Engineering topics
Publications and source records attributed to Heald, R H.
The effect of aileron displacement on wing characteristics has been investigated for the Clark Y and the U.S.A. 27 wing sections equipped with rectangular ailerons. The airfoils, rectangular in plan, and having a 10 inch chord and 60 inch span, were mounted on a model fuselage.
Ailerons described in references 1, 2, and 3, are summarized in the form of empirical equations which relate the aileron dimensions and displacements to the rolling, yawing, and hinge moments for pitch angles of 0 and 12 degrees, corresponding to angles of attack of the wings of 4 and 16 degrees, respectively.
This report presents the results of an extension to higher angles of attack of the investigation of the rolling and yawing moments due to ailerons of various chords and spans on two airfoils having the Clark Y and U. S. A. 27 wings. The measurements were made at various angles of pitch but at zero angle of roll and yaw, the wing chord being set at an angle of +4 degrees to the fuselage axis. In the case of the Clark Y airfoil the measurements have been extended to a pitch angle of 40 degrees, using ailerons of span equal to 67 per cent of the wing semispan and chord equal to 20 and 30 per cent of the wing chord. The work was conducted on wing models of 60-inch span and 10-inch chord.
This report presents the results of an investigation of the rolling and yawing moments due to ailerons of various chords and spans on two airfoils having the Clark Y and U. S. A. 27 wing sections. Some attention is devoted to a study of the effect of scale on rolling and yawing moments and to the effect of slightly rounding the wing tips. The results apply to level flight with the wing chord set at an angle of attack of +4 degrees and to conditions of zero pitch, zero yaw, and zero roll of the airplane. It is planned later to extend the investigation to other attitudes for monoplane and biplane combinations. The work was conducted in the 10 foot wind tunnel of the Bureau of Standards on models of 60-inch span and 10-inch chord. (author)
With the assistance and cooperation of the National Advisory Committee for Aeronautics the Bureau of Standards has been engaged for the past year in an investigation of turbulence in wind tunnels, especially in so far as turbulence affects the results of measurements in different wind tunnels. Two methods of making such studies are described in this report together with the results of the use in the 54-inch wind tunnel of the Bureau of Standards. The first method consists in measuring the drag of circular cylinders; the second in measuring the static pressure at some fixed point. Both methods show that the flow is not entirely free from irregularities.
Given here are the results of a test conducted in a wind tunnel on the performance of a vane-driven gear pump used to pump gasoline upward into a small tank located within the upper wing from which it flows by gravity to the engine carburetor. Information is given on the efficiency of the pump, the head resistance of the vanes, the performance and characteristics of the unit with and without housing about the vanes, the pump performance when motor driven, and resistance and power characteristics.