Engineering PapersSearch

Engineering topics

Heidtmann, D. L.

Publications and source records attributed to Heidtmann, D. L..

Effects of transistor geometry on CCD output sensitivity

This paper discusses recent progress in the understanding of the fabrication of low noise floating diffusion output amplifiers for special purpose charge-coupled devices. Emphasis has been given to reducing the total node capacitance and increasing the output sensitivity. Measurements of noise on experimental devices has yielded noise less than 3 electrons rms at 50 kpixel data rate.

Kim, H.

A quadrant-CCD star tracker

The characteristics of a quadrant-CCD designed for pointing and tracking are discussed with reference to its use in an adaptive optics program. The quadrant-CCD is used to correct stellar image motion proceeding from atmospheric turbulence by means of a system in which a sensor measures the image offset and sends data to a high-speed tip/tilt mirror. The design and control of the device are detailed, including four 100-micron-square pixels, the quadrant architecture, controller electronics, and data acquisition computer and interface. The transfer function is set forth in the x and y directions, and transfer curves are shown. A laboratory simulation of random image motion was conducted to evaluate the performance of the quadrant-CCD as an image motion sensor, and the experimental results are presented. The suitability of the quadrant-CCD for space-based pointing and tracking uses is demonstrated by this test and two earlier theoretical studies. Some future developments which improve performance capabilities are mentioned.

Clampin, M.

Large area CCD image sensors for scientific applications

The designs of the 512 x 512 pixel and 2048 x 2048 pixel CCD sensors developed for scientific imaging are described. Both sensors are manufactured using the three phase, three level polysilicon gate technology, and the architecture of the chips is series-parallel-series. The components of the two different on-chip amplifiers are examined. The sensors are thinned and operated in the back side illumination mode to ensure the highest quantum efficiency. The performances of a number of front side illuminated devices and two thinned rear illuminated chips are evaluated. It is observed that the sensors equal or exceed their proposed charge transfer efficiency of 0.99999, the noise level of 2 e- and 20 e- at 50 kp/s, the quantum efficiency of 40 percent at 400 microns and 70 percent at 700 microns, and of the well capacity of greater than 500 ke-/pixel.

Blouke, M. M.