Engineering Papers⌕ Search

Engineering topics

Hemmati, Hamid

Publications and source records attributed to Hemmati, Hamid.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS2006

Simplified Optics and Controls for Laser Communications

A document discusses an architecture of a spaceborne laser communication system that provides for a simplified control subsystem that stabilizes the line of sight in a desired direction. Heretofore, a typical design for a spaceborne laser communication system has called for a high-bandwidth control loop, a steering mirror and associated optics, and a fast steering-mirror actuator to stabilize the line of sight in the presence of vibrations. In the present architecture, the need for this fast steering-mirror subsystem is eliminated by mounting the laser-communication optics on a disturbance-free platform (DFP) that suppresses coupling of vibrations to the optics by 60 dB. Taking advantage of microgravitation, in the DFP, the optical assembly is free-flying relative to the rest of the spacecraft, and a low-spring-constant pointing control subsystem exerts small forces to regulate the position and orientation of the optics via voice coils. All steering is effected via the DFP, which can be controlled in all six degrees of freedom relative to the spacecraft. A second control loop, closed around a position sensor and the spacecraft attitude-control system, moves the spacecraft as needed to prevent mechanical contact with the optical assembly.

Chen, Chien-Chung↗
NASA NTRS2006

Simplified Lasercom System Architecture Using a Disturbance-Free Platform

A simplified laser communications (lasercom) system architecture, primarily for a deep-space flight transceivers, can be realized by decoupling the lasercom optical components from the host spacecraft using a disturbance-free platform (DFP) developed by Lockheed Martin Space System Company. Unlike conventional lasercom system architectures where a high bandwidth control loop is used to stabilize the optical line-of-sight in the presence of platform disturbance, the DFP package isolates the optical train from the high frequency platform jitter produced by the host. By preventing the vibration from coupling into the optics train, the need for a high bandwidth beam stabilization control loop (including fast steering mirror, detectors, controls and the associated relay optics) is eliminated with possible mass savings.

deep space↗
NASA NTRS2005

Optical Design of an Optical Communications Terminal

An optical communications terminal (OCT) is being developed to enable transmission of data at a rate as high as 2.5 Gb/s, from an aircraft or spacecraft to a ground station. In addition to transmitting high data rates, OCT will also be capable of bidirectional communications.

Biswas, Abhijit↗
NASA NTRS2005

Earth-Image Tracking in the IR for Deep Space Optical Communications

Sub-microradian level laser beam pointing to an Earth-based receiver is required for deep space optical communications. This requires a beacon emanated from Earth towards the spacecraft. The beacon could be a laser or reflected sunlight from Earth. Earth image tracking in the visible is hampered by significant albedo variations and/or crescent Earth image yielding large central errors. Here, we report results of Earth-image tracking in the infrared (8 to 13 micron) region of the spectrum with the aim of substantially alleviating the two challenges mentioned earlier.

earth image tracking↗
NASA NTRS2005

Assessment of Free-Space Lasercomm for DOD's T and E Applications

For test and evaluation of airplanes, it is desirable to telemeter large volumes of data to the ground. This telemetry has generally utilized W communication systems, which have relatively low data rates, and, due to limited spectrum availability, imposes limitations on the number of simultaneous communications in a given region. Appropriate application of optical communication technology is expected to provide higher data rate capability without the spectrum limitations of W systems, facilitating simultaneous telemetry of more data from a greater number of aircraft. This paper reviews our recent brief study to assess the insertion of free space lasercom to DOD Test and Evaluation applications.

earth image tracking↗
NASA NTRS2005

Integrated Network Architecture for Sustained Human and Robotic Exploration

The National Aeronautics and Space Administration (NASA) Exploration Systems Enterprise is planning a series of human and robotic missions to the Earth's moon and to Mars. These missions will require communication and navigation services. This paper1 sets forth presumed requirements for such services and concepts for lunar and Mars telecommunications network architectures to satisfy the presumed requirements. The paper suggests that an inexpensive ground network would suffice for missions to the near-side of the moon. A constellation of three Lunar Telecommunications Orbiters connected to an inexpensive ground network could provide continuous redundant links to a polar lunar base and its vicinity. For human and robotic missions to Mars, a pair of areostationary satellites could provide continuous redundant links between Earth and a mid-latitude Mars base in conjunction with the Deep Space Network augmented by large arrays of 12-m antennas on Earth.

robotics↗
NASA NTRS2005

Integrated network architecture for sustained human and robotic exploration

The National Aeronautics and Space Administration (NASA) Exploration Systems Mission Directorate is planning a series of human and robotic missions to the Earth's moon and to Mars. These missions will require telecommunication and navigation services. This paper sets forth presumed requirements for such services and presents strawman lunar and Mars telecommunications network architectures to satisfy the presumed requirements.

