Engineering Papers⌕ Search

Engineering topics

Hemsch, Michael J.

Publications and source records attributed to Hemsch, Michael J..

33 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1996

Development and status of data quality assurance program at NASA Langley research center: Toward national standards

As part of a continuing effort to re-engineer the wind tunnel testing process, a comprehensive data quality assurance program is being established at NASA Langley Research Center (LaRC). The ultimate goal of the program is routing provision of tunnel-to-tunnel reproducibility with total uncertainty levels acceptable for test and evaluation of civilian transports. The operational elements for reaching such levels of reproducibility are: (1) statistical control, which provides long term measurement uncertainty predictability and a base for continuous improvement, (2) measurement uncertainty prediction, which provides test designs that can meet data quality expectations with the system's predictable variation, and (3) national standards, which provide a means for resolving tunnel-to-tunnel differences. The paper presents the LaRC design for the program and discusses the process of implementation.

Hemsch, Michael J.↗
NASA NTRS1995

Measurements of store forces and moments and cavity pressures for a generic store in and near a box cavity at subsonic and transonic speeds

An experimental force and moment study was conducted in the Langley 8-Foot Transonic Pressure Tunnel for a generic store in and near rectangular box cavities contained in a flat-plate configuration at subsonic and transonic speeds. Surface pressures were measured inside the cavities and on the flat plate. The length-to-height ratios were 5.42, 6.25, 10.83, and 12.50. The corresponding width-to-height ratios were 2.00, 2.00, 4.00, and 4.00. The free-stream Mach number range was from 0.20 to 0.95. Surface pressure measurements inside the cavities indicated that the flow fields for the shallow cavities were either closed or transitional near the transitional/closed boundary. For the deep cavities, the flow fields were either open or near the open/transitional boundary. The presence of the store did not change the type of flow field and had only small effects on the pressure distributions. For transitional or open transitional flow fields, increasing the free-stream Mach number resulted in large reductions in pitching-moment coefficient. Values of pitching-moment coefficient were always much greater for closed flow fields than for open flow fields.

Stallings, Robert L., Jr.↗
NASA NTRS1992

Component build-up method for engineering analysis of missiles at low-to-high angles of attack

Methods are presented for estimating the component build-up terms, with the exception of zero-lift drag, for missile airframes in steady flow and at arbitrary angles of attack and bank. The underlying and unifying bases of all these efforts are slender-body theory and its nonlinear extensions through the equivalent angle-of-attack concept. Emphasis is placed on the forces and moments which act on each of the fins, so that control cross-coupling effects as well as longitudinal and lateral-directional effects can be determined.

Hemsch, Michael J.↗
NASA NTRS1992

Alleviation of side force on tangent-ogive forebodies using passive porosity

An experimental investigation to determine the effectiveness of porosity for alleviating side forces on forebodies was conducted in the NASA Langley Research Center 7 x 10 ft High-Speed Wind Tunnel. The study consisted of a comparison of experimental force, moment, and surface pressure results obtained on a fineness ratio 5.0 tangent-ogive porous forebody with 0.020 in. hole diameter and 22 percent porosity with results obtained on a solid forebody. The forebodies were tested with cylindrical afterbodies. The solid forebody was tested with transition grit to simulate fully turbulent conditions and without transition grit to simulate free transition conditions. The extent of porosity on the forebody was varied to determine the extent of porosity needed to alleviate side forces. Static longitudinal and lateral-directional stability and surface pressure data were obtained at Mach numbers of 0.2, 0.5, and 0.8. The angle of attack range was from 5 to 45 deg and roll angles from -90 to 180 deg. The solid forebody exhibited large asymmetries at moderate to high angles of attack causing large side forces and yawing moments. The porous forebody exhibited no significant side forces or yawing moments at any angle of attack tested.

Bauer, Steven X. S.↗
NASA NTRS1990

Comparison of high-angle-of-attack slender-body theory and exact solutions for potential flow over an ellipsoid

The accuracy of high-alpha slender-body theory (HASBT) for bodies with elliptical cross-sections is presently demonstrated by means of a comparison with exact solutions for incompressible potential flow over a wide range of ellipsoid geometries and angles of attack and sideslip. The addition of the appropriate trigonometric coefficients to the classical slender-body theory decomposition yields the formally correct HASBT, and results in accuracies previously considered unattainable.

Hemsch, Michael J.↗
NASA NTRS1990

Connection between leading-edge sweep, vortex lift, and vortex strength for delta wings

An effort is made to clarify the effect of leading-edge sweep on the vortex lift and leading-edge vortex strength of a slender wing; while it is often assumed that increasing sweep enhances vortex lift and strength, the opposite is the case. The suction analogy is used in association with numerical and experimental data to derive simple formulas yielding the actual relationship for delta wings. The difference between vortex lift and nonlinear lift is highlighted.

