. Here, with the ever-increasing projections for electric vehicles, the dependency of current Li-ion batteries on the ever-fluctuating cobalt prices poses serious environmental and sustainability issues. To address these challenges, a new class of cobalt-free materials with general formula of LiNi x Fe y Al z O 2 ( x + y + z = 1), termed as the lithium iron aluminum nickelate (NFA) class of cathodes, is introduced. These cobalt-free materials are synthesized using the sol–gel process to explore their compositional landscape by varying aluminum and iron. These NFA variants are characterized using electron microscopy, neutron and X-ray diffraction, and Mössbauer and X-ray photoelectron spectroscopy to investigate their morphological, physical, and crystal-structure properties. Operando experiments by X-ray diffraction, Mössbauer spectroscopy, and galvanostatic intermittent titration have been also used to study the crystallographic transitions, electrochemical activity, and Li-ion diffusivity upon lithium removal and uptake in the NFA cathodes. NFA compositions yield specific capacities of ≈200 mAh g -1 , demonstrating reasonable rate capability and cycling stability with ≈80% capacity retention after 100 charge/discharge cycles. While this is an early stage of research, the potential that these cathodes could have as viable candidates in next-generation cobalt-free lithium-ion batteries is highlighted here.

25 ENERGY STORAGE↗

DOE OSTI2020

LiNi x Fe y Al z O 2 , a new cobalt-free layered cathode material for advanced Li-ion batteries

Recently, rapid fluctuations in cobalt prices have created a worsening supply chain constraint that has become a serious cause of concern amidst global battery manufacturers. To address this challenge, we report herein a new class of cobalt-free, nickel-rich layered cathode material termed the NFA class with general formula LiNi x Fe y Al z O 2 (x + y + z = 1). Using co-precipitation reaction in a continuous stirred tank reactor, we synthesized NFA(OH) 2 precursors with the constituent Ni, Fe and Al elements successfully incorporated. The obtained LiNFAO 2 cathode was characterized using X-Ray diffraction, Mössbauer spectroscopy and scanning electron microscopy. Electrochemical behavior was assessed using cyclic voltammetry, galvanostatic charge/discharge, electrochemical impedance spectroscopy and galvanostatic intermittent titration technique at various states of lithiation/delithiation. Electrochemical performance evaluations revealed that our cobalt-free material delivers high capacity of 190 mAh/g at 0.1C. Rate and cycling performance evaluations also indicated good rate capability and cycling stability with 88% capacity retention after 100 cycles at C/3. Using NFA cathodes, we also fabricated a 0.5Ah (C/3) cobalt-free Li-ion battery which demonstrated reasonable cycling stability with ~72% capacity retained after 200 cycles. Overall, our work demonstrates the immense potential of the cobalt-free NFA class cathodes as viable candidates towards development of next generation cost effective lithium ion batteries.

25 ENERGY STORAGE↗