network architecture human robotic sustained explo↗
NASA NTRS2005

Large diameter refractive Fresnel lenses as low-cost optical communication ground receiver aperture

Feasibility of utilizing large diameter custom designed and fabricated Fresnel lenses as the front optical aperture for Earth-based reception of optical communication signals from remote spacecraft is investigated. This includes preliminary optical designs, investigation of stray-light effects for a particular optical design, effect of temperature variations and mechanical sag on the performance of the photon bucket, and effect of temporal dispersion on the link performance. Experimental results for several commercial off-the-shelf Fresnel lenses with diameters exceeding 1-meter are presented as well as plans for custom diamond turning fabrication of two-meter diameter Fresnel lenses.

Hemmati, Hamid↗
NASA NTRS2005

Telescope Wavefront Aberration Compensation with a Deformable Mirror in an Adaptive Optics System

With the goal of reducing the surface wavefront error of low-cost multi-meter-diameter mirrors from about 10 waves peak-to-valley (P-V), at lpm wavelength, to approximately 1-wave or less, we describe a method to compensate for slowly varying wavefront aberrations of telescope mirrors. A deformable mirror is utilized in an active optical compensation system. The kMS wavefront error of a 0.3m telescope improved to 0.05 waves (0.26 waves P-V) from the original value of 1.4 waves RMS (6.5 waves P-V), measured at 633nm, and the Strehl ratio improved to 89% from the original value of 0.08%.

active optics↗
NASA NTRS2004

Fresnel Lenses for Wide-Aperture Optical Receivers

Wide-aperture receivers for freespace optical communication systems would utilize Fresnel lenses instead of conventional telescope lenses, according to a proposal. Fresnel lenses weigh and cost much less than conventional lenses having equal aperture widths. Plastic Fresnel lenses are commercially available in diameters up to 5 m large enough to satisfy requirements for aperture widths of the order of meters for collecting sufficient light in typical long-distance free-space optical communication systems. Fresnel lenses are not yet suitable for high-quality diffraction-limited imaging, especially in polychromatic light. However, optical communication systems utilize monochromatic light, and there is no requirement for high-quality imaging; instead, the basic requirement for an optical receiver is to collect the incoming monochromatic light over a wide aperture and concentrate the light onto a photodetector. Because of lens aberrations and diffraction, the light passing through any lens is focused to a blur circle rather than to a point. Calculations for some representative cases of wide-aperture non-diffraction-limited Fresnel lenses have shown that it should be possible to attain blur-circle diameters of less than 2 mm. Preferably, the blur-circle diameter should match the width of the photodetector. For most high-bandwidth communication applications, the required photodetector diameters would be about 1 mm. In a less-preferable case in which the blur circle was wider than a single photodetector, it would be possible to occupy the blur circle with an array of photodetectors. As an alternative to using a single large Fresnel lens, one could use an array of somewhat smaller lenses to synthesize the equivalent aperture area. Such a configuration might be preferable in a case in which a single Fresnel lens of the requisite large size would be impractical to manufacture, and the blur circle could not be made small enough. For example one could construct a square array of four 5-m-diameter Fresnel lenses to obtain the same light-collecting area as that of a single 10-m-diameter lens. In that case (see figure), the light collected by each Fresnel lens could be collimated, the collimated beams from the four Fresnel lenses could be reflected onto a common offaxis paraboloidal reflector, and the paraboloidal reflector would focus the four beams onto a single photodetector. Alternatively, detected signal from each detector behind each lens would be digitized before summing the signals.

Hemmati, Hamid↗
NASA NTRS2003

Optical space communications at JPL

Subsytem and system level technology development at JPL for free-space laser communications from both deep space and near Earth is described. These include acquisition, tracking, and pointing, laser transmitters, photon-counting receivers, coding, modulation, and communication systems.

laser transmitter↗
NASA NTRS2003

Optical systems for free-space laser communications

An overview of optical systems utilized in JPL's Optical Communications research is provided here. These include discussions on the flight terminal optics, the ground receiver aperture and the uplink beacon or command optical system. On-going efforts on these and beam-coupling techniques will be described.

