Engineering PapersSearch

Engineering topics

Heffner, P.

Publications and source records attributed to Heffner, P..

Advanced technology for earth observation - Data processing

The Experimental Land Observing System (ELOS) is to demonstrate major advances in space-based land observation. Program success will depend upon successful demonstration of both space-segment performance and ground-system capabilities. Increases in data-rate, volume, and processing requirements present substantial challenges to the ground data processing system. ELOS is based on the utilization of the multispectral linear array (MLA) sensor, a solid-state, electronically scanned instrument. Current MLA instrument designs offer a number of capabilities beyond those provided in the Landsat imaging devices. These capabilities include greater resolution, inherent registration, onboard calibration, off-nadir pointing capability, and fore/aft pointing capability. The proposed MLA flight mission scenario will be one of continued growth and will include flights on the Space Transportation System. Attention is also given to ground-to-ground data transport, data capture, and the use of high speed computers.

Heffner, P.

Bit error rate performance of Image Processing Facility high density tape recorders

The Image Processing Facility at the NASA/Goddard Space Flight Center uses High Density Tape Recorders (HDTR's) to transfer high volume image data and ancillary information from one system to another. For ancillary information, it is required that very low bit error rates (BER's) accompany the transfers. The facility processes about 10 to the 11th bits of image data per day from many sensors, involving 15 independent processing systems requiring the use of HDTR's. When acquired, the 16 HDTR's offered state-of-the-art performance of 1 x 10 to the -6th BER as specified. The BER requirement was later upgraded in two steps: (1) incorporating data randomizing circuitry to yield a BER of 2 x 10 to the -7th and (2) further modifying to include a bit error correction capability to attain a BER of 2 x 10 to the -9th. The total improvement factor was 500 to 1. Attention is given here to the background, technical approach, and final results of these modifications. Also discussed are the format of the data recorded by the HDTR, the magnetic tape format, the magnetic tape dropout characteristics as experienced in the Image Processing Facility, the head life history, and the reliability of the HDTR's.

Heffner, P.

Flexible high-resolution film recorder system

The paper describes a high-resolution film recorder (HRFR) system capable of meeting the requirements of all of the imaging sensors for the recording support of NASA missions. The technical requirements imposed by sensor constraints and end users of the film product are examined, along with the implementation techniques to satisfy these requirements. The recorder can produce annotated imagery with array sizes ranging from 1 to 400 million picture elements and a programmable radiometric transfer function provided by the recorder. The HRFR requirements were grouped into three categories: (1) front end (input) requirements defined by the input medium, (2) operational requirements based on the volume, throughput, and changeover time from one mode to another, and (3) film product requirements determined by the needs of the end product user.

Heffner, P.

High data volume and transfer rate techniques used at NASA's image processing facility

Data storage and transfer operations at a new image processing facility are described. The equipment includes high density digital magnetic tape drives and specially designed controllers to provide an interface between the tape drives and computerized image processing systems. The controller performs the functions necessary to convert the continuous serial data stream from the tape drive to a word-parallel blocked data stream which then goes to the computer-based system. With regard to the tape packing density, 1.8 times 10 to the tenth data bits are stored on a reel of one-inch tape. System components and their operation are surveyed, and studies on advanced storage techniques are summarized.

Heffner, P.

The application of high density tape recording to image processing

The Image Processing Facility at Goddard Space Flight Center has the requirement to move volumes of digital data (100 billion data bits per day) that exceed the capacity of conventional computer tape. This paper presents the requirements for a high-density digital tape recorder compatible with conventional computer systems. The steps leading to the formulation of these requirements are described. The use and interaction of the recorder with the various elements in the facility are treated. The formulation of the requirements resulted in the selection of a tape transport modified for digital serial-in, serial-out operation. This selection followed a competitive procurement action.

Heffner, P.

Electron beam recorder image correction for ERTS

Video data from the Earth Resources Technology Satellite (ERTS) are entered into the initial image generation system and placed on film using an electron beam to correct for both radiometric and geometric errors, a hardware unit called EBRIC was designed, fabricated, and incorporated in the image processing system. It operates under the control of a process control computer, as it varies video signal and the x and y deflection signals of the EBR.

Heffner, P.

Portable PFM Simulator

Portable transistorized circuit pulse frequency modulation /PFM/ simulator with power supply regulator

TRANSISTOR CIRCUIT

Monostable circuit with tunnel diode has fast recovery

A monostable multivibrator circuit using a tunnel diode makes it possible for the MSMV to exceed the performance of present multivibrators in two respects. The rise time of the output voltage is faster and the duty cycle is raised to approximately 95 percent.

Heffner, P.

PFM Simulator

Pulse frequency modulation simulator for design and testing of telemetry equipment for satellite systems

SATELLITE INSTRUMENTATION