Hemsch, Michael J.↗
NASA NTRS1990

Navier-Stokes computations of vortex asymmetries controlled by small surface imperfections

Navier-Stokes analyses are employed to explore the driving mechanisms controlling asymmetric vortical flows with Re(D) = 0.8 million (Reynolds number based on maximum diameter) over a 3.5 caliber tangent-ogive cylinder at large angles of attack (alpha = 20, 30, and 40 degrees). All flowfield results are steady-state solutions to the three-dimensional, incompressible Navier-Stokes equations in the thin-layer approximation. The numerical results are temporally and spatially fully converged, and are in good agreement with experimental data. The major findings are: (1) for alpha not less than 30 degrees, the vortex flows are genuinely asymmetric yet recurrent; (2) asymmetric vortex patterns are highly sensitive toward such parameters as machine accuracy, grid topology, etc., unless triggered by a slight deformation (similar to an out-of-round nose tip) in the neighborhood of the apex; and (3) for alpha = 20 degrees, the flow is symmetric for both circular and elliptic cross-sectional shapes of the nose tip.

Hartwich, PETER-M.↗
NASA NTRS1989

An improved, robust, axial line singularity method for bodies of revolution

The failures encountered in attempts to increase the range of applicability of the axial line singularity method for representing incompressible, inviscid flow about an inclined and slender body-of-revolution are presently noted to be common to all efforts to solve Fredholm equations of the first kind. It is shown that a previously developed smoothing technique yields a robust method for numerical solution of the governing equations; this technique is easily retrofitted to existing codes, and allows the number of circularities to be increased until the most accurate line singularity solution is obtained.

Hemsch, Michael J.↗
NASA NTRS1987

Aerodynamic characteristics of cruciform missiles at high angles of attack

An aerodynamic prediction method for missile aerodynamic performance and preliminary design has been developed to utilize a newly available systematic fin data base and an improved equivalent angle of attack methodology. The method predicts total aerodynamic loads and individual fin forces and moments for body-tail (wing-body) and canard-body-tail configurations with cruciform fin arrangements. The data base and the prediction method are valid for angles of attack up to 45 deg, arbitrary roll angles, fin deflection angles between -40 deg and 40 deg, Mach numbers between 0.6 and 4.5, and fin aspect ratios between 0.25 and 4.0. The equivalent angle of attack concept is employed to include the effects of vorticity and geometric scaling.

Lesieutre, Daniel J.↗
NASA NTRS1987

Engineering analysis of slender-body aerodynamics using Sychev similarity parameters

The similarity parameters deduced by Sychev for inviscid hypersonic flow over slender bodies are reviewed and used to correlate flowfield, surface-pressure, normal-force and center-of-pressure data for supersonic flow over thin slender wings and smooth slender bodies at low-to-high angles of attack. Although Sychev expected similarity to hold only for hypersonic freestream and cross flows, it is demonstrated empirically that similarity holds for any value of cross-flow Mach number if the axial flow component is supersonic. It is also shown for thin wings that similarity holds for much larger values of aspect ratio than Sychev supposed. A one-term power-law expression is found to fit all of the normal-force correlations which suggests that it may be possible to develop a simple semi-empirical method for estimating the aerodynamic characteristics of arbitrary slender airframes.

Hemsch, Michael J.↗
NASA NTRS1987

Recent advances in the nonlinear aerodynamics of tactical missiles

It is suggested that nonlinear extensions of the slender-body theory may be of use in obtaining simple nonlinear models for missile aerodynamics. It is pointed out that the transonic equivalence rule and the slender-body theory are nearly identical; the difference is that the flow around the equivalent body is governed by the nonlinear small-disturbance equation rather than by the linear Prandtl-Glauert equation. Five examples of nonlinear extensions of the slender-body theory are presented.

Hemsch, Michael J.↗
NASA NTRS1986

Tactical missile aerodynamics

The present conference on tactical missile aerodynamics discusses autopilot-related aerodynamic design considerations, flow visualization methods' role in the study of high angle-of-attack aerodynamics, low aspect ratio wing behavior at high angle-of-attack, supersonic airbreathing propulsion system inlet design, missile bodies with noncircular cross section and bank-to-turn maneuvering capabilities, 'waverider' supersonic cruise missile concepts and design methods, asymmetric vortex sheding phenomena from bodies-of-revolution, and swept shock wave/boundary layer interaction phenomena. Also discussed are the assessment of aerodynamic drag in tactical missiles, the analysis of supersonic missile aerodynamic heating, the 'equivalent angle-of-attack' concept for engineering analysis, the vortex cloud model for body vortex shedding and tracking, paneling methods with vorticity effects and corrections for nonlinear compressibility, the application of supersonic full potential method to missile bodies, Euler space marching methods for missiles, three-dimensional missile boundary layers, and an analysis of exhaust plumes and their interaction with missile airframes.

Hemsch, Michael J.↗