Engineering Papers⌕ Search

Engineering topics

Heaps, W.

Publications and source records attributed to Heaps, W..

The solar diameter and oblateness measured by the solar disk sextant on the 1992 September 30 balloon flight

This paper reports the results of a balloon flight of the Solar Disk Sextant (SDS) on 1992 September 30. This was the first flight in which the SDS used a wedge assembly fabricated by molecular contact in order to eliminate the wedge angle variations observed in previous flights. The instrument performed as designed. The main results obtained are values of the solar diameter for a number of discrete heliocentric latitudes, and the solar oblateness. The accuracy of the diameter values is better than 0.2 sec whereas the precision is approximately 1-2 mas. The equatorial solar diameter, at 1 AU, was 1919.06 sec +/- 0.12 sec, and the oblateness epsilon = 8.63 +/- 0.88 x 10(exp -6).

Sofia, S.↗

Rotationally resolved collisional transfer rates in OH

Fluorescence lidar measurements of the hydroxyl radical require detailed information concerning collision induced processes in order to deduce the radical number density from a lidar return. The Goddard SFC OH lidar currently utilizes a broadband detector which precludes the necessity of fully understanding collisional redistribution of rotational energy within the excited state. Numerous advantages result however from the inclusion of a detector with a bandpass only slightly larger that the Doppler width of a rotational line. This however places more stringent requirements on the spectroscopy. Measurements were accordingly made of rotationally resolved quenching rates for collisions with O2, N2, and H2O. Rotational transfer rates were also measured for the same colliders. Quenching rates were measured using a Nd-YAG pumped Rh6G dye laser doubled into the UV. The OH lifetimes were measured as a function of pressure of quenching gas at total pressures of between 50 and 250 microns. Rotational transfer rates were measured by recording the emission spectrum on an intensified diode array and integrating over 10.000 laser shots.

Mcgee, T. J.↗

Hydrogen species

Measurements of the members of the HO(x) family (OH, HO2, and H2O2) and their major source gases, H2O, and CH4 are discussed. Emphasis is placed on measurements which were made since the 1982 World Meteorologic Organization (WMO) report. Measurement techniques, available data, an assessment of data reliability, and a comparison of the data with theoretical distributions of stratospheric HO(x) species predicted from one and two dimensional photochemical models are discussed.

Schiff, H. I.↗

Boundary layer measurements of the OH radical in the vicinity of an isolated power plant plume - SO2 and NO2 chemical conversion times

Direct measurements of the OH radical in the vicinity of an isolated power plant plume are reported. These measurements were used to estimate the conversion time of SO2 to H2SO4-sulfate aerosol via the initiating step OH + SO2 + M yields HSO3. Using the near-high-noon measured value of OH (9.5 million per cu cm), resulted in a 1/e conversion time of 1.4 days. The latter lifetime would correspond to a conversion rate of about 2%/hr. When the lifetime calculation was modified to take into consideration the OH diurnal cycle, the 1/e conversion time for SO2 was found to be 4.4 days, giving an apparent overall rate of conversion of about 0.7%/hr. Similar calculations carried out for the conversion of NO2 to NHO3 resulted in 1/e lifetimes for NO2 of 2-3 h for midday time periods.

Davis, D. D.↗

A frequency doubled pressure-tunable oscillator-amplifier dye laser system

A tunable high-repetition-rate oscillator-amplifier dye-laser system is reported. The dye laser described was longitudinally pumped with the second harmonic of a Nd-YAG laser operating at 10 Hz. Using three Faraday-Perot etalons and pressure tuning, a maximum fundamental output power of the order of 6 MW with a corresponding spectral width of less than 0.003 nm at 564 nm was obtained. The fundamental at 564 nm was frequency doubled to give a maximum power level of 0.6 MW of second-harmonic output power with a spectral width less than 0.0015 nm at 282 nm. Frequency stability could be maintained to within approximately 15% of the line-width.

Moriarty, A.↗