Hemmati, Hamid↗
NASA NTRS2003

Efficient Coupling of Lasers to Telescopes with Obscuration

Two techniques have been proposed to increase the efficiency of coupling of light from lasers to Cassegrain telescopes and, in general, telescopes with secondary or tertiary mirror obscuration. The need to increase the efficiency of coupling arises in laser transmitters of lidar and freespace optical communication systems that utilize Cassegrain telescopes. The vignetting caused by the secondary reflector and baffle in such a telescope reduces the transmitted power by a large fraction because (1) the obscured area is central and is a significant fraction of the telescope aperture and (2) the cross-sectional intensity profile of a typical laser beam is Gaussian, so that intensity is greatest in the obscured central area. In a technique proposed previously for increasing the efficiency of coupling, an optical assembly comprising an axicon device and a folding mirror that would render the solid laser beam annular - in effect, turning the laser beam inside out - so that the laser light would be concentrated into an annular cross section that would not be obscured by the secondary reflector and baffle. Hence, most or all of the light would be coupled into the output beam. Another prior efficiency-enhancing technique is denoted subaperture illumination. In this technique, the laser beam is displaced laterally with respect to the optical axis of the secondary reflector, such that the beam impinges on an off-axis subaperture of the primary reflector that is not obscured by the secondary reflector and baffle.

Hemmati, Hamid↗
NASA NTRS2003

Laser Ranging Simulation Program

Laser Ranging Simulation Program (LRSP) is a computer program that predicts selected aspects of the performances of a laser altimeter or other laser ranging or remote-sensing systems and is especially applicable to a laser-based system used to map terrain from a distance of several kilometers. Designed to run in a more recent version (5 or higher) of the MATLAB programming language, LRSP exploits the numerical and graphical capabilities of MATLAB. LRSP generates a graphical user interface that includes a pop-up menu that prompts the user for the input of data that determine the performance of a laser ranging system. Examples of input data include duration and energy of the laser pulse, the laser wavelength, the width of the laser beam, and several parameters that characterize the transmitting and receiving optics, the receiving electronic circuitry, and the optical properties of the atmosphere and the terrain. When the input data have been entered, LRSP computes the signal-to-noise ratio as a function of range, signal and noise currents, and ranging and pointing errors.

Piazolla, Sabino↗
NASA NTRS1999

Semi-monolithic cavity for external resonant frequency doubling and method of performing the same

The fabrication of an optical cavity for use in a laser, in a frequency doubling external cavity, or any other type of nonlinear optical device, can be simplified by providing the nonlinear crystal in combination with a surrounding glass having an index of refraction substantially equal to that of the nonlinear crystal. The closed optical path in this cavity is formed in the surrounding glass and through the nonlinear crystal which lies in one of the optical segments of the light path. The light is transmitted through interfaces between the surrounding glass in the nonlinear crystal through interfaces which are formed at the Brewster-angle to minimize or eliminate reflection.

Hemmati, Hamid↗
NASA NTRS1999

Development of Prototype Micro-Lidar using Narrow Linewidth Semiconductor Lasers for Mars Boundary Layer Wind and Dust Opacity Profiles

We have developed a compact Doppler lidar concept which utilizes recent developments in semiconductor diode laser technology in order to be considered suitable for wind and dust opacity profiling in the Mars lower atmosphere from a surface location. The current understanding of the Mars global climate and meteorology is very limited, with only sparse, near-surface data available from the Viking and Mars Pathfinder landers, supplemented by long-range remote sensing of the Martian atmosphere. The in situ measurements from a lander-based Doppler lidar would provide a unique dataset particularly for the boundary layer. The coupling of the radiative properties of the lower atmosphere with the dynamics involves the radiative absorption and scattering effects of the wind-driven dust. Variability in solar irradiance, on diurnal and seasonal time scales, drives vertical mixing and PBL (planetary boundary layer) thickness. The lidar data will also contribute to an understanding of the impact of wind-driven dust on lander and rover operations and lifetime through an improvement in our understanding of Mars climatology. In this paper we discuss the Mars lidar concept, and the development of a laboratory prototype for performance studies, using, local boundary layer and topographic target measurements.

Menzies, Robert T.↗
NASA NTRS1999

Design of a 2.5 Gbps Optical Transmitter for the International Space Station

A high data rate laser transmitter assembly (LTA) has been designed as the source for an optical free-space communication link between the International Space Station and the 1-meter Optical Communication Telescope Laboratory (OCTL) to be built at the Table Mountain Facility (IMF, Wrightwood, CA). The transmitter design concept uses a fiber-based master oscillator power amplifier (MOPA) configuration with an average output power of 200 made at a 1550 nm transmit wavelength. This transmitter source is also designed to provide a signal at 980 nm to the Silicon-based focal plane array for the point-ahead beam control function. This novel integration of a 980 nm boresight signal allows the use of Silicon based imagers for the acquisition/tracking and point-ahead functions, yet permits the transmit signal to be at any wavelength outside the Silicon sensitivity. The LTA, a sub-system of the Flight Terminal, has been designed to have a selectable data rate from 155 - 2500 Mbps in discrete steps. It also incorporates a 2.5 Gbps pseudo-random bit sequence (PRBS) generator for complete link testing and diagnostics. The design emphasizes using commercial off the shelf components (COTS).

Ortiz, Gerardo G.↗