Engineering Papers⌕ Search

Engineering topics

Hearn, C. P.

Publications and source records attributed to Hearn, C. P..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

The 24 GHz measurements of 2.2 lambda conical horn antennas illuminating a conducting sheet

Monostatic reflection-coefficient magnitude, absolute value of Gamma, measurements occurring between a radiating horn and a metal reflecting plate are presented for a family of three 2.2 lambda diameter conical horn antennas. The three horns have different aperture phase deviations: 6 deg, 22.5 deg, and 125 deg. Measurements of the magnitude of absolute value of Gamma as a function of horn-plate separation (d) extend from an effective antenna aperture short (d = O) to beyond the far-field boundary (d = 2D(sup 2)/lambda, where D is the antenna diameter). Measurement data are presented with various physical environments for each of the horns. Measured scalar data are compared with theoretical data from two models, a numerical model for a circular waveguide aperture in a ground plane and a scalar diffraction theory model. This work was conducted in support of the development effort for a spaceborne multifrequency microwave reflectometer designed to accurately determine the distance from a space vehicle's surface to a reflecting plasma boundary. The metal reflecting plate was used to simulate the RF reflectivity of a critically dense plasma. The resulting configuration, a ground plane mounted aperture facing a reflecting plane in close proximity, produces a strong interaction between the ground plane and the reflecting plate, especially at integral half-wavelength separations. The transition coefficient is characterized by large amplitude variations.

Cross, A. E.↗
NASA NTRS1991

Low-loss coupling to dielectric resonators

A compilation is presented of experimental observations and arguments concerning the use of dielectric resonators in applications requiring both tight coupling (beta greater than 10) and high unloaded Q, such as low loss bandpass filters. The microstrip coupled dielectric resonator is the primary focus, but an alternative coupling technique is discussed and comparatively evaluated. It is concluded that coupling factors as large as 65 are achievable.

Hearn, C. P.↗
NASA NTRS1990

The effect of coupling line loss in microstrip to dielectric resonator coupling

The interaction between a dielectric resonator and a microstrip transmission line is fundamentally a field phenomenon. However, the model of Figure 1b widely is used to represent the arrangement in Figure 1a, and predicts the behavior encountered in practice. The microstrip line of length l = n(lambda)/4 between the input and coupling planes and the lambda/4 open-circuit stub usually is assumed to be lossless. This paper considers the effect of coupling line loss on the unloaded-Q and coupling coefficient beta of the combination. It shows that transmission line loss can cause the decrease in unloaded-Q that has been observed to occur with tight coupling, and limits the coupling coefficient to a much lower value than would be obtained with a lossless coupling line.

Hearn, C. P.↗
NASA NTRS1990

An analysis of the effects of secondary reflections on dual-frequency reflectometers

The error-producing mechanism involving secondary reflections in a dual-frequency, distance measuring reflectometer is examined analytically. Equations defining the phase, and hence distance, error are derived. The error-reducing potential of frequency-sweeping is demonstrated. It is shown that a single spurious return can be completely nullified by optimizing the sweep width.

Hearn, C. P.↗
NASA NTRS1990

An assessment of the potential of continuous-wave ranging for measuring the distance to a highly reflective, infinite sheet

The feasibility of a continuous-wave, distance-measuring technique for measuring the distance from a spacecraft antenna to a highly ionized plasma surface is examined. The reflection coefficient angle is computed for several aperture models. It is concluded that aperture size and the presence of a nonablating dielectric cover over the antenna are critical factors.

Hearn, C. P.↗
NASA NTRS1986

Design and development of a multibeam 1.4 GHz pushbroom microwave radiometer

The design and operation of a multiple beam, digital signal processing radiometer are discussed. The discussion includes a brief description of each major subsystem and an overall explanation of the hardware requirements and operation. A series of flight tests was conducted in which sea-truth sites, as well as an existing radiometer were used to verify the Pushbroom Radiometer performance. The results of these tests indicate that the Pushbroom Radiometer did meet the sensitivity design goal of 1.0 kelvin, and exceeded the accuracy requirement of 2.0 kelvin. Additional performance characteristics and test results are also presented.

Lawrence, R. W.↗
NASA NTRS1985

Linearity optimization in a class of analog phase modulators

This paper examines the ultimate modulating linearity attainable with a phase modulation technique based on the linear addition of quadrature phase carrier signals which have been multiplied by precisely defined nonlinear transformations of the modulating signal. Optimum gain coefficients are derived and plotted to permit implementation of analog phase modulators capable of exceptionally good linearity of phase deviations as large as 5 radians.

Hearn, C. P.↗
NASA NTRS1985

Microstrip termination effects on dielectric resonator filters

Dielectric resonator filters coupled to microstrip lines appear to answer the requirements of high performance and small size and weight that must be satisfied for use in satellite-based radiometers. The open-circuit and short-circuit types of coupling dielectric resonators to microstrip lines were compared with respect to radiation losses at various frequencies. The filters were fabricated from 1.6 mm Duroid board. The termination impedances for the microstrip lines were measured using a calibrated HP 8510 network analyzer. The values for radiation resistance obtained experimentally for both types of coupling agreed well with the values calculated from the Lewin theory (1960). It was found that the use of short-circuit coupling results in significantly reduced radiation resistance compared to the use of open-circuit lines. Improvement increases with increased frequency.

Trew, R. J.↗
NASA NTRS1985

The role of amplitude-to-phase conversion in the generation of oscillator flicker phase noise

The role of amplitude-to-phase conversion as a factor in feedback oscillator flicker phase noise is examined. A limiting stage consisting of parallel-connected opposite polarity diodes operating in a circuit environment contining reactance is shown to exhibit amplitude-to-phase conversion. This mechanism coupled with resistive upconversion provides an indirect route for very low frequency flicker noise to be transferred into the phase of an oscillator signal. It is concluded that this effect is more significant in the lower frequency regimes where the onlinear reactances associated with active devices are overwhelmed by linear reactive elements.

Hearn, C. P.↗
NASA NTRS1984

Demodulator for AM and SSB-SC Signals

Compatible linear demodulator (CLD) detects either amplitude modulation (AM) or single-sideband suppressed-carrier (SSB-SC) modulation. Carrier recovery homodyne product detector designed for voice communication but easily scaled to other frequencies.

Hearn, C. P.↗
NASA NTRS1984

Theoretical and experimental studies of error in square-law detector circuits

Square law detector circuits to determine errors from the ideal input/output characteristic function were investigated. The nonlinear circuit response is analyzed by a power series expansion containing terms through the fourth degree, from which the significant deviation from square law can be predicted. Both fixed bias current and flexible bias current configurations are considered. The latter case corresponds with the situation where the mean current can change with the application of a signal. Experimental investigations of the circuit arrangements are described. Agreement between the analytical models and the experimental results are established. Factors which contribute to differences under certain conditions are outlined.

Stanley, W. D.↗
NASA NTRS1984

An investigation of the existence of a surface water layer on aircraft radomes during simulated flight in heavy precipitation

An experiment to investigate the electromagnetic attenuation effects of an impacting water spray on an aircraft weather radome was conducted in Langley's 4 X 7 m. wind tunnel equipped with a water spray system. Results indicate no significant liquid water film formed at the stagnation point of the radome under the test conditions. However, a water sheath was observed standing away from the radome surface, which could possibly have significant attenuation properties of its own. Due to the lack of fidelity in modeling both the natural environment with the tunnel apparatus and the water sheath, it is recommended that further studies be undertaken to better define the water distribution in the vicinity of the radome and measure its effect on weather radar performance.

Branstetter, J. R.↗
NASA NTRS1984

Effect of nonideal square-law detection on static calibration in noise-injection radiometers

The effect of nonideal square-law detection on the static calibration for a class of Dicke radiometers is examined. It is shown that fourth-order curvature in the detection characteristic adds a nonlinear term to the linear calibration relationship normally ascribed to noise-injection, balanced Dicke radiometers. The minimum error, based on an optimum straight-line fit to the calibration curve, is derived in terms of the power series coefficients describing the input-output characteristics of the detector. These coefficients can be determined by simple measurements, and detection nonlinearity is, therefore, quantitatively related to radiometric measurement error.

Hearn, C. P.↗
NASA NTRS1983

Microprogramed Sequencer for Tunable RF Oscillator

Standard IC chips and digitally tuned oscillator combined. Circuit consists of PROM-based microprogramed control sequencer, which drives group of diode switches to select one of eight tuning capacitors in L-C oscillator. Circuit originally designed to "dither" transmitter frequency of K-band radar at high rates finds application in other areas, as automated test equipment or computer-controlled receiver tuning.

Couch, R. H.↗
NASA NTRS1982

Microwave integrated circuit radiometer front-ends for the Push Broom Microwave Radiometer

Microwave integrated circuit front-ends for the L-band, S-band and C-band stepped frequency null-balanced noise-injection Dicke-switched radiometer to be installed in the NASA Langley airborne prototype Push Broom Microwave Radiometer (PBMR) are described. These front-ends were developed for the fixed frequency of 1.413 GHz and the variable frequencies of 1.8-2.8 GHz and 3.8-5.8 GHz. Measurements of the noise temperature of these units were made at 55.8 C, and the results of these tests are given. While the overall performance was reasonable, improvements need to be made in circuit losses and noise temperatures, which in the case of the C-band were from 1000 to 1850 K instead of the 500 K specified. Further development of the prototypes is underway to improve performance and extend the frequency range.

Harrington, R. F.↗
NASA NTRS1980

Temperature controller for hyperthermia devices

Temperature controller monitors and controls temperature in local region of tumor. Medical grade thermocouples are inserted in or near tumor, controller pulse modulates radio frequency diathermy power source to maintain temperature within 0.2 C. System may be extended to control diathermy of more than one tumor or patient.

Couch, R. H.↗
NASA NTRS1976

Phase modulating with odd and even finite power series of a modulating signal

Method and apparatus is presented for producing a phase-modulated waveform having a high degree of linearity between the modulating signal and the phase of the modulated carrier signal. Two signals representing finite odd and even power series transformations of the modulating signal are produced and multiplied with two quadrature components of the input carrier signal, respectively. One of the multiplied signals is subtracted from the other and the resulting signal is hard-limited to produce a phase-modulated output signal. The means for producing the two signals representing the odd and even power series of the modulating signal includes means for varying the coefficients of the two power series. By means of an existing computer program, the coefficients of the two power series are selected such that there is an extremely high degree of linearity between the modulating signal and the phase of the modulated carrier signal.

Hearn, C. P